@@ -1604,8 +1604,8 @@ config VIDEO_DS90UB960
select V4L2_FWNODE
select VIDEO_V4L2_SUBDEV_API
help
- Device driver for the Texas Instruments DS90UB960
- FPD-Link III Deserializer and DS90UB9702 FPD-Link IV Deserializer.
+ Device driver for the Texas Instruments DS90UB954/DS90UB960
+ FPD-Link III Deserializers and DS90UB9702 FPD-Link IV Deserializer.
config VIDEO_MAX96714
tristate "Maxim MAX96714 GMSL2 deserializer"
@@ -403,6 +403,7 @@
#define UB960_NUM_EQ_LEVELS (UB960_MAX_EQ_LEVEL - UB960_MIN_EQ_LEVEL + 1)
enum chip_type {
+ UB954,
UB960,
UB9702,
};
@@ -815,6 +816,10 @@ static int ub960_txport_select(struct ub960_data *priv, u8 nport)
lockdep_assert_held(&priv->reg_lock);
+ /* TX port registers is shared for UB954 */
+ if (priv->hw_data->chip_type == UB954)
+ return 0;
+
if (priv->reg_current.txport == nport)
return 0;
@@ -1157,10 +1162,18 @@ static int ub960_parse_dt_txport(struct ub960_data *priv,
priv->tx_link_freq[0] = vep.link_frequencies[0];
priv->tx_data_rate = priv->tx_link_freq[0] * 2;
- if (priv->tx_data_rate != MHZ(1600) &&
- priv->tx_data_rate != MHZ(1200) &&
- priv->tx_data_rate != MHZ(800) &&
- priv->tx_data_rate != MHZ(400)) {
+ switch (priv->tx_data_rate) {
+ case MHZ(1600):
+ case MHZ(800):
+ case MHZ(400):
+ break;
+ case MHZ(1200):
+ /* UB954 does not support 1.2 Gbps */
+ if ((priv->hw_data->chip_type == UB960) ||
+ (priv->hw_data->chip_type == UB9702))
+ break;
+ fallthrough;
+ default:
dev_err(dev, "tx%u: invalid 'link-frequencies' value\n", nport);
ret = -EINVAL;
goto err_free_vep;
@@ -1311,6 +1324,10 @@ static void ub960_rxport_set_strobe_pos(struct ub960_data *priv,
{
u8 clk_delay, data_delay;
+ /* FIXME: After writing to this area the UB954 chip no longer responds */
+ if (priv->hw_data->chip_type == UB954)
+ return;
+
clk_delay = UB960_IR_RX_ANA_STROBE_SET_CLK_NO_EXTRA_DELAY;
data_delay = UB960_IR_RX_ANA_STROBE_SET_DATA_NO_EXTRA_DELAY;
@@ -3853,6 +3870,9 @@ static int ub960_enable_core_hw(struct ub960_data *priv)
}
switch (priv->hw_data->chip_type) {
+ case UB954:
+ model = "UB954";
+ break;
case UB960:
model = "UB960";
break;
@@ -3874,6 +3894,27 @@ static int ub960_enable_core_hw(struct ub960_data *priv)
if (ret)
goto err_pd_gpio;
+ if (priv->hw_data->chip_type == UB954) {
+ /* From DS90UB954-Q1 datasheet:
+ * "REFCLK_FREQ measurement is not synchronized. Value in this
+ * register should read twice and only considered valid if
+ * REFCLK_FREQ is unchanged between reads."
+ */
+ unsigned long timeout = jiffies + msecs_to_jiffies(100);
+
+ do {
+ u8 refclk_new;
+
+ ret = ub960_read(priv, UB960_XR_REFCLK_FREQ, &refclk_new);
+ if (ret)
+ goto err_pd_gpio;
+
+ if (refclk_new == refclk_freq)
+ break;
+ refclk_freq = refclk_new;
+ } while (time_before(jiffies, timeout));
+ }
+
dev_dbg(dev, "refclk valid %u freq %u MHz (clk fw freq %lu MHz)\n",
!!(dev_sts & BIT(4)), refclk_freq,
clk_get_rate(priv->refclk) / 1000000);
@@ -4045,6 +4086,13 @@ static void ub960_remove(struct i2c_client *client)
mutex_destroy(&priv->reg_lock);
}
+static const struct ub960_hw_data ds90ub954_hw = {
+ .chip_type = UB954,
+ .chip_family = FAMILY_FPD3,
+ .num_rxports = 2,
+ .num_txports = 1,
+};
+
static const struct ub960_hw_data ds90ub960_hw = {
.chip_type = UB960,
.chip_family = FAMILY_FPD3,
@@ -4060,6 +4108,7 @@ static const struct ub960_hw_data ds90ub9702_hw = {
};
static const struct i2c_device_id ub960_id[] = {
+ { "ds90ub954-q1", (kernel_ulong_t)&ds90ub954_hw },
{ "ds90ub960-q1", (kernel_ulong_t)&ds90ub960_hw },
{ "ds90ub9702-q1", (kernel_ulong_t)&ds90ub9702_hw },
{}
@@ -4067,6 +4116,7 @@ static const struct i2c_device_id ub960_id[] = {
MODULE_DEVICE_TABLE(i2c, ub960_id);
static const struct of_device_id ub960_dt_ids[] = {
+ { .compatible = "ti,ds90ub954-q1", .data = &ds90ub954_hw },
{ .compatible = "ti,ds90ub960-q1", .data = &ds90ub960_hw },
{ .compatible = "ti,ds90ub9702-q1", .data = &ds90ub9702_hw },
{}
Add support for TI DS90UB954 FPD-Link III Deserializer. --- v2: Avoid potentially infinite loop when checking chip frequency. Move chip specific checks to appropriate functions. Signed-off-by: Alexander Shiyan <eagle.alexander923@gmail.com> --- drivers/media/i2c/Kconfig | 4 +-- drivers/media/i2c/ds90ub960.c | 58 ++++++++++++++++++++++++++++++++--- 2 files changed, 56 insertions(+), 6 deletions(-)