@@ -136,7 +136,7 @@ static void sp887x_setup_agc (struct sp887x_state* state)
static int sp887x_initial_setup (struct dvb_frontend* fe, const struct firmware *fw)
{
struct sp887x_state* state = fe->demodulator_priv;
- u8 buf [BLOCKSIZE+2];
+ u8 buf [BLOCKSIZE + 2];
int i;
int fw_size = fw->size;
const unsigned char *mem = fw->data;
@@ -144,7 +144,7 @@ static int sp887x_initial_setup (struct dvb_frontend* fe, const struct firmware
dprintk("%s\n", __func__);
/* ignore the first 10 bytes, then we expect 0x4000 bytes of firmware */
- if (fw_size < FW_SIZE+10)
+ if (fw_size < FW_SIZE + 10)
return -ENODEV;
mem = fw->data + 10;
@@ -167,7 +167,7 @@ static int sp887x_initial_setup (struct dvb_frontend* fe, const struct firmware
int c = BLOCKSIZE;
int err;
- if (i+c > FW_SIZE)
+ if (c > FW_SIZE - i)
c = FW_SIZE - i;
/* bit 0x8000 in address is set to enable 13bit mode */
drivers/media/dvb-frontends/sp887x.c:179 sp887x_initial_setup() error: memcpy() '&buf[2]' too small (30 vs 16384) This is actually a false alarm, but reverting the check order makes not only for humans to review the code, but also cleans the warning. Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com> --- drivers/media/dvb-frontends/sp887x.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)