@@ -1576,6 +1576,8 @@ int gspca_dev_probe2(struct usb_interface *intf,
#endif
v4l2_ctrl_handler_free(gspca_dev->vdev.ctrl_handler);
v4l2_device_unregister(&gspca_dev->v4l2_dev);
+ if (sd_desc->probe_error)
+ sd_desc->probe_error(gspca_dev);
kfree(gspca_dev->usb_buf);
kfree(gspca_dev);
return ret;
@@ -105,6 +105,7 @@ struct sd_desc {
cam_cf_op config; /* called on probe */
cam_op init; /* called on probe and resume */
cam_op init_controls; /* called on probe */
+ cam_v_op probe_error; /* called if probe failed, do cleanup here */
cam_op start; /* called on stream on after URBs creation */
cam_pkt_op pkt_scan;
/* optional operations */
@@ -529,12 +529,21 @@ static int sd_int_pkt_scan(struct gspca_dev *gspca_dev,
static int stv06xx_config(struct gspca_dev *gspca_dev,
const struct usb_device_id *id);
+static void stv06xx_probe_error(struct gspca_dev *gspca_dev)
+{
+ struct sd *sd = (struct sd *) gspca_dev;
+
+ kfree(sd->sensor_priv);
+ sd->sensor_priv = NULL;
+}
+
/* sub-driver description */
static const struct sd_desc sd_desc = {
.name = MODULE_NAME,
.config = stv06xx_config,
.init = stv06xx_init,
.init_controls = stv06xx_init_controls,
+ .probe_error = stv06xx_probe_error,
.start = stv06xx_start,
.stopN = stv06xx_stopN,
.pkt_scan = stv06xx_pkt_scan,
For two of the supported sensors the stv06xx driver allocates memory which is stored in sd->sensor_priv. This memory is freed on a disconnect, but if the probe() fails, then it isn't freed and so this leaks memory. Add a new probe_error() op that drivers can use to free any allocated memory in case there was a probe failure. Thanks to Pavel Skripkin <paskripkin@gmail.com> for discovering the cause of the memory leak. Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl> Reported-and-tested-by: syzbot+e7f4c64a4248a0340c37@syzkaller.appspotmail.com ---