[net-next,v13,00/16] net: ethernet: mtk_eth_soc: various enhancements

Message

Daniel Golle March 9, 2023, 10:54 a.m. UTC

This series brings a variety of fixes and enhancements for mtk_eth_soc,
adds support for the MT7981 SoC and facilitates sharing the SGMII PCS
code between mtk_eth_soc and mt7530.
Also prepare support for MT7988 which has been done while net-next was
closed.

Note that this series depends on commit 697c3892d825
("regmap: apply reg_base and reg_downshift for single register ops") to
not break mt7530 pcs register access.

For SGMII and 1000Base-X mode to work well it also depends on commit
193250ace270 ("net: ethernet: mtk_eth_soc: fix RX data corruption issue")
which has already been merged via the net tree.

The whole series has been tested on MT7622+MT7531 (BPi-R64),
MT7623+MT7530 (BPi-R2), MT7981+GPY211 (GL.iNet GL-MT3000) and
MT7986+MT7531 (BPi-R3). On the BananaPi R3 a variete of SFP modules
have been tested, all of them (some SGMII with PHY, others 2500Base-X
or 1000Base-X without PHY) are working well now, however, some of them
need manually disabling of autonegotiation for the link to come up.

Changes since v12:
 * remove patches "fixing" ????Base-X modes. Turns out the cause are
   buggy SFP modules for which we will need to introduce quirks rather
   than trying to address this in the Ethernet driver.

Changes since v11:
 * remove patch "net: ethernet: mtk_eth_soc: fix RX data corruption issue"
   as it has already been merged via net tree
 * add commits fixing 1000Base-X and 2500Base-X modes after phylink_pcs
   conversion
 * completely remove mtk_sgmii.c as only about 20 lines were left in that
   file
 * Add commits from Lorenzo for MT7988 as requested by him

Changes since v10:
 * improve mediatek,mt7981-eth dt-bindings
 * use regmap_set_bits instead of regmap_update_bits where possible
 * completely remove mtk_sgmii.c
 * no need to keep struct mtk_sgmii either as it had only a single
   element

Changes since v9:
 * fix path in mediatek,sgmiisys dt-binding

Changes since v8:
 * move mediatek,sgmiisys dt-bindings to correct net/pcs folder
 * rebase on top of net-next/main so series applies cleanly again

Changes since v7:
 * move mediatek,sgmiisys.yaml to more appropriate folder
 * don't include <linux/phylink.h> twice in PCS driver, sort includes

Changes since v6:
 * label MAC MCR bit 12 in 08/12, MediaTek replied explaining its function

Changes since v5:
 * drop dev pointer also from struct mtk_sgmii, pass it as function
   parameter instead
 * address comments left for dt-bindings
 * minor improvements to commit messages

Changes since v4:
 * remove unused dev pointer in struct pcs_mtk_lynxi
 * squash link timer check into correct follow-up patch

Changes since v3:
 * remove unused #define's
 * use BMCR_* instead of #define'ing our own constants
 * return before changing registers in case of invalid link timer

Changes since v2:
 * improve dt-bindings, convert sgmisys bindings to dt-schema yaml
 * fix typo

Changes since v1:
 * apply reverse xmas tree everywhere
 * improve commit descriptions
 * add dt binding documentation
 * various small changes addressing all comments received for v1

Daniel Golle (11):
  net: ethernet: mtk_eth_soc: add support for MT7981 SoC
  dt-bindings: net: mediatek,net: add mt7981-eth binding
  dt-bindings: arm: mediatek: sgmiisys: Convert to DT schema
  dt-bindings: arm: mediatek: sgmiisys: add MT7981 SoC
  net: ethernet: mtk_eth_soc: set MDIO bus clock frequency
  net: ethernet: mtk_eth_soc: reset PCS state
  net: ethernet: mtk_eth_soc: only write values if needed
  net: ethernet: mtk_eth_soc: ppe: add support for flow accounting
  net: pcs: add driver for MediaTek SGMII PCS
  net: ethernet: mtk_eth_soc: switch to external PCS driver
  net: dsa: mt7530: use external PCS driver

Lorenzo Bianconi (5):
  net: ethernet: mtk_eth_soc: add MTK_NETSYS_V1 capability bit
  net: ethernet: mtk_eth_soc: move MAX_DEVS in mtk_soc_data
  net: ethernet: mtk_eth_soc: rely on num_devs and remove MTK_MAC_COUNT
  net: ethernet: mtk_eth_soc: add MTK_NETSYS_V3 capability bit
  net: ethernet: mtk_eth_soc: convert caps in mtk_soc_data struct to u64

 .../arm/mediatek/mediatek,sgmiisys.txt        |  27 --
 .../devicetree/bindings/net/mediatek,net.yaml |  53 ++-
 .../bindings/net/pcs/mediatek,sgmiisys.yaml   |  55 +++
 MAINTAINERS                                   |   8 +
 drivers/net/dsa/Kconfig                       |   1 +
 drivers/net/dsa/mt7530.c                      | 277 ++++-----------
 drivers/net/dsa/mt7530.h                      |  47 +--
 drivers/net/ethernet/mediatek/Kconfig         |   2 +
 drivers/net/ethernet/mediatek/Makefile        |   2 +-
 drivers/net/ethernet/mediatek/mtk_eth_path.c  |  36 +-
 drivers/net/ethernet/mediatek/mtk_eth_soc.c   | 314 ++++++++++++++----
 drivers/net/ethernet/mediatek/mtk_eth_soc.h   | 207 ++++++------
 drivers/net/ethernet/mediatek/mtk_ppe.c       | 114 ++++++-
 drivers/net/ethernet/mediatek/mtk_ppe.h       |  25 +-
 .../net/ethernet/mediatek/mtk_ppe_debugfs.c   |   9 +-
 .../net/ethernet/mediatek/mtk_ppe_offload.c   |   8 +
 drivers/net/ethernet/mediatek/mtk_ppe_regs.h  |  14 +
 drivers/net/ethernet/mediatek/mtk_sgmii.c     | 203 -----------
 drivers/net/pcs/Kconfig                       |   7 +
 drivers/net/pcs/Makefile                      |   1 +
 drivers/net/pcs/pcs-mtk-lynxi.c               | 305 +++++++++++++++++
 include/linux/pcs/pcs-mtk-lynxi.h             |  13 +
 22 files changed, 1050 insertions(+), 679 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/arm/mediatek/mediatek,sgmiisys.txt
 create mode 100644 Documentation/devicetree/bindings/net/pcs/mediatek,sgmiisys.yaml
 delete mode 100644 drivers/net/ethernet/mediatek/mtk_sgmii.c
 create mode 100644 drivers/net/pcs/pcs-mtk-lynxi.c
 create mode 100644 include/linux/pcs/pcs-mtk-lynxi.h


base-commit: 46ca833c060cff588a5fc2c25a1def8a1b6284e2

Comments

Jakub Kicinski March 13, 2023, 11:51 p.m. UTC | #1

On Thu, 9 Mar 2023 10:54:23 +0000 Daniel Golle wrote:
> This series brings a variety of fixes and enhancements for mtk_eth_soc,
> adds support for the MT7981 SoC and facilitates sharing the SGMII PCS
> code between mtk_eth_soc and mt7530.
> Also prepare support for MT7988 which has been done while net-next was
> closed.

The netdev review queue is too long for me to comprehend, since the
discussion is still ongoing on v12 (even tho seemingly tangential) 
I'll drop this, please repost once conclusion is reached.