new file mode 100644
@@ -0,0 +1,51 @@
+MediaTek Serial ATA controller
+
+Required properties:
+ - compatible : Must be "mediatek,<chip>-ahci", "mediatek,mtk-ahci".
+ When using "mediatek,mtk-ahci" compatible strings, you
+ need SoC specific ones in addition, one of:
+ - "mediatek,mt7622-ahci"
+ - reg : Physical base addresses and length of register sets.
+ - interrupts : Interrupt associated with the SATA device.
+ - interrupt-names : Associated name must be: "hostc".
+ - clocks : A list of phandle and clock specifier pairs, one for each
+ entry in clock-names.
+ - clock-names : Associated names must be: "ahb", "axi", "asic", "rbc", "pm".
+ - phys : A phandle and PHY specifier pair for the PHY port.
+ - phy-names : Associated name must be: "sata-phy".
+ - ports-implemented : See ./ahci-platform.txt for details.
+
+Optional properties:
+ - power-domains : A phandle and power domain specifier pair to the power
+ domain which is responsible for collapsing and restoring
+ power to the peripheral.
+ - resets : Must contain an entry for each entry in reset-names.
+ See ../reset/reset.txt for details.
+ - reset-names : Associated names must be: "axi", "sw", "reg".
+ - mediatek,phy-mode : A phandle to the system controller, used to enable
+ SATA function.
+
+Example:
+
+ sata: sata@1a200000 {
+ compatible = "mediatek,mt7622-ahci",
+ "mediatek,mtk-ahci";
+ reg = <0 0x1a200000 0 0x1100>;
+ interrupts = <GIC_SPI 233 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "hostc";
+ clocks = <&pciesys CLK_SATA_AHB_EN>,
+ <&pciesys CLK_SATA_AXI_EN>,
+ <&pciesys CLK_SATA_ASIC_EN>,
+ <&pciesys CLK_SATA_RBC_EN>,
+ <&pciesys CLK_SATA_PM_EN>;
+ clock-names = "ahb", "axi", "asic", "rbc", "pm";
+ phys = <&u3port1 PHY_TYPE_SATA>;
+ phy-names = "sata-phy";
+ ports-implemented = <0x1>;
+ power-domains = <&scpsys MT7622_POWER_DOMAIN_HIF0>;
+ resets = <&pciesys MT7622_SATA_AXI_BUS_RST>,
+ <&pciesys MT7622_SATA_PHY_SW_RST>,
+ <&pciesys MT7622_SATA_PHY_REG_RST>;
+ reset-names = "axi", "sw", "reg";
+ mediatek,phy-mode = <&pciesys>;
+ };