@@ -6,6 +6,7 @@
*/
/dts-v1/;
+#include <dt-bindings/gpio/gpio.h>
#include "mt2712e.dtsi"
/ {
@@ -41,6 +42,53 @@
regulator-max-microvolt = <1000000>;
};
+ extcon_usb: extcon_iddig {
+ compatible = "linux,extcon-usb-gpio";
+ id-gpio = <&pio 12 GPIO_ACTIVE_HIGH>;
+ };
+
+ extcon_usb1: extcon_iddig1 {
+ compatible = "linux,extcon-usb-gpio";
+ id-gpio = <&pio 14 GPIO_ACTIVE_HIGH>;
+ };
+
+ usb_p0_vbus: regulator@2 {
+ compatible = "regulator-fixed";
+ regulator-name = "p0_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&pio 13 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
+ usb_p1_vbus: regulator@3 {
+ compatible = "regulator-fixed";
+ regulator-name = "p1_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&pio 15 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
+ usb_p2_vbus: regulator@4 {
+ compatible = "regulator-fixed";
+ regulator-name = "p2_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&pio 16 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
+ usb_p3_vbus: regulator@5 {
+ compatible = "regulator-fixed";
+ regulator-name = "p3_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&pio 17 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ regulator-always-on;
+ };
+
};
&auxadc {
@@ -59,7 +107,57 @@
proc-supply = <&cpus_fixed_vproc1>;
};
+&pio {
+ usb0_id_pins_float: usb0_iddig {
+ pins_iddig {
+ pinmux = <MT2712_PIN_12_IDDIG_P0__FUNC_IDDIG_A>;
+ bias-pull-up;
+ };
+ };
+
+ usb1_id_pins_float: usb1_iddig {
+ pins_iddig {
+ pinmux = <MT2712_PIN_14_IDDIG_P1__FUNC_IDDIG_B>;
+ bias-pull-up;
+ };
+ };
+};
+
+&ssusb {
+ vbus-supply = <&usb_p0_vbus>;
+ extcon = <&extcon_usb>;
+ dr_mode = "otg";
+ wakeup-source;
+ mediatek,u3p-dis-msk = <0x1>;
+ //enable-manual-drd;
+ //maximum-speed = "full-speed";
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb0_id_pins_float>;
+ status = "okay";
+};
+
+&ssusb1 {
+ vbus-supply = <&usb_p1_vbus>;
+ extcon = <&extcon_usb1>;
+ dr_mode = "otg";
+ //mediatek,u3p-dis-msk = <0x1>;
+ enable-manual-drd;
+ wakeup-source;
+ //maximum-speed = "full-speed";
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb1_id_pins_float>;
+ status = "okay";
+};
+
&uart0 {
status = "okay";
};
+&usb_host0 {
+ vbus-supply = <&usb_p2_vbus>;
+ status = "okay";
+};
+
+&usb_host1 {
+ status = "okay";
+};
@@ -8,6 +8,7 @@
#include <dt-bindings/clock/mt2712-clk.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/interrupt-controller/arm-gic.h>
+#include <dt-bindings/phy/phy.h>
#include <dt-bindings/power/mt2712-power.h>
#include "mt2712-pinfunc.h"
@@ -405,6 +406,131 @@
status = "disabled";
};
+ ssusb: usb@11271000 {
+ compatible = "mediatek,mt2712-mtu3", "mediatek,mtu3";
+ reg = <0 0x11271000 0 0x3000>,
+ <0 0x11280700 0 0x0100>;
+ reg-names = "mac", "ippc";
+ interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_LOW>;
+ phys = <&u2port0 PHY_TYPE_USB2>,
+ <&u2port1 PHY_TYPE_USB2>;
+ power-domains = <&scpsys MT2712_POWER_DOMAIN_USB>;
+ clocks = <&topckgen CLK_TOP_USB30_SEL>;
+ clock-names = "sys_ck";
+ mediatek,syscon-wakeup = <&pericfg 0x510 2>;
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+ status = "disabled";
+
+ usb_host0: xhci@11270000 {
+ compatible = "mediatek,mt2712-xhci",
+ "mediatek,mtk-xhci";
+ reg = <0 0x11270000 0 0x1000>;
+ reg-names = "mac";
+ interrupts = <GIC_SPI 123 IRQ_TYPE_LEVEL_LOW>;
+ power-domains = <&scpsys MT2712_POWER_DOMAIN_USB>;
+ clocks = <&topckgen CLK_TOP_USB30_SEL>, <&clk26m>;
+ clock-names = "sys_ck", "ref_ck";
+ status = "disabled";
+ };
+ };
+
+ u3phy0: usb-phy@11290000 {
+ compatible = "mediatek,mt2712-u3phy";
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+ status = "okay";
+
+ u2port0: usb-phy@11290000 {
+ reg = <0 0x11290000 0 0x700>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+
+ u2port1: usb-phy@11298000 {
+ reg = <0 0x11298000 0 0x700>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+
+ u3port0: usb-phy@11298700 {
+ reg = <0 0x11298700 0 0x900>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+ };
+
+ ssusb1: usb@112c1000 {
+ compatible = "mediatek,mt2712-mtu3", "mediatek,mtu3";
+ reg = <0 0x112c1000 0 0x3000>,
+ <0 0x112d0700 0 0x0100>;
+ reg-names = "mac", "ippc";
+ interrupts = <GIC_SPI 248 IRQ_TYPE_LEVEL_LOW>;
+ phys = <&u2port2 PHY_TYPE_USB2>,
+ <&u2port3 PHY_TYPE_USB2>,
+ <&u3port1 PHY_TYPE_USB3>;
+ power-domains = <&scpsys MT2712_POWER_DOMAIN_USB2>;
+ clocks = <&topckgen CLK_TOP_USB30_SEL>;
+ clock-names = "sys_ck";
+ mediatek,syscon-wakeup = <&pericfg 0x514 2>;
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+ status = "disabled";
+
+ usb_host1: xhci@112c0000 {
+ compatible = "mediatek,mt2712-xhci",
+ "mediatek,mtk-xhci";
+ reg = <0 0x112c0000 0 0x1000>;
+ reg-names = "mac";
+ interrupts = <GIC_SPI 249 IRQ_TYPE_LEVEL_LOW>;
+ power-domains = <&scpsys MT2712_POWER_DOMAIN_USB2>;
+ clocks = <&topckgen CLK_TOP_USB30_SEL>, <&clk26m>;
+ clock-names = "sys_ck", "ref_ck";
+ status = "disabled";
+ };
+ };
+
+ u3phy1: usb-phy@112e0000 {
+ compatible = "mediatek,mt2712-u3phy";
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+ status = "okay";
+
+ u2port2: usb-phy@112e0000 {
+ reg = <0 0x112e0000 0 0x700>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+
+ u2port3: usb-phy@112e8000 {
+ reg = <0 0x112e8000 0 0x700>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+
+ u3port1: usb-phy@112e8700 {
+ reg = <0 0x112e8700 0 0x900>;
+ clocks = <&clk26m>;
+ clock-names = "ref";
+ #phy-cells = <1>;
+ status = "okay";
+ };
+ };
+
mfgcfg: syscon@13000000 {
compatible = "mediatek,mt2712-mfgcfg", "syscon";
reg = <0 0x13000000 0 0x1000>;