diff mbox series

net: ethernet: mtk-star-emac: simplify interrupt handling

Message ID 20200611140139.17702-1-brgl@bgdev.pl (mailing list archive)
State New, archived
Headers show
Series net: ethernet: mtk-star-emac: simplify interrupt handling | expand

Commit Message

Bartosz Golaszewski June 11, 2020, 2:01 p.m. UTC 
From: Bartosz Golaszewski <bgolaszewski@baylibre.com>

During development we tried to make the interrupt handling as fine-grained
as possible with TX and RX interrupts being disabled/enabled independently
and the counter registers reset from workqueue context.

Unfortunately after thorough testing of current mainline, we noticed the
driver has become unstable under heavy load. While this is hard to
reproduce, it's quite consistent in the driver's current form.

This patch proposes to go back to the previous approach of doing all
processing in napi context with all interrupts masked in order to make the
driver usable in mainline linux. This doesn't impact the performance on
pumpkin boards at all and it's in line with what many ethernet drivers do
in mainline linux anyway.

At the same time we're adding a FIXME comment about the need to improve
the interrupt handling.

Fixes: 8c7bd5a454ff ("net: ethernet: mtk-star-emac: new driver")
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
---
 drivers/net/ethernet/mediatek/mtk_star_emac.c | 118 +++++-------------
 1 file changed, 29 insertions(+), 89 deletions(-)

Comments

David Miller June 11, 2020, 7:51 p.m. UTC | #1 
From: Bartosz Golaszewski <brgl@bgdev.pl>
Date: Thu, 11 Jun 2020 16:01:39 +0200

> Unfortunately after thorough testing of current mainline, we noticed the
> driver has become unstable under heavy load. While this is hard to
> reproduce, it's quite consistent in the driver's current form.

Maybe you should work to pinpoint the actual problem before pushing forward
a solution?
Bartosz Golaszewski June 11, 2020, 9:04 p.m. UTC | #2 
czw., 11 cze 2020 o 21:51 David Miller <davem@davemloft.net> napisał(a):
>
> From: Bartosz Golaszewski <brgl@bgdev.pl>
> Date: Thu, 11 Jun 2020 16:01:39 +0200
>
> > Unfortunately after thorough testing of current mainline, we noticed the
> > driver has become unstable under heavy load. While this is hard to
> > reproduce, it's quite consistent in the driver's current form.
>
> Maybe you should work to pinpoint the actual problem before pushing forward
> a solution?

Why would you assume I didn't? I've been trying to figure out this
problem since Monday but since I'm not sure how much time I will be
able to spend on this going forward and due to the fact that this is
now upstream (and broken), I sent this patch. As I said: it doesn't
impact performance nor is this solution inherently wrong - many
drivers do it this way.

I will continue working on this driver on and off so I *do* intend on
fixing it as well as extending it with more support, hence the FIXME
and previous TODO.

Best regards,
Bartosz
David Miller June 15, 2020, 8:31 p.m. UTC | #3 
From: Bartosz Golaszewski <brgl@bgdev.pl>
Date: Thu, 11 Jun 2020 16:01:39 +0200

> From: Bartosz Golaszewski <bgolaszewski@baylibre.com>
> 
> During development we tried to make the interrupt handling as fine-grained
> as possible with TX and RX interrupts being disabled/enabled independently
> and the counter registers reset from workqueue context.
> 
> Unfortunately after thorough testing of current mainline, we noticed the
> driver has become unstable under heavy load. While this is hard to
> reproduce, it's quite consistent in the driver's current form.
> 
> This patch proposes to go back to the previous approach of doing all
> processing in napi context with all interrupts masked in order to make the
> driver usable in mainline linux. This doesn't impact the performance on
> pumpkin boards at all and it's in line with what many ethernet drivers do
> in mainline linux anyway.
> 
> At the same time we're adding a FIXME comment about the need to improve
> the interrupt handling.
> 
> Fixes: 8c7bd5a454ff ("net: ethernet: mtk-star-emac: new driver")
> Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>

Applied.
diff mbox series

Patch

diff --git a/drivers/net/ethernet/mediatek/mtk_star_emac.c b/drivers/net/ethernet/mediatek/mtk_star_emac.c
index f1ace4fec19f..3e765bdcf9e1 100644
--- a/drivers/net/ethernet/mediatek/mtk_star_emac.c
+++ b/drivers/net/ethernet/mediatek/mtk_star_emac.c
@@ -24,7 +24,6 @@ 
 #include <linux/regmap.h>
 #include <linux/skbuff.h>
 #include <linux/spinlock.h>
-#include <linux/workqueue.h>
 
 #define MTK_STAR_DRVNAME			"mtk_star_emac"
 
@@ -262,7 +261,6 @@  struct mtk_star_priv {
 	spinlock_t lock;
 
 	struct rtnl_link_stats64 stats;
-	struct work_struct stats_work;
 };
 
 static struct device *mtk_star_get_dev(struct mtk_star_priv *priv)
@@ -432,42 +430,6 @@  static void mtk_star_intr_disable(struct mtk_star_priv *priv)
 	regmap_write(priv->regs, MTK_STAR_REG_INT_MASK, ~0);
 }
 
-static void mtk_star_intr_enable_tx(struct mtk_star_priv *priv)
-{
-	regmap_clear_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			  MTK_STAR_BIT_INT_STS_TNTC);
-}
-
-static void mtk_star_intr_enable_rx(struct mtk_star_priv *priv)
-{
-	regmap_clear_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			  MTK_STAR_BIT_INT_STS_FNRC);
-}
-
-static void mtk_star_intr_enable_stats(struct mtk_star_priv *priv)
-{
-	regmap_clear_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			  MTK_STAR_REG_INT_STS_MIB_CNT_TH);
-}
-
-static void mtk_star_intr_disable_tx(struct mtk_star_priv *priv)
-{
-	regmap_set_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			MTK_STAR_BIT_INT_STS_TNTC);
-}
-
-static void mtk_star_intr_disable_rx(struct mtk_star_priv *priv)
-{
-	regmap_set_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			MTK_STAR_BIT_INT_STS_FNRC);
-}
-
-static void mtk_star_intr_disable_stats(struct mtk_star_priv *priv)
-{
-	regmap_set_bits(priv->regs, MTK_STAR_REG_INT_MASK,
-			MTK_STAR_REG_INT_STS_MIB_CNT_TH);
-}
-
 static unsigned int mtk_star_intr_read(struct mtk_star_priv *priv)
 {
 	unsigned int val;
@@ -663,20 +625,6 @@  static void mtk_star_update_stats(struct mtk_star_priv *priv)
 	stats->rx_errors += stats->rx_fifo_errors;
 }
 
-/* This runs in process context and parallel TX and RX paths executing in
- * napi context may result in losing some stats data but this should happen
- * seldom enough to be acceptable.
- */
-static void mtk_star_update_stats_work(struct work_struct *work)
-{
-	struct mtk_star_priv *priv = container_of(work, struct mtk_star_priv,
-						 stats_work);
-
-	mtk_star_update_stats(priv);
-	mtk_star_reset_counters(priv);
-	mtk_star_intr_enable_stats(priv);
-}
-
 static struct sk_buff *mtk_star_alloc_skb(struct net_device *ndev)
 {
 	uintptr_t tail, offset;
@@ -767,42 +715,25 @@  static void mtk_star_free_tx_skbs(struct mtk_star_priv *priv)
 	mtk_star_ring_free_skbs(priv, ring, mtk_star_dma_unmap_tx);
 }
 
-/* All processing for TX and RX happens in the napi poll callback. */
+/* All processing for TX and RX happens in the napi poll callback.
+ *
+ * FIXME: The interrupt handling should be more fine-grained with each
+ * interrupt enabled/disabled independently when needed. Unfortunatly this
+ * turned out to impact the driver's stability and until we have something
+ * working properly, we're disabling all interrupts during TX & RX processing
+ * or when resetting the counter registers.
+ */
 static irqreturn_t mtk_star_handle_irq(int irq, void *data)
 {
 	struct mtk_star_priv *priv;
 	struct net_device *ndev;
-	bool need_napi = false;
-	unsigned int status;
 
 	ndev = data;
 	priv = netdev_priv(ndev);
 
 	if (netif_running(ndev)) {
-		status = mtk_star_intr_read(priv);
-
-		if (status & MTK_STAR_BIT_INT_STS_TNTC) {
-			mtk_star_intr_disable_tx(priv);
-			need_napi = true;
-		}
-
-		if (status & MTK_STAR_BIT_INT_STS_FNRC) {
-			mtk_star_intr_disable_rx(priv);
-			need_napi = true;
-		}
-
-		if (need_napi)
-			napi_schedule(&priv->napi);
-
-		/* One of the counters reached 0x8000000 - update stats and
-		 * reset all counters.
-		 */
-		if (unlikely(status & MTK_STAR_REG_INT_STS_MIB_CNT_TH)) {
-			mtk_star_intr_disable_stats(priv);
-			schedule_work(&priv->stats_work);
-		}
-
-		mtk_star_intr_ack_all(priv);
+		mtk_star_intr_disable(priv);
+		napi_schedule(&priv->napi);
 	}
 
 	return IRQ_HANDLED;
@@ -1169,8 +1100,6 @@  static void mtk_star_tx_complete_all(struct mtk_star_priv *priv)
 	if (wake && netif_queue_stopped(ndev))
 		netif_wake_queue(ndev);
 
-	mtk_star_intr_enable_tx(priv);
-
 	spin_unlock(&priv->lock);
 }
 
@@ -1332,20 +1261,32 @@  static int mtk_star_process_rx(struct mtk_star_priv *priv, int budget)
 static int mtk_star_poll(struct napi_struct *napi, int budget)
 {
 	struct mtk_star_priv *priv;
+	unsigned int status;
 	int received = 0;
 
 	priv = container_of(napi, struct mtk_star_priv, napi);
 
-	/* Clean-up all TX descriptors. */
-	mtk_star_tx_complete_all(priv);
-	/* Receive up to $budget packets. */
-	received = mtk_star_process_rx(priv, budget);
+	status = mtk_star_intr_read(priv);
+	mtk_star_intr_ack_all(priv);
 
-	if (received < budget) {
-		napi_complete_done(napi, received);
-		mtk_star_intr_enable_rx(priv);
+	if (status & MTK_STAR_BIT_INT_STS_TNTC)
+		/* Clean-up all TX descriptors. */
+		mtk_star_tx_complete_all(priv);
+
+	if (status & MTK_STAR_BIT_INT_STS_FNRC)
+		/* Receive up to $budget packets. */
+		received = mtk_star_process_rx(priv, budget);
+
+	if (unlikely(status & MTK_STAR_REG_INT_STS_MIB_CNT_TH)) {
+		mtk_star_update_stats(priv);
+		mtk_star_reset_counters(priv);
 	}
 
+	if (received < budget)
+		napi_complete_done(napi, received);
+
+	mtk_star_intr_enable(priv);
+
 	return received;
 }
 
@@ -1532,7 +1473,6 @@  static int mtk_star_probe(struct platform_device *pdev)
 	ndev->max_mtu = MTK_STAR_MAX_FRAME_SIZE;
 
 	spin_lock_init(&priv->lock);
-	INIT_WORK(&priv->stats_work, mtk_star_update_stats_work);
 
 	base = devm_platform_ioremap_resource(pdev, 0);
 	if (IS_ERR(base))