[v4,00/13] mips: Prepare MIPS-arch code for Baikal-T1 SoC support

Message

Serge Semin May 21, 2020, 2:07 p.m. UTC

This is a first patchset of a series of about 25 ones, which are intended to
add the full Baikal-T1 SoC [1] support to the Linux kernel. Since they will
concern various kernel subsystems, I decided to split the whole work up into
the patchesets in accordance with the subsystems/devices their changes are
introduced for. Nearly 2/3 of the work is already done and will be sent out
very soon. While the rest of the changes specifically related to the fast-speed
interfaces (DW 12G PHY, PCIe, SATA, xGBE, GMAC, USB, DDRC, IC) are still in
refactoring and preparation for integration into the mainline kernel. Hopefully
I'll finish them up in the next two-three months, and submit them straight
away.

Getting back to this patchset. As the subject states this is intended to
prepare the MIPS-arch and generic kernel code for further Baikal-T1 SoC
platform support integration (note the Baikal-T1 SoC platform code will be
submitted last after the whole series of patchsets as a closure of the
submission process). First of all the patchset starts with a set of changes
to the dt-bindings kernel concerning MIPS CPC and CDMM nodes to make them
being represented by dt schemas. In addition we updated the vendors prefix
schema with Baikal Electronics JSC prefix so being further committed
vendor-specific device drivers would be correctly accepted by the
checkpatch script.

While I was working with the MIPS architecture code, I discovered, that there
is a bug in the Coherency Manager v2 error causes declaration and the errors
handler lacked of CM2 L2 ECC/parity errors support. So the fixes are here in
the patchset.

Baikal-T1 SoC is based on the MIPS P5600 Warrior IP-core, which itself has
MIPS32 Release 5 architecture. Even though on ISA level it doesn't differ much
from the MIPS32 Release 2 release, there are still some peculiarities, which
make it's justified to add the direct MIPS32r5 support into the kernel (see
the specific patch for details). In addition seeing there is more than one
real chip based on the MIPS P5600 core on the market, it would be good to have
the direct P5600 CPU config in the MIPS-arch.

There were some issues we discovered while were working with MIPS-arch code.
So the cleanups and fixes are introduced in this patchset. First of all the
Write-Merge CPU feature hasn't been handled in a generic way. Even if a
platform defined the writecombine flag as _CACHE_UNCACHED_ACCELERATED, the
feature might have been disabled in the CP0 register. We either enable it or
leave it as is in accordance with the knowledge of whether the corresponding
platform really supports it. Secondly Memory Accessibility Attribute Registers
(MAAR) haven't been properly initialized when Extended Physical Address (XPA)
mode was enabled. Thirdly since some of the platforms may have a very strict
limitations on the IO-memory access instructions. For instance Baikal-T1 SoC
IO-memory can be accessed by the lw/sw instructions only. In this case
for early-printk and CPS-debug code we suggest to use the instructions in
accordance with the UART-registers offset (lb/sb if offset = 0, lh/sh
if offset = 1 and so on). Fourthly in case if CPUFREQ feature is enabled
and frequency of the CPU is changed by the reference clock alteration, we
must make sure that MIPS r4k timer related services are properly updated
when CPU-frequency changes. It concerns udelay lpj adjustment, MIPS timer
clockevent frequency update. In addition when CPU reference frequency changes
it isn't recommended to use the timer as clocksource at all, since currently
the subsystem isn't tolerant to the unstable clock sources. So in this case
we suggest to use the r4k timer for clocksourcing only as a last resort.
Fifthly we discovered a bug in a method of CPUFREQ boost feature enable
procedure and fixed it in one of the patches within this patchset. And finally
there are a few fixups/cleanups we suggest to integrate into the MIPS FDC
and CDMM related code (see the patches for details).

This patchset is rebased and tested on the mips-next branch:
base-commit: bbb5946eb545 ("Linux 5.7-rc1" + mips-next)
tag: v5.7-rc1

[1] http://www.baikalelectronics.com/products/168/

Link: https://lore.kernel.org/linux-mips/[e-mail]/
Changelog v2:
- Replace "be" vendor prefix with "baikal" one.
- Remove patches adding the platform devices to the trivial-devices.yaml
  bindings file (Rob nacked it).
- Add yaml-based bindings file for MIPS CDMM dt-node.
- Convert mti,mips-cpc to DT schema.
- Use a shorter summary describing the bindings modification patches.
- Rearrange the SoBs with adding Alexey' co-development tag.
- Lowercase the hex numbers in the dt-bindings.
- Fix author and SoB emails mismatch in the patch of adding the Baikal
  Electronis JSC prefix to the dt schema of the prefixes.
- Remove patch "tty: mips_ejtag_fdc: Mark expected switch fall-through" from
  the patchset as being already applied to the Greg' tty-next branch.
- Our corporate email server doesn't change Message-Id anymore, so the patchset
  is resubmitted being in the cover-letter-threaded format.

Link: https://lore.kernel.org/linux-mips/[e-mail]/
Changelog v3:
- Discard commit 0ea2a268a7d3 ("mips: cm: Fix an invalid error code of INTVN_*_ERR")
  from the series since being integrated into the mips-next supported by Thomas.
- Discard commit d8163378fa4a ("mips: cm: Add L2 ECC/parity errors reporting")
  from the series since being integrated into the mips-next supported by Thomas.
- Discard commit 424de4cd3170 ("mips: MAAR: Add XPA mode support")
  from the series since being integrated into the mips-next supported by Thomas.
- Discard commit e128d941798d ("cpufreq: Return zero on success in boost sw setting")
  from the series as a fixup has been integrated into the kernel.
- Discard commit 08a3eb747882 ("dt-bindings: Add vendor prefix for Baikal
  Electronics, JSC") from the series since being integrated into the for-next
  supported by Rob.
- Discard commit 126510566cc7 ("mips: early_printk_8250: Use offset-sized IO-mem
  accessors") as being rejected by Thomas. Baikal-T1 SoC platform code will have to
  implement its own prom_putchar() method. It's probably for good. I'll use it to
  declare a common zboot and early printk method for a single UART.
- Use cpu_has_64bits to make sure the CPU has 64bits ISA instead of
  creating and using a new macro __isa_range_and_flag().
- Add r4k_ prefix to the cpufreq change notifier methods.
- In accordance with MIPS32/64 Privileged Resource Architecture Extend
  the MAAR Addr mask to value [12:55] instead of P5600-specific [12:35].
- In accordance with MIPS32/64 Privileged Resource Architecture Extend
  the MAAR Addr mask to value [12:55] instead of P5600-specific [12:35].
- Use cpu_has_64bits to make sure the CPU has 64bits ISA instead of
  creating and using a new macro __isa_range_and_flag().
- Mark r4k clocksource as unstable instead of lowering its rating.
- Along with MIPS32 Release 5 add MIPS64 Release 5 CPU support.
- Add CONFIG_CPS_NS16550_WIDTH config to select the UART registers accessors.

Changelog v4:
- Discard commit 37353ec964e8 ("mips: MAAR: Use more precise address mask")
  from the series as a fixup has been integrated into the kernel.
- Rebase onto the mips-next branch.

Co-developed-by: Alexey Malahov <[e-mail]>
Signed-off-by: Alexey Malahov <[e-mail]>
Signed-off-by: Serge Semin <[e-mail]>
Cc: Maxim Kaurkin <[e-mail]>
Cc: Pavel Parkhomenko <[e-mail]>
Cc: Ramil Zaripov <[e-mail]>
Cc: Ekaterina Skachko <[e-mail]>
Cc: Vadim Vlasov <[e-mail]>
Cc: Alexey Kolotnikov <[e-mail]>
Cc: Paul Burton <[e-mail]>
Cc: Ralf Baechle <[e-mail]>
Cc: Rob Herring <[e-mail]>
Cc: Frank Rowand <[e-mail]>
Cc: Tony Lindgren <[e-mail]>
Cc: Arnd Bergmann <[e-mail]>
Cc: Olof Johansson <[e-mail]>
Cc: Greg Kroah-Hartman <[e-mail]>
Cc: Jiri Slaby <[e-mail]>
Cc: [e-mail]
Cc: [e-mail]
Cc: [e-mail]

Serge Semin (13):
  dt-bindings: power: Convert mti,mips-cpc to DT schema
  dt-bindings: bus: Add MIPS CDMM controller
  mips: Add MIPS Release 5 support
  mips: Add MIPS Warrior P5600 support
  mips: Fix cpu_has_mips64r1/2 activation for MIPS32 CPUs
  mips: Add CP0 Write Merge config support
  mips: Add CONFIG/CONFIG6/Cause reg fields macro
  mips: Add CPS_NS16550_WIDTH config
  mips: cdmm: Add mti,mips-cdmm dtb node support
  bus: cdmm: Add MIPS R5 arch support
  mips: Add udelay lpj numbers adjustment
  mips: csrc-r4k: Mark R4K timer as unstable if CPU freq changes
  mips: cevt-r4k: Update the r4k-clockevent frequency in sync with CPU

 .../bindings/bus/mti,mips-cdmm.yaml           | 35 ++++++++
 .../bindings/power/mti,mips-cpc.txt           |  8 --
 .../bindings/power/mti,mips-cpc.yaml          | 35 ++++++++
 arch/mips/Kconfig                             | 84 +++++++++++++++++--
 arch/mips/Kconfig.debug                       | 10 +++
 arch/mips/Makefile                            |  3 +
 arch/mips/include/asm/asmmacro.h              | 18 ++--
 arch/mips/include/asm/compiler.h              |  5 ++
 arch/mips/include/asm/cpu-features.h          | 41 +++++++--
 arch/mips/include/asm/cpu-info.h              |  2 +-
 arch/mips/include/asm/cpu-type.h              |  7 +-
 arch/mips/include/asm/cpu.h                   | 14 ++--
 arch/mips/include/asm/fpu.h                   |  4 +-
 arch/mips/include/asm/hazards.h               |  8 +-
 arch/mips/include/asm/mipsregs.h              | 22 +++++
 arch/mips/include/asm/module.h                |  6 ++
 arch/mips/include/asm/stackframe.h            |  2 +-
 arch/mips/include/asm/switch_to.h             |  8 +-
 arch/mips/kernel/cevt-r4k.c                   | 44 ++++++++++
 arch/mips/kernel/cps-vec-ns16550.S            | 18 +++-
 arch/mips/kernel/cpu-probe.c                  | 65 ++++++++++++++
 arch/mips/kernel/csrc-r4k.c                   | 40 +++++++++
 arch/mips/kernel/entry.S                      |  6 +-
 arch/mips/kernel/proc.c                       |  4 +
 arch/mips/kernel/r4k_fpu.S                    | 14 ++--
 arch/mips/kernel/spram.c                      |  4 +-
 arch/mips/kernel/time.c                       | 70 ++++++++++++++++
 arch/mips/kvm/vz.c                            |  6 +-
 arch/mips/lib/csum_partial.S                  |  6 +-
 arch/mips/mm/c-r4k.c                          |  7 +-
 arch/mips/mm/sc-mips.c                        |  7 +-
 drivers/bus/Kconfig                           |  2 +-
 drivers/bus/mips_cdmm.c                       | 15 ++++
 33 files changed, 547 insertions(+), 73 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/bus/mti,mips-cdmm.yaml
 delete mode 100644 Documentation/devicetree/bindings/power/mti,mips-cpc.txt
 create mode 100644 Documentation/devicetree/bindings/power/mti,mips-cpc.yaml