@@ -32,6 +32,7 @@
#include <linux/ssb/ssb_driver_chipcommon.h>
#include <linux/ssb/ssb_regs.h>
#include <linux/smp.h>
+#include <asm/bmips.h>
#include <asm/bootinfo.h>
#include <bcm47xx.h>
#include <bcm47xx_board.h>
@@ -110,6 +111,8 @@ static __init void prom_init_mem(void)
void __init prom_init(void)
{
+ /* Cache CBR addr before CPU/DMA setup */
+ bmips_cbr_addr = BMIPS_GET_CBR();
prom_init_mem();
setup_8250_early_printk_port(CKSEG1ADDR(BCM47XX_SERIAL_ADDR), 0, 0);
}
@@ -37,6 +37,7 @@
#include <linux/ssb/ssb.h>
#include <linux/ssb/ssb_embedded.h>
#include <linux/bcma/bcma_soc.h>
+#include <asm/bmips.h>
#include <asm/bootinfo.h>
#include <asm/idle.h>
#include <asm/prom.h>
@@ -45,6 +46,9 @@
#include <bcm47xx.h>
#include <bcm47xx_board.h>
+/* CBR addr doesn't change and we can cache it */
+void __iomem *bmips_cbr_addr __read_mostly;
+
union bcm47xx_bus bcm47xx_bus;
EXPORT_SYMBOL(bcm47xx_bus);
@@ -22,6 +22,9 @@ void __init prom_init(void)
{
u32 reg, mask;
+ /* Cache CBR addr before CPU/DMA setup */
+ bmips_cbr_addr = BMIPS_GET_CBR();
+
bcm63xx_cpu_init();
/* stop any running watchdog */
@@ -12,6 +12,7 @@
#include <linux/memblock.h>
#include <linux/ioport.h>
#include <linux/pm.h>
+#include <asm/bmips.h>
#include <asm/bootinfo.h>
#include <asm/time.h>
#include <asm/reboot.h>
@@ -22,6 +23,9 @@
#include <bcm63xx_io.h>
#include <bcm63xx_gpio.h>
+/* CBR addr doesn't change and we can cache it */
+void __iomem *bmips_cbr_addr __read_mostly;
+
void bcm63xx_machine_halt(void)
{
pr_info("System halted\n");
@@ -9,7 +9,7 @@ bool bmips_rac_flush_disable;
void arch_sync_dma_for_cpu_all(void)
{
- void __iomem *cbr = BMIPS_GET_CBR();
+ void __iomem *cbr = bmips_cbr_addr;
u32 cfg;
if (boot_cpu_type() != CPU_BMIPS3300 &&
@@ -34,6 +34,9 @@
#define REG_BCM6328_OTP ((void __iomem *)CKSEG1ADDR(0x1000062c))
#define BCM6328_TP1_DISABLED BIT(9)
+/* CBR addr doesn't change and we can cache it */
+void __iomem *bmips_cbr_addr __read_mostly;
+
extern bool bmips_rac_flush_disable;
static const unsigned long kbase = VMLINUX_LOAD_ADDRESS & 0xfff00000;
@@ -111,7 +114,7 @@ static void bcm6358_quirks(void)
* because the bootloader is not initializing it properly.
*/
bmips_rac_flush_disable = !!(read_c0_brcm_cmt_local() & (1 << 31)) ||
- !!BMIPS_GET_CBR();
+ !!bmips_cbr_addr;
}
static void bcm6368_quirks(void)
@@ -144,6 +147,8 @@ static void __init bmips_init_cfe(void)
void __init prom_init(void)
{
+ /* Cache CBR addr before CPU/DMA setup */
+ bmips_cbr_addr = BMIPS_GET_CBR();
bmips_init_cfe();
bmips_cpu_setup();
register_bmips_smp_ops();
@@ -81,6 +81,7 @@ extern char bmips_smp_movevec[];
extern char bmips_smp_int_vec[];
extern char bmips_smp_int_vec_end[];
+extern void __iomem *bmips_cbr_addr;
extern int bmips_smp_enabled;
extern int bmips_cpu_offset;
extern cpumask_t bmips_booted_mask;
@@ -518,7 +518,7 @@ static void bmips_set_reset_vec(int cpu, u32 val)
info.val = val;
bmips_set_reset_vec_remote(&info);
} else {
- void __iomem *cbr = BMIPS_GET_CBR();
+ void __iomem *cbr = bmips_cbr_addr;
if (cpu == 0)
__raw_writel(val, cbr + BMIPS_RELO_VECTOR_CONTROL_0);
@@ -591,7 +591,7 @@ asmlinkage void __weak plat_wired_tlb_setup(void)
void bmips_cpu_setup(void)
{
- void __iomem __maybe_unused *cbr = BMIPS_GET_CBR();
+ void __iomem __maybe_unused *cbr = bmips_cbr_addr;
u32 __maybe_unused cfg;
switch (current_cpu_type()) {