@@ -2760,6 +2760,13 @@ static int mlxsw_sp_port_ets_init(struct mlxsw_sp_port *mlxsw_sp_port)
false, 0);
if (err)
return err;
+
+ err = mlxsw_sp_port_ets_set(mlxsw_sp_port,
+ MLXSW_REG_QEEC_HIERARCY_TC,
+ i + 8, i,
+ false, 0);
+ if (err)
+ return err;
}
/* Make sure the max shaper is disabled in all hierarchies that
@@ -2797,6 +2804,15 @@ static int mlxsw_sp_port_ets_init(struct mlxsw_sp_port *mlxsw_sp_port)
return 0;
}
+static int mlxsw_sp_port_tc_mc_mode_set(struct mlxsw_sp_port *mlxsw_sp_port)
+{
+ struct mlxsw_sp *mlxsw_sp = mlxsw_sp_port->mlxsw_sp;
+ char qtctm_pl[MLXSW_REG_QTCTM_LEN];
+
+ mlxsw_reg_qtctm_pack(qtctm_pl, mlxsw_sp_port->local_port, true);
+ return mlxsw_reg_write(mlxsw_sp->core, MLXSW_REG(qtctm), qtctm_pl);
+}
+
static int mlxsw_sp_port_create(struct mlxsw_sp *mlxsw_sp, u8 local_port,
bool split, u8 module, u8 width, u8 lane)
{
@@ -2925,6 +2941,13 @@ static int mlxsw_sp_port_create(struct mlxsw_sp *mlxsw_sp, u8 local_port,
goto err_port_ets_init;
}
+ err = mlxsw_sp_port_tc_mc_mode_set(mlxsw_sp_port);
+ if (err) {
+ dev_err(mlxsw_sp->bus_info->dev, "Port %d: Failed to initialize TC MC mode\n",
+ mlxsw_sp_port->local_port);
+ goto err_port_tc_mc_mode;
+ }
+
/* ETS and buffers must be initialized before DCB. */
err = mlxsw_sp_port_dcb_init(mlxsw_sp_port);
if (err) {
@@ -2981,6 +3004,7 @@ static int mlxsw_sp_port_create(struct mlxsw_sp *mlxsw_sp, u8 local_port,
err_port_fids_init:
mlxsw_sp_port_dcb_fini(mlxsw_sp_port);
err_port_dcb_init:
+err_port_tc_mc_mode:
err_port_ets_init:
err_port_buffers_init:
err_port_admin_status_set:
In order to give unicast traffic precedence over BUM traffic, configure multicast-aware mode on all ports. Under multicast-aware regime, when assigning traffic class to a packet, the switch doesn't merely take the value prescribed by the QTCT register. For BUM traffic, it instead assigns that value plus 8. ETS elements for TCs 8..15 thus need to be configured as well. Extend mlxsw_sp_port_ets_init() so that it maps each of them to the same subgroup as their corresponding TC from the range 0..7, such that TCs X and X+8 map to the same subgroup. The existing code configures TCs with strict priority. So far this was immaterial, because each TC had its own subgroup. Now that two TCs share a subgroup it becomes important. TCs are prioritized in order of 7, 6, ..., 0, 15, 14, ..., 8: the higher TCs used for BUM traffic end up being deprioritized. Since that's what's needed, keep that configuration as it is, and configure the new TCs likewise. Finally in mlxsw_sp_port_create(), invoke configuration of QTCTM to enable MC-aware mode on each port. Signed-off-by: Petr Machata <petrm@mellanox.com> --- drivers/net/ethernet/mellanox/mlxsw/spectrum.c | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+)