@@ -40,11 +40,26 @@ check_test_requirements()
load_driver()
{
- modprobe $DRIVER > /dev/null 2>&1
+ if [ $# -eq 0 ]; then
+ modprobe $DRIVER > /dev/null 2>&1
+ else
+ if [ $# -eq 2 ]; then
+ modprobe $DRIVER spm_addr_dev0=$1 spm_addr_dev1=$2
+ > /dev/null 2>&1
+ else
+ echo "Missing module parameters. Make sure pass"\
+ "spm_addr_dev0 and spm_addr_dev1"
+ usage
+ fi
+ fi
if [ $? == 0 ]; then
major=$(awk "\$2==\"HMM_DMIRROR\" {print \$1}" /proc/devices)
mknod /dev/hmm_dmirror0 c $major 0
mknod /dev/hmm_dmirror1 c $major 1
+ if [ $# -eq 2 ]; then
+ mknod /dev/hmm_dmirror2 c $major 2
+ mknod /dev/hmm_dmirror3 c $major 3
+ fi
fi
}
@@ -58,7 +73,7 @@ run_smoke()
{
echo "Running smoke test. Note, this test provides basic coverage."
- load_driver
+ load_driver $1 $2
$(dirname "${BASH_SOURCE[0]}")/hmm-tests
unload_driver
}
@@ -75,6 +90,9 @@ usage()
echo "# Smoke testing"
echo "./${TEST_NAME}.sh smoke"
echo
+ echo "# Smoke testing with SPM enabled"
+ echo "./${TEST_NAME}.sh smoke <spm_addr_dev0> <spm_addr_dev1>"
+ echo
exit 0
}
@@ -84,7 +102,7 @@ function run_test()
usage
else
if [ "$1" = "smoke" ]; then
- run_smoke
+ run_smoke $2 $3
else
usage
fi
Add two more parameters to set spm_addr_dev0 & spm_addr_dev1 addresses. These two parameters configure the start SP addresses for each device in test_hmm driver. Consequently, this configures zone device type as coherent. Signed-off-by: Alex Sierra <alex.sierra@amd.com> --- v2: Add more mknods for device coherent type. These are represented under /dev/hmm_mirror2 and /dev/hmm_mirror3, only in case they have created at probing the hmm-test driver. --- tools/testing/selftests/vm/test_hmm.sh | 24 +++++++++++++++++++++--- 1 file changed, 21 insertions(+), 3 deletions(-)