[v4,0/2] add NPCM SDHCI driver support

Message

Tomer Maimon Oct. 2, 2023, 7:41 p.m. UTC

This patch set adds SDHCI support for the Nuvoton NPCM Baseboard 
Management Controller (BMC).

Deeply sorry it took that long until sending version three, promise to try
to do better on the next versions (if needed) :-),

The NPCM SDHCI driver tested on NPCM750 and NPCM845 EVB.

Addressed comments from:
 - Andy Shevchenko : https://www.spinics.net/lists/devicetree/msg637946.html

Changes since version 3:
 - Use devm_clk_get_optional_enabled function.
 - Add mod_devicetable.h.
 - Modify copyright year.

Changes since version 2:
 - Add data to handle architecture-specific SDHCI parameters.
 - Change config place in make and kconfig files.
 - Calling sdhci_pltfm_free to to avoid a memory leak on error.

Changes since version 1:
 - Use correct spaces in the dt-bindings.
 - Drop unused labels from dt-bindings.
 - Order by module name in the make a configuration.
 - Remove unnecessary blank lines.
 - Using devm_clk_get_optional instead of devm_clk_get.

Tomer Maimon (2):
  dt-bindings: mmc: npcm,sdhci: Document NPCM SDHCI controller
  mmc: sdhci-npcm: Add NPCM SDHCI driver

 .../devicetree/bindings/mmc/npcm,sdhci.yaml   | 45 +++++++++
 drivers/mmc/host/Kconfig                      |  8 ++
 drivers/mmc/host/Makefile                     |  1 +
 drivers/mmc/host/sdhci-npcm.c                 | 96 +++++++++++++++++++
 4 files changed, 150 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mmc/npcm,sdhci.yaml
 create mode 100644 drivers/mmc/host/sdhci-npcm.c