@@ -25,6 +25,10 @@ Optional properties:
- max-frequency: maximum operating clock frequency
- no-1-8-v: when present, denotes that 1.8v card voltage is not supported on
this system, even if the controller claims it is.
+- cap-sd-highspeed: SD high-speed timing is supported
+- cap-mmc-highspeed: MMC high-speed timing is supported
+- cap-power-off-card: powering off the card is safe
+- cap-sdio-irq: enable SDIO IRQ signalling on this interface
*NOTE* on CD and WP polarity. As of 3.8, SD/MMC drivers parse their DT nodes
each in its own way, including calculation of CD and WP polarities. Our goal is
@@ -380,6 +380,19 @@ void mmc_of_parse(struct mmc_host *host)
}
if (explicit_inv_wp ^ gpio_inv_wp)
host->caps2 |= MMC_CAP2_RO_ACTIVE_HIGH;
+
+ if (of_find_property(np, "cap-sd-highspeed", &len))
+ host->caps |= MMC_CAP_SD_HIGHSPEED;
+ if (of_find_property(np, "cap-mmc-highspeed", &len))
+ host->caps |= MMC_CAP_MMC_HIGHSPEED;
+ if (of_find_property(np, "cap-power-off-card", &len))
+ host->caps |= MMC_CAP_POWER_OFF_CARD;
+ if (of_find_property(np, "cap-sdio-irq", &len))
+ host->caps |= MMC_CAP_SDIO_IRQ;
+ if (of_find_property(np, "keep-power-in-suspend", &len))
+ host->pm_caps |= MMC_PM_KEEP_POWER;
+ if (of_find_property(np, "enable-sdio-wakeup", &len))
+ host->pm_caps |= MMC_PM_WAKE_SDIO_IRQ;
}
EXPORT_SYMBOL(mmc_of_parse);
Many MMC capability flags are platform-dependent and are traditionally set in platform data. With DT often each such capability requires a special binding. Add bindings for MMC_CAP_SD_HIGHSPEED, MMC_CAP_MMC_HIGHSPEED, MMC_CAP_POWER_OFF_CARD and MMC_CAP_SDIO_IRQ capabilities. Also add code to DT parser to look up "keep-power-in-suspend" and "enable-sdio-wakeup" bindings and set MMC_PM_KEEP_POWER and MMC_PM_WAKE_SDIO_IRQ respectively, if found. Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de> Cc: Arnd Bergmann <arnd@arndb.de> --- v3: add cap-sdio-irq Documentation/devicetree/bindings/mmc/mmc.txt | 4 ++++ drivers/mmc/core/host.c | 13 +++++++++++++ 2 files changed, 17 insertions(+), 0 deletions(-)