@@ -90,6 +90,8 @@
#define TMIO_SDIO_STAT_EXWT 0x8000
#define TMIO_SDIO_MASK_ALL 0xc007
+#define TMIO_SDIO_SETBITS_MASK 0x0006
+
/* Define some IRQ masks */
/* This is the mask used at reset by the chip */
#define TMIO_MASK_ALL 0x837f031d
@@ -180,12 +180,21 @@ static void tmio_mmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
struct tmio_mmc_host *host = mmc_priv(mmc);
if (enable && !host->sdio_irq_enabled) {
+ u16 sdio_status;
+
/* Keep device active while SDIO irq is enabled */
pm_runtime_get_sync(mmc_dev(mmc));
- host->sdio_irq_enabled = true;
+ host->sdio_irq_enabled = true;
host->sdio_irq_mask = TMIO_SDIO_MASK_ALL &
~TMIO_SDIO_STAT_IOIRQ;
+
+ /* Clear obsolete interrupts before enabling */
+ sdio_status = sd_ctrl_read16(host, CTL_SDIO_STATUS) & ~TMIO_SDIO_MASK_ALL;
+ if (host->pdata->flags & TMIO_MMC_SDIO_STATUS_SETBITS)
+ sdio_status |= TMIO_SDIO_SETBITS_MASK;
+ sd_ctrl_write16(host, CTL_SDIO_STATUS, sdio_status);
+
sd_ctrl_write16(host, CTL_SDIO_IRQ_MASK, host->sdio_irq_mask);
} else if (!enable && host->sdio_irq_enabled) {
host->sdio_irq_mask = TMIO_SDIO_MASK_ALL;
@@ -771,7 +780,7 @@ static void __tmio_mmc_sdio_irq(struct tmio_mmc_host *host)
sdio_status = status & ~TMIO_SDIO_MASK_ALL;
if (pdata->flags & TMIO_MMC_SDIO_STATUS_SETBITS)
- sdio_status |= 6;
+ sdio_status |= TMIO_SDIO_SETBITS_MASK;
sd_ctrl_write16(host, CTL_SDIO_STATUS, sdio_status);
Before enabling SDIO irqs, clear the status bit, so we discard old and stale interrupts. Needed to get two wireless cards working. Use the newly introduced macro in all places. Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com> --- Change since RFC: use #define for SETBITS_MASK drivers/mmc/host/tmio_mmc.h | 2 ++ drivers/mmc/host/tmio_mmc_pio.c | 13 +++++++++++-- 2 files changed, 13 insertions(+), 2 deletions(-)