@@ -17,6 +17,7 @@
#include <linux/iopoll.h>
#include <linux/kernel.h>
#include <linux/module.h>
+#include <linux/pm_runtime.h>
#include <linux/skbuff.h>
#include <linux/mmc/host.h>
@@ -33,6 +34,10 @@
#define FIRMWARE_MT7663 "mediatek/mt7663pr2h.bin"
#define FIRMWARE_MT7668 "mediatek/mt7668pr2h.bin"
+#define MTKBTSDIO_AUTOSUSPEND_DELAY 8000
+
+static bool enable_autosuspend;
+
struct btmtksdio_data {
const char *fwname;
};
@@ -150,6 +155,7 @@ struct btmtk_hci_wmt_params {
struct btmtksdio_dev {
struct hci_dev *hdev;
struct sdio_func *func;
+ struct device *dev;
struct work_struct tx_work;
unsigned long tx_state;
@@ -301,6 +307,8 @@ static void btmtksdio_tx_work(struct work_struct *work)
struct sk_buff *skb;
int err;
+ pm_runtime_get_sync(bdev->dev);
+
sdio_claim_host(bdev->func);
while ((skb = skb_dequeue(&bdev->txq))) {
@@ -313,6 +321,9 @@ static void btmtksdio_tx_work(struct work_struct *work)
}
sdio_release_host(bdev->func);
+
+ pm_runtime_mark_last_busy(bdev->dev);
+ pm_runtime_put_autosuspend(bdev->dev);
}
static int btmtksdio_recv_event(struct hci_dev *hdev, struct sk_buff *skb)
@@ -471,6 +482,18 @@ static void btmtksdio_interrupt(struct sdio_func *func)
u32 int_status;
u16 rx_size;
+ /* It is required that the host gets ownership from the device before
+ * accessing any register, however, if SDIO host is not being released,
+ * a potential deadlock probably happens in a circular wait between SDIO
+ * IRQ work and PM runtime work. So, we have to explicitly release SDIO
+ * host here and claim again after the PM runtime work is all done.
+ */
+ sdio_release_host(bdev->func);
+
+ pm_runtime_get_sync(bdev->dev);
+
+ sdio_claim_host(bdev->func);
+
/* Disable interrupt */
sdio_writel(func, C_INT_EN_CLR, MTK_REG_CHLPCR, 0);
@@ -507,6 +530,9 @@ static void btmtksdio_interrupt(struct sdio_func *func)
/* Enable interrupt */
sdio_writel(func, C_INT_EN_SET, MTK_REG_CHLPCR, 0);
+
+ pm_runtime_mark_last_busy(bdev->dev);
+ pm_runtime_put_autosuspend(bdev->dev);
}
static int btmtksdio_open(struct hci_dev *hdev)
@@ -815,6 +841,23 @@ static int btmtksdio_setup(struct hci_dev *hdev)
delta = ktime_sub(rettime, calltime);
duration = (unsigned long long)ktime_to_ns(delta) >> 10;
+ pm_runtime_set_autosuspend_delay(bdev->dev,
+ MTKBTSDIO_AUTOSUSPEND_DELAY);
+ pm_runtime_use_autosuspend(bdev->dev);
+
+ err = pm_runtime_set_active(bdev->dev);
+ if (err < 0)
+ return err;
+
+ /* Default forbid runtime auto suspend, that can be allowed by
+ * enable_autosuspend flag or the PM runtime entry under sysfs.
+ */
+ pm_runtime_forbid(bdev->dev);
+ pm_runtime_enable(bdev->dev);
+
+ if (enable_autosuspend)
+ pm_runtime_allow(bdev->dev);
+
bt_dev_info(hdev, "Device setup in %llu usecs", duration);
return 0;
@@ -822,10 +865,16 @@ static int btmtksdio_setup(struct hci_dev *hdev)
static int btmtksdio_shutdown(struct hci_dev *hdev)
{
+ struct btmtksdio_dev *bdev = hci_get_drvdata(hdev);
struct btmtk_hci_wmt_params wmt_params;
u8 param = 0x0;
int err;
+ /* Get back the state to be consistent with the state
+ * in btmtksdio_setup.
+ */
+ pm_runtime_get_sync(bdev->dev);
+
/* Disable the device */
wmt_params.op = MTK_WMT_FUNC_CTRL;
wmt_params.flag = 0;
@@ -839,6 +888,9 @@ static int btmtksdio_shutdown(struct hci_dev *hdev)
return err;
}
+ pm_runtime_put_noidle(bdev->dev);
+ pm_runtime_disable(bdev->dev);
+
return 0;
}
@@ -885,6 +937,7 @@ static int btmtksdio_probe(struct sdio_func *func,
if (!bdev->data)
return -ENODEV;
+ bdev->dev = &func->dev;
bdev->func = func;
INIT_WORK(&bdev->tx_work, btmtksdio_tx_work);
@@ -922,6 +975,25 @@ static int btmtksdio_probe(struct sdio_func *func,
sdio_set_drvdata(func, bdev);
+ /* pm_runtime_enable would be done after the firmware is being
+ * downloaded because the core layer probably already enables
+ * runtime PM for this func such as the case host->caps &
+ * MMC_CAP_POWER_OFF_CARD.
+ */
+ if (pm_runtime_enabled(bdev->dev))
+ pm_runtime_disable(bdev->dev);
+
+ /* As explaination in drivers/mmc/core/sdio_bus.c tells us:
+ * Unbound SDIO functions are always suspended.
+ * During probe, the function is set active and the usage count
+ * is incremented. If the driver supports runtime PM,
+ * it should call pm_runtime_put_noidle() in its probe routine and
+ * pm_runtime_get_noresume() in its remove routine.
+ *
+ * So, put a pm_runtime_put_noidle here !
+ */
+ pm_runtime_put_noidle(bdev->dev);
+
return 0;
}
@@ -933,6 +1005,9 @@ static void btmtksdio_remove(struct sdio_func *func)
if (!bdev)
return;
+ /* Be consistent the state in btmtksdio_probe */
+ pm_runtime_get_noresume(bdev->dev);
+
hdev = bdev->hdev;
sdio_set_drvdata(func, NULL);
@@ -940,15 +1015,84 @@ static void btmtksdio_remove(struct sdio_func *func)
hci_free_dev(hdev);
}
+#ifdef CONFIG_PM
+static int btmtksdio_runtime_suspend(struct device *dev)
+{
+ struct sdio_func *func = dev_to_sdio_func(dev);
+ struct btmtksdio_dev *bdev;
+ u32 status;
+ int err;
+
+ bdev = sdio_get_drvdata(func);
+ if (!bdev)
+ return 0;
+
+ sdio_claim_host(bdev->func);
+
+ sdio_writel(bdev->func, C_FW_OWN_REQ_SET, MTK_REG_CHLPCR, &err);
+ if (err < 0)
+ goto out;
+
+ err = readx_poll_timeout(btmtksdio_drv_own_query, bdev, status,
+ !(status & C_COM_DRV_OWN), 2000, 1000000);
+out:
+ bt_dev_info(bdev->hdev, "status (%d) return ownership to device", err);
+
+ sdio_release_host(bdev->func);
+
+ return err;
+}
+
+static int btmtksdio_runtime_resume(struct device *dev)
+{
+ struct sdio_func *func = dev_to_sdio_func(dev);
+ struct btmtksdio_dev *bdev;
+ u32 status;
+ int err;
+
+ bdev = sdio_get_drvdata(func);
+ if (!bdev)
+ return 0;
+
+ sdio_claim_host(bdev->func);
+
+ sdio_writel(bdev->func, C_FW_OWN_REQ_CLR, MTK_REG_CHLPCR, &err);
+ if (err < 0)
+ goto out;
+
+ err = readx_poll_timeout(btmtksdio_drv_own_query, bdev, status,
+ status & C_COM_DRV_OWN, 2000, 1000000);
+out:
+ bt_dev_info(bdev->hdev, "status (%d) get ownership from device", err);
+
+ sdio_release_host(bdev->func);
+
+ return err;
+}
+
+static UNIVERSAL_DEV_PM_OPS(btmtksdio_pm_ops, btmtksdio_runtime_suspend,
+ btmtksdio_runtime_resume, NULL);
+#define BTMTKSDIO_PM_OPS (&btmtksdio_pm_ops)
+#else /* CONFIG_PM */
+#define BTMTKSDIO_PM_OPS NULL
+#endif /* CONFIG_PM */
+
static struct sdio_driver btmtksdio_driver = {
.name = "btmtksdio",
.probe = btmtksdio_probe,
.remove = btmtksdio_remove,
.id_table = btmtksdio_table,
+ .drv = {
+ .owner = THIS_MODULE,
+ .pm = BTMTKSDIO_PM_OPS,
+ }
};
module_sdio_driver(btmtksdio_driver);
+module_param(enable_autosuspend, bool, 0644);
+MODULE_PARM_DESC(enable_autosuspend, "Enable autosuspend by default");
+
MODULE_AUTHOR("Sean Wang <sean.wang@mediatek.com>");
MODULE_DESCRIPTION("MediaTek Bluetooth SDIO driver ver " VERSION);
MODULE_VERSION(VERSION);