@@ -5,6 +5,9 @@
* Tony Lindgren <tony@atomide.com>
* Jouni Hogander
*
+ * Copyright (C) 2007 Texas Instruments, Inc.
+ * Rajendra Nayak <rnayak@ti.com>
+ *
* Copyright (C) 2005 Texas Instruments, Inc.
* Richard Woodruff <r-woodruff2@ti.com>
*
@@ -29,6 +32,8 @@
#include <plat/control.h>
#include <plat/serial.h>
#include <plat/sdrc.h>
+#include <plat/prcm.h>
+#include <plat/gpmc.h>
#include <asm/tlbflush.h>
@@ -39,6 +44,11 @@
#include "prm.h"
#include "pm.h"
+/* Scratchpad offsets */
+#define OMAP343X_TABLE_ADDRESS_OFFSET 0x31
+#define OMAP343X_TABLE_VALUE_OFFSET 0x30
+#define OMAP343X_CONTROL_REG_VALUE_OFFSET 0x32
+
struct power_state {
struct powerdomain *pwrdm;
u32 next_state;
@@ -57,6 +67,46 @@ static struct powerdomain *core_pwrdm, *per_pwrdm;
static int set_pwrdm_state(struct powerdomain *pwrdm, u32 state);
+static inline void omap3_per_save_context(void)
+{
+ omap_gpio_save_context();
+}
+
+static inline void omap3_per_restore_context(void)
+{
+ omap_gpio_restore_context();
+}
+
+static void omap3_core_save_context(void)
+{
+ u32 control_padconf_off;
+
+ /* Save the padconf registers */
+ control_padconf_off = omap_ctrl_readl(OMAP343X_CONTROL_PADCONF_OFF);
+ control_padconf_off |= START_PADCONF_SAVE;
+ omap_ctrl_writel(control_padconf_off, OMAP343X_CONTROL_PADCONF_OFF);
+ /* wait for the save to complete */
+ while (!omap_ctrl_readl(OMAP343X_CONTROL_GENERAL_PURPOSE_STATUS)
+ & PADCONF_SAVE_DONE)
+ ;
+ /* Save the Interrupt controller context */
+ omap_intc_save_context();
+ /* Save the GPMC context */
+ omap3_gpmc_save_context();
+ /* Save the system control module context, padconf already save above*/
+ omap3_control_save_context();
+}
+
+static void omap3_core_restore_context(void)
+{
+ /* Restore the control module context, padconf restored by h/w */
+ omap3_control_restore_context();
+ /* Restore the GPMC context */
+ omap3_gpmc_restore_context();
+ /* Restore the interrupt controller context */
+ omap_intc_restore_context();
+}
+
/*
* PRCM Interrupt Handler Helper Function
*
@@ -208,6 +258,7 @@ static void omap_sram_idle(void)
int mpu_next_state = PWRDM_POWER_ON;
int per_next_state = PWRDM_POWER_ON;
int core_next_state = PWRDM_POWER_ON;
+ int core_prev_state, per_prev_state;
if (!_omap_sram_idle)
return;
@@ -246,8 +297,15 @@ static void omap_sram_idle(void)
omap_uart_prepare_idle(1);
/* PER changes only with core */
per_next_state = pwrdm_read_next_pwrst(per_pwrdm);
- if (per_next_state < PWRDM_POWER_ON)
+ if (per_next_state < PWRDM_POWER_ON) {
omap_uart_prepare_idle(2);
+ if (per_next_state == PWRDM_POWER_OFF)
+ omap3_per_save_context();
+ }
+ if (core_next_state == PWRDM_POWER_OFF) {
+ omap3_core_save_context();
+ omap3_prcm_save_context();
+ }
/* Enable IO-PAD wakeup */
prm_set_mod_reg_bits(OMAP3430_EN_IO, WKUP_MOD, PM_WKEN);
}
@@ -272,6 +330,18 @@ static void omap_sram_idle(void)
/* Disable IO-PAD wakeup */
prm_clear_mod_reg_bits(OMAP3430_EN_IO, WKUP_MOD, PM_WKEN);
+ core_prev_state = pwrdm_read_prev_pwrst(core_pwrdm);
+ if (core_prev_state == PWRDM_POWER_OFF) {
+ omap3_core_restore_context();
+ omap3_prcm_restore_context();
+ omap3_sram_restore_context();
+ }
+ if (per_next_state < PWRDM_POWER_ON) {
+ per_prev_state =
+ pwrdm_read_prev_pwrst(per_pwrdm);
+ if (per_prev_state == PWRDM_POWER_OFF)
+ omap3_per_restore_context();
+ }
omap2_gpio_resume_after_retention();
}
@@ -843,6 +913,7 @@ static int __init omap3_pm_init(void)
/* XXX prcm_setup_regs needs to be before enabling hw
* supervised mode for powerdomains */
prcm_setup_regs();
+ omap3_save_scratchpad_contents();
ret = request_irq(INT_34XX_PRCM_MPU_IRQ,
(irq_handler_t)prcm_interrupt_handler,
@@ -27,6 +27,7 @@ extern u32 omap3_configure_core_dpll(
u32 sdrc_actim_ctrl_b_0, u32 sdrc_mr_0,
u32 sdrc_rfr_ctrl_1, u32 sdrc_actim_ctrl_a_1,
u32 sdrc_actim_ctrl_b_1, u32 sdrc_mr_1);
+extern void omap3_sram_restore_context(void);
/* Do not use these */
extern void omap1_sram_reprogram_clock(u32 ckctl, u32 dpllctl);