@@ -17,7 +17,6 @@ menuconfig TIDSPBRIDGE
config TIDSPBRIDGE_DVFS
bool "Enable Bridge Dynamic Voltage and Frequency Scaling (DVFS)"
depends on TIDSPBRIDGE && OMAP_PM_SRF && CPU_FREQ
- default n
help
DVFS allows DSP Bridge to initiate the operating point change to
scale the chip voltage and frequency in order to match the
@@ -33,14 +32,15 @@ config TIDSPBRIDGE_MEMPOOL_SIZE
failure under heavy memory fragmentation after some use time.
config TIDSPBRIDGE_DEBUG
- bool "DSP Bridge Debug Support"
+ bool "Debug Support"
depends on TIDSPBRIDGE
help
Say Y to enable Bridge debugging capabilities
config TIDSPBRIDGE_RECOVERY
- bool "DSP Recovery Support"
+ bool "Recovery Support"
depends on TIDSPBRIDGE
+ default y
help
In case of DSP fatal error, BRIDGE driver will try to
recover itself.
@@ -48,7 +48,6 @@ config TIDSPBRIDGE_RECOVERY
config TIDSPBRIDGE_CACHE_LINE_CHECK
bool "Check buffers to be 128 byte aligned"
depends on TIDSPBRIDGE
- default n
help
When the DSP processes data, the DSP cache controller loads 128-Byte
chunks (lines) from SDRAM and writes the data back in 128-Byte chunks.
@@ -60,27 +59,23 @@ config TIDSPBRIDGE_CACHE_LINE_CHECK
byte alignment, buffers failing this check will be rejected.
config TIDSPBRIDGE_WDT3
- bool "Enable WDT3 interruptions"
+ bool "Enable watchdog timer"
depends on TIDSPBRIDGE
- default n
help
WTD3 is managed by DSP and once it is enabled, DSP side bridge is in
charge of refreshing the timer before overflow, if the DSP hangs MPU
will caught the interrupt and try to recover DSP.
config TIDSPBRIDGE_WDT_TIMEOUT
- int "DSP watchdog timer timeout (in secs)"
- depends on TIDSPBRIDGE_WDT3
+ int "Watchdog timer timeout (in secs)"
+ depends on TIDSPBRIDGE && TIDSPBRIDGE_WDT3
default 5
help
Watchdog timer timeout value, after that time if the watchdog timer
counter is not reset the wdt overflow interrupt will be triggered
-comment "Bridge Notifications"
- depends on TIDSPBRIDGE
-
config TIDSPBRIDGE_NTFY_PWRERR
- bool "Notify DSP Power Error"
+ bool "Notify power errors"
depends on TIDSPBRIDGE
help
Enable notifications to registered clients on the event of power errror