@@ -42,6 +42,7 @@
#define ETH_KS8851_IRQ 34
#define ETH_KS8851_POWER_ON 48
#define ETH_KS8851_QUART 138
+#define OMAP4SDP_MDM_PWR_EN_GPIO 157
#define OMAP4_SFH7741_SENSOR_OUTPUT_GPIO 184
#define OMAP4_SFH7741_ENABLE_GPIO 188
@@ -225,6 +226,16 @@ static void __init omap_4430sdp_init_irq(void)
omap_gpio_init();
}
+static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst = {
+ .port_mode[0] = EHCI_HCD_OMAP_MODE_PHY,
+ .port_mode[1] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+ .port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN,
+ .phy_reset = false,
+ .reset_gpio_port[0] = -EINVAL,
+ .reset_gpio_port[1] = -EINVAL,
+ .reset_gpio_port[2] = -EINVAL,
+};
+
static struct omap_musb_board_data musb_board_data = {
.interface_type = MUSB_INTERFACE_UTMI,
.mode = MUSB_PERIPHERAL,
@@ -514,6 +525,15 @@ static void __init omap_4430sdp_init(void)
platform_add_devices(sdp4430_devices, ARRAY_SIZE(sdp4430_devices));
omap_serial_init();
omap4_twl6030_hsmmc_init(mmc);
+
+ /* Power on the ULPI PHY */
+ if (gpio_is_valid(OMAP4SDP_MDM_PWR_EN_GPIO)) {
+ /* FIXME: Assumes pad is already muxed for GPIO mode */
+ gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY VMDM_3V3");
+ gpio_direction_output(OMAP4SDP_MDM_PWR_EN_GPIO, 1);
+ }
+ usb_ehci_init(&ehci_pdata);
+
/* OMAP4 SDP uses internal transceiver so register nop transceiver */
usb_nop_xceiv_register();
/* FIXME: allow multi-omap to boot until musb is updated for omap4 */