@@ -111,6 +111,8 @@ obj-y += $(i2c-omap-m) $(i2c-omap-y)
ifneq ($(CONFIG_TIDSPBRIDGE),)
obj-y += dsp.o
endif
+omap-ssi-$(CONFIG_OMAP_SSI) := ssi.o
+obj-y += $(omap-ssi-m) $(omap-ssi-y)
# Specific board support
obj-$(CONFIG_MACH_OMAP_GENERIC) += board-generic.o
@@ -14,4 +14,6 @@ config HSI_BOARDINFO
bool
default y
+source "drivers/hsi/controllers/Kconfig"
+
endif # HSI
@@ -3,3 +3,4 @@
#
obj-$(CONFIG_HSI_BOARDINFO) += hsi_boardinfo.o
obj-$(CONFIG_HSI) += hsi.o
+obj-y += controllers/
new file mode 100644
@@ -0,0 +1,23 @@
+#
+# HSI controllers configuration
+#
+comment "HSI controllers"
+
+config OMAP_SSI
+ tristate "OMAP SSI hardware driver"
+ depends on ARCH_OMAP && HSI
+ default n
+ ---help---
+ SSI is a legacy version of HSI. It is usually used to connect
+ an application engine with a cellular modem.
+ If you say Y here, you will enable the OMAP SSI hardware driver.
+
+ If unsure, say N.
+
+if OMAP_SSI
+
+config OMAP_SSI_CONFIG
+ boolean
+ default y
+
+endif # OMAP_SSI
new file mode 100644
@@ -0,0 +1,5 @@
+#
+# Makefile for HSI controllers drivers
+#
+
+obj-$(CONFIG_OMAP_SSI) += omap_ssi.o