@@ -6,6 +6,7 @@
*
* Copyright (C) 2007-2011 Texas Instruments
* Author: Vikram Pandita <vikram.pandita@ti.com>
+ * Author: Keshava Munegowda <keshava_mgowda@ti.com>
*
* Generalization by:
* Felipe Balbi <balbi@ti.com>
@@ -19,7 +20,7 @@
#include <linux/errno.h>
#include <linux/delay.h>
#include <linux/platform_device.h>
-#include <linux/clk.h>
+#include <linux/slab.h>
#include <linux/dma-mapping.h>
#include <asm/io.h>
@@ -30,7 +31,7 @@
#include "mux.h"
-#if defined(CONFIG_USB_EHCI_HCD) || defined(CONFIG_USB_EHCI_HCD_MODULE)
+#ifdef CONFIG_MFD_OMAP_USB_HOST
static struct resource ehci_resources[] = {
{
@@ -361,17 +362,6 @@ void __init usb_ehci_init(const struct usbhs_omap_board_data *pdata)
}
}
-#else
-
-void __init usb_ehci_init(const struct usbhs_omap_board_data *pdata)
-
-{
-}
-
-#endif /* CONFIG_USB_EHCI_HCD */
-
-#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE)
-
static struct resource ohci_resources[] = {
{
.name = "ohci",
@@ -508,6 +498,77 @@ static void setup_ohci_io_mux(const enum usbhs_omap_port_mode *port_mode)
}
}
+static void setup_4430ohci_io_mux(const enum usbhs_omap_port_mode *port_mode)
+{
+ switch (port_mode[0]) {
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM:
+ omap_mux_init_signal("usbb1_mm_rxdp",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("usbb1_mm_rxdm",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+ case OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM:
+ omap_mux_init_signal("usbb1_mm_rxrcv",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+ case OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0:
+ omap_mux_init_signal("usbb1_mm_txen",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM:
+ omap_mux_init_signal("usbb1_mm_txdat",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("usbb1_mm_txse0",
+ OMAP_PIN_INPUT_PULLDOWN);
+ break;
+
+ case OMAP_USBHS_PORT_MODE_UNUSED:
+ default:
+ break;
+ }
+
+ switch (port_mode[1]) {
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM:
+ omap_mux_init_signal("usbb2_mm_rxdp",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("usbb2_mm_rxdm",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+ case OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM:
+ omap_mux_init_signal("usbb2_mm_rxrcv",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+ case OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0:
+ omap_mux_init_signal("usbb2_mm_txen",
+ OMAP_PIN_INPUT_PULLDOWN);
+
+
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM:
+ omap_mux_init_signal("usbb2_mm_txdat",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("usbb2_mm_txse0",
+ OMAP_PIN_INPUT_PULLDOWN);
+ break;
+
+ case OMAP_USBHS_PORT_MODE_UNUSED:
+ default:
+ break;
+ }
+}
+
void __init usb_ohci_init(const struct usbhs_omap_board_data *pdata)
{
platform_device_add_data(&ohci_device, pdata, sizeof(*pdata));
@@ -522,10 +583,115 @@ void __init usb_ohci_init(const struct usbhs_omap_board_data *pdata)
}
}
+
+#define OMAP_USBHS_DEVICE "usbhs-omap"
+
+static struct resource usbhs_resources[] = {
+ {
+ .name = "uhh",
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .name = "tll",
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .name = "ehci",
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .name = "ehci-irq",
+ .flags = IORESOURCE_IRQ,
+ },
+ {
+ .name = "ohci",
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .name = "ohci-irq",
+ .flags = IORESOURCE_IRQ,
+ }
+};
+
+static struct usbhs_omap_platform_data usbhs_data;
+static struct ehci_hcd_omap_platform_data ehci_data;
+static struct ohci_hcd_omap_platform_data ohci_data;
+
+void __init usbhs_init(const struct usbhs_omap_board_data *pdata)
+{
+ struct platform_device *pdev;
+ int i;
+
+ pdev = platform_device_alloc(OMAP_USBHS_DEVICE, 0);
+ if (!pdev) {
+ printk(KERN_ERR "EHCI platform_device_alloc failed\n");
+ return;
+ }
+
+ for (i = 0; i < OMAP3_HS_USB_PORTS; i++) {
+ usbhs_data.port_mode[i] = pdata->port_mode[i];
+ ohci_data.port_mode[i] = pdata->port_mode[i];
+ ehci_data.port_mode[i] = pdata->port_mode[i];
+ ehci_data.reset_gpio_port[i] = pdata->reset_gpio_port[i];
+ ehci_data.regulator[i] = pdata->regulator[i];
+ }
+ ehci_data.phy_reset = pdata->phy_reset;
+ ohci_data.es2_compatibility = pdata->es2_compatibility;
+ usbhs_data.ehci_data = &ehci_data;
+ usbhs_data.ohci_data = &ohci_data;
+
+ if (cpu_is_omap34xx()) {
+ usbhs_resources[0].start = OMAP34XX_UHH_CONFIG_BASE;
+ usbhs_resources[0].end = OMAP34XX_UHH_CONFIG_BASE + SZ_1K - 1;
+ usbhs_resources[1].start = OMAP34XX_USBTLL_BASE;
+ usbhs_resources[1].end = OMAP34XX_USBTLL_BASE + SZ_4K - 1;
+ usbhs_resources[2].start = OMAP34XX_EHCI_BASE;
+ usbhs_resources[2].end = OMAP34XX_EHCI_BASE + SZ_1K - 1;
+ usbhs_resources[3].start = INT_34XX_EHCI_IRQ;
+ usbhs_resources[4].start = OMAP34XX_OHCI_BASE;
+ usbhs_resources[4].end = OMAP34XX_OHCI_BASE + SZ_1K - 1;
+ usbhs_resources[5].start = INT_34XX_OHCI_IRQ;
+ setup_ehci_io_mux(pdata->port_mode);
+ setup_ohci_io_mux(pdata->port_mode);
+ } else if (cpu_is_omap44xx()) {
+ usbhs_resources[0].start = OMAP44XX_UHH_CONFIG_BASE;
+ usbhs_resources[0].end = OMAP44XX_UHH_CONFIG_BASE + SZ_1K - 1;
+ usbhs_resources[1].start = OMAP44XX_USBTLL_BASE;
+ usbhs_resources[1].end = OMAP44XX_USBTLL_BASE + SZ_4K - 1;
+ usbhs_resources[2].start = OMAP44XX_HSUSB_EHCI_BASE;
+ usbhs_resources[2].end = OMAP44XX_HSUSB_EHCI_BASE + SZ_1K - 1;
+ usbhs_resources[3].start = OMAP44XX_IRQ_EHCI;
+ usbhs_resources[4].start = OMAP44XX_HSUSB_OHCI_BASE;
+ usbhs_resources[4].end = OMAP44XX_HSUSB_OHCI_BASE + SZ_1K - 1;
+ usbhs_resources[5].start = OMAP44XX_IRQ_OHCI;
+ setup_4430ehci_io_mux(pdata->port_mode);
+ setup_4430ohci_io_mux(pdata->port_mode);
+ }
+
+ pdev->num_resources = ARRAY_SIZE(usbhs_resources);
+ pdev->resource = usbhs_resources;
+
+ platform_device_add_data(pdev, &usbhs_data, sizeof(usbhs_data));
+
+ if (platform_device_add(pdev) < 0) {
+ printk(KERN_ERR "Unable to register USBHS device\n");
+ platform_device_put(pdev);
+ return;
+ }
+}
#else
+void __init usbhs_init(const struct usbhs_omap_board_data *pdata)
+{
+}
+
void __init usb_ohci_init(const struct usbhs_omap_board_data *pdata)
{
}
-#endif /* CONFIG_USB_OHCI_HCD */
+void __init usb_ehci_init(const struct usbhs_omap_board_data *pdata)
+{
+}
+#endif
+
+
@@ -102,6 +102,8 @@ extern void usb_ehci_init(const struct usbhs_omap_board_data *pdata);
extern void usb_ohci_init(const struct usbhs_omap_board_data *pdata);
+extern void usbhs_init(const struct usbhs_omap_board_data *pdata);
+
extern int omap_usbhs_enable(struct device *dev);
extern void omap_usbhs_disable(struct device *dev);