@@ -271,6 +271,7 @@ extern void omap_secondary_startup(void);
extern u32 omap_modify_auxcoreboot0(u32 set_mask, u32 clear_mask);
extern void omap_auxcoreboot_addr(u32 cpu_addr);
extern u32 omap_read_auxcoreboot0(void);
+extern void omap5_secondary_startup(void);
#endif
#if defined(CONFIG_SMP) && defined(CONFIG_PM)
@@ -19,6 +19,27 @@
#include <linux/init.h>
__CPUINIT
+
+/* Physical address needed since MMU not enabled yet on secondary core */
+#define AUX_CORE_BOOT0_PA 0x48281800
+
+/*
+ * OMAP5 specific entry point for secondary CPU to jump from ROM
+ * code. This routine also provides a holding flag into which
+ * secondary core is held until we're ready for it to initialise.
+ * The primary core will update this flag using a hardware
++ * register AuxCoreBoot0.
+ */
+ENTRY(omap5_secondary_startup)
+wait: ldr r2, =AUX_CORE_BOOT0_PA @ read from AuxCoreBoot0
+ ldr r0, [r2]
+ mov r0, r0, lsr #5
+ mrc p15, 0, r4, c0, c0, 5
+ and r4, r4, #0x0f
+ cmp r0, r4
+ bne wait
+ b secondary_startup
+END(omap5_secondary_startup)
/*
* OMAP4 specific entry point for secondary CPU to jump from ROM
* code. This routine also provides a holding flag into which
@@ -33,6 +33,12 @@
#include "common.h"
#include "clockdomain.h"
+#define CPU_MASK 0xff0ffff0
+#define CPU_CORTEX_A9 0x410FC090
+#define CPU_CORTEX_A15 0x410FC0F0
+
+#define OMAP5_CORE_COUNT 0x2
+
/* SCU base address */
static void __iomem *scu_base;
@@ -133,7 +139,6 @@ int __cpuinit boot_secondary(unsigned int cpu, struct task_struct *idle)
static void __init wakeup_secondary(void)
{
void __iomem *base = omap_get_wakeupgen_base();
-
/*
* Write the address of secondary startup routine into the
* AuxCoreBoot1 where ROM code will jump and start executing
@@ -162,16 +167,21 @@ static void __init wakeup_secondary(void)
*/
void __init smp_init_cpus(void)
{
- unsigned int i, ncores;
-
- /*
- * Currently we can't call ioremap here because
- * SoC detection won't work until after init_early.
- */
- scu_base = OMAP2_L4_IO_ADDRESS(OMAP44XX_SCU_BASE);
- BUG_ON(!scu_base);
-
- ncores = scu_get_core_count(scu_base);
+ unsigned int i = 0, ncores = 1, cpu_id;
+
+ /* Use ARM cpuid check here, as SoC detection will not work so early */
+ cpu_id = read_cpuid(CPUID_ID) & CPU_MASK;
+ if (cpu_id == CPU_CORTEX_A9) {
+ /*
+ * Currently we can't call ioremap here because
+ * SoC detection won't work until after init_early.
+ */
+ scu_base = OMAP2_L4_IO_ADDRESS(OMAP44XX_SCU_BASE);
+ BUG_ON(!scu_base);
+ ncores = scu_get_core_count(scu_base);
+ } else if (cpu_id == CPU_CORTEX_A15) {
+ ncores = OMAP5_CORE_COUNT;
+ }
/* sanity check */
if (ncores > nr_cpu_ids) {
@@ -193,6 +203,7 @@ void __init platform_smp_prepare_cpus(unsigned int max_cpus)
* Initialise the SCU and wake up the secondary core using
* wakeup_secondary().
*/
- scu_enable(scu_base);
+ if (scu_base)
+ scu_enable(scu_base);
wakeup_secondary();
}