@@ -248,6 +248,25 @@ twl4030_usb_clear_bits(struct twl4030_usb *twl, u8 reg, u8 bits)
/*-------------------------------------------------------------------------*/
+static bool twl4030_is_driving_vbus(struct twl4030_usb *twl)
+{
+ int ret;
+
+ ret = twl4030_usb_read(twl, PHY_CLK_CTRL_STS);
+ if (ret < 0 || !(ret & PHY_DPLL_CLK))
+ /*
+ * if clocks are off, registers are not updated,
+ * but we can assume we don't drive VBUS in this case
+ */
+ return false;
+
+ ret = twl4030_usb_read(twl, ULPI_OTG_CTRL);
+ if (ret < 0)
+ return false;
+
+ return (ret & (ULPI_OTG_DRVVBUS | ULPI_OTG_CHRGVBUS)) ? true : false;
+}
+
static enum omap_musb_vbus_id_status
twl4030_usb_linkstat(struct twl4030_usb *twl)
{
@@ -270,13 +289,19 @@ static enum omap_musb_vbus_id_status
if (status < 0)
dev_err(twl->dev, "USB link status err %d\n", status);
else if (status & (BIT(7) | BIT(2))) {
- if (status & (BIT(7)))
- twl->vbus_supplied = true;
+ if (status & BIT(7)) {
+ if (twl4030_is_driving_vbus(twl))
+ status &= ~BIT(7);
+ else
+ twl->vbus_supplied = true;
+ }
if (status & BIT(2))
linkstat = OMAP_MUSB_ID_GROUND;
- else
+ else if (status & BIT(7))
linkstat = OMAP_MUSB_VBUS_VALID;
+ else
+ linkstat = OMAP_MUSB_VBUS_OFF;
} else {
if (twl->linkstat != OMAP_MUSB_UNKNOWN)
linkstat = OMAP_MUSB_VBUS_OFF;
At least on pandora, STS_VBUS gets set even when VBUS is driven by twl itself. Reporting VBUS in this case confuses OMAP musb glue and charger driver, so check if OTG VBUS charge pump is on before reporting VBUS event to avoid this problem. Signed-off-by: Grazvydas Ignotas <notasas@gmail.com> --- drivers/usb/phy/phy-twl4030-usb.c | 31 ++++++++++++++++++++++++++++--- 1 file changed, 28 insertions(+), 3 deletions(-)