@@ -96,43 +96,15 @@ config MTD_NAND_OMAP2
config MTD_NAND_OMAP_BCH
depends on MTD_NAND && MTD_NAND_OMAP2 && ARCH_OMAP3
- tristate "Enable support for hardware BCH error correction"
+ tristate "Support hardware based BCH error correction"
default n
select BCH
- select BCH_CONST_PARAMS
help
- Support for hardware BCH error correction.
-
-choice
- prompt "BCH error correction capability"
- depends on MTD_NAND_OMAP_BCH
-
-config MTD_NAND_OMAP_BCH8
- bool "8 bits / 512 bytes (recommended)"
- help
- Support correcting up to 8 bitflips per 512-byte block.
- This will use 13 bytes of spare area per 512 bytes of page data.
- This is the recommended mode, as 4-bit mode does not work
- on some OMAP3 revisions, due to a hardware bug.
-
-config MTD_NAND_OMAP_BCH4
- bool "4 bits / 512 bytes"
- help
- Support correcting up to 4 bitflips per 512-byte block.
- This will use 7 bytes of spare area per 512 bytes of page data.
- Note that this mode does not work on some OMAP3 revisions, due to a
- hardware bug. Please check your OMAP datasheet before selecting this
- mode.
-
-endchoice
-
-if MTD_NAND_OMAP_BCH
-config BCH_CONST_M
- default 13
-config BCH_CONST_T
- default 4 if MTD_NAND_OMAP_BCH4
- default 8 if MTD_NAND_OMAP_BCH8
-endif
+ This config enables the ELM hardware engine, which can be used to
+ locate and correct errors when using BCH ECC scheme. This offloads
+ the cpu from doing ECC error searching and correction. However some
+ legacy OMAP families like OMAP2xxx, OMAP3xxx do not have ELM engine
+ so they should not enable this config symbol.
config MTD_NAND_IDS
tristate
With OMAP NAND driver updates, selection of ecc-scheme: *DT enabled kernel* depends on ti,nand-ecc-opt and ti,elm-id DT bindings. *Non DT enabled kernel* depends on elm_dev and ecc-scheme passed along with platform-data from board file. So, selection of ecc-scheme (BCH8 or BCH4) from KConfig can be removed Signed-off-by: Pekon Gupta <pekon@ti.com> --- drivers/mtd/nand/Kconfig | 40 ++++++---------------------------------- 1 file changed, 6 insertions(+), 34 deletions(-)