@@ -689,6 +689,30 @@
<&edma 11>;
dma-names = "tx", "rx";
};
+
+ elm: elm@48080000 {
+ compatible = "ti,am3352-elm";
+ reg = <0x48080000 0x2000>;
+ interrupts = <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>;
+ ti,hwmods = "elm";
+ clocks = <&l4ls_gclk>;
+ clock-names = "fck";
+ status = "disabled";
+ };
+
+ gpmc: gpmc@50000000 {
+ compatible = "ti,am3352-gpmc";
+ ti,hwmods = "gpmc";
+ clocks = <&l3s_gclk>;
+ clock-names = "fck";
+ reg = <0x50000000 0x2000>;
+ interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
+ gpmc,num-cs = <7>;
+ gpmc,num-waitpins = <2>;
+ #address-cells = <2>;
+ #size-cells = <1>;
+ status = "disabled";
+ };
};
};
@@ -79,6 +79,27 @@
0x18c (PIN_INPUT_PULLUP | SLEWCTRL_FAST | MUX_MODE0) /* i2c0_scl.i2c0_scl */
>;
};
+
+ nand_flash_x8: nand_flash_x8 {
+ pinctrl-single,pins = <
+ 0x40 (PIN_OUTPUT_PULLDOWN | MUX_MODE7) /* gpmc_a0.SELQSPIorNAND/GPIO */
+ 0x0 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad0.gpmc_ad0 */
+ 0x4 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad1.gpmc_ad1 */
+ 0x8 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad2.gpmc_ad2 */
+ 0xc (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad3.gpmc_ad3 */
+ 0x10 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad4.gpmc_ad4 */
+ 0x14 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad5.gpmc_ad5 */
+ 0x18 (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad6.gpmc_ad6 */
+ 0x1c (PIN_INPUT_PULLDOWN | MUX_MODE0) /* gpmc_ad7.gpmc_ad7 */
+ 0x70 (PIN_INPUT_PULLUP | MUX_MODE0) /* gpmc_wait0.gpmc_wait0 */
+ 0x74 (PIN_OUTPUT_PULLUP | MUX_MODE7) /* gpmc_wpn.gpmc_wpn */
+ 0x7c (PIN_OUTPUT | MUX_MODE0) /* gpmc_csn0.gpmc_csn0 */
+ 0x90 (PIN_OUTPUT | MUX_MODE0) /* gpmc_advn_ale.gpmc_advn_ale */
+ 0x94 (PIN_OUTPUT | MUX_MODE0) /* gpmc_oen_ren.gpmc_oen_ren */
+ 0x98 (PIN_OUTPUT | MUX_MODE0) /* gpmc_wen.gpmc_wen */
+ 0x9c (PIN_OUTPUT | MUX_MODE0) /* gpmc_be0n_cle.gpmc_be0n_cle */
+ >;
+ };
};
matrix_keypad: matrix_keypad@0 {
@@ -184,3 +205,89 @@
&gpio3 {
status = "okay";
};
+
+&elm {
+ status = "okay";
+};
+
+&gpmc {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&nand_flash_x8>;
+ ranges = <0 0 0x08000000 0x10000000>; /* CS0: NAND */
+ nand@0,0 {
+ reg = <0 0 0>; /* CS0, offset 0 */
+ ti,nand-ecc-opt = "bch8";
+ ti,elm-id = <&elm>;
+ nand-bus-width = <8>;
+ gpmc,device-width = <1>;
+ gpmc,sync-clk-ps = <0>;
+ gpmc,cs-on-ns = <0>;
+ gpmc,cs-rd-off-ns = <40>; /* tCEA + tCHZ + 1 */
+ gpmc,cs-wr-off-ns = <40>;
+ gpmc,adv-on-ns = <0>; /* cs-on-ns */
+ gpmc,adv-rd-off-ns = <25>; /* min( tALH + tALS + 1) */
+ gpmc,adv-wr-off-ns = <25>; /* min( tALH + tALS + 1) */
+ gpmc,we-on-ns = <0>; /* cs-on-ns */
+ gpmc,we-off-ns = <20>; /* we-on-time + tWP + 2 */
+ gpmc,oe-on-ns = <3>; /* cs-on-ns + tRR + 2 */
+ gpmc,oe-off-ns = <30>; /* oe-on-ns + tRP + 2 */
+ gpmc,access-ns = <30>; /* tCEA + 4*/
+ gpmc,rd-cycle-ns = <40>;
+ gpmc,wr-cycle-ns = <40>;
+ gpmc,wait-on-read = "true";
+ gpmc,wait-on-write = "true";
+ gpmc,bus-turnaround-ns = <0>;
+ gpmc,cycle2cycle-delay-ns = <0>;
+ gpmc,clk-activation-ns = <0>;
+ gpmc,wait-monitoring-ns = <0>;
+ gpmc,wr-access-ns = <40>;
+ gpmc,wr-data-mux-bus-ns = <0>;
+ /* MTD partition table */
+ /* All SPL-* partitions are sized to minimal length
+ * which can be independently programmable. For
+ * NAND flash this is equal to size of erase-block */
+ #address-cells = <1>;
+ #size-cells = <1>;
+ partition@0 {
+ label = "NAND.SPL";
+ reg = <0x00000000 0x00040000>;
+ };
+ partition@1 {
+ label = "NAND.SPL.backup1";
+ reg = <0x00040000 0x00040000>;
+ };
+ partition@2 {
+ label = "NAND.SPL.backup2";
+ reg = <0x00080000 0x00040000>;
+ };
+ partition@3 {
+ label = "NAND.SPL.backup3";
+ reg = <0x000C0000 0x00040000>;
+ };
+ partition@4 {
+ label = "NAND.u-boot-spl-os";
+ reg = <0x00100000 0x00080000>;
+ };
+ partition@5 {
+ label = "NAND.u-boot";
+ reg = <0x00180000 0x00100000>;
+ };
+ partition@6 {
+ label = "NAND.u-boot-env";
+ reg = <0x00280000 0x00040000>;
+ };
+ partition@7 {
+ label = "NAND.u-boot-env.backup1";
+ reg = <0x002C0000 0x00040000>;
+ };
+ partition@8 {
+ label = "NAND.kernel";
+ reg = <0x00300000 0x00700000>;
+ };
+ partition@9 {
+ label = "NAND.file-system";
+ reg = <0x00800000 0x1F600000>;
+ };
+ };
+};
This patch: - enables GPMC h/w and ELM h/w engine for AM43xx devices (am4372.dtsi) - adds pinmux and DT node for Micron 4K-paged x8 NAND device (MT29F4G08AB) present on following boards: am43x-epos-evm: On this board, NAND Flash control lines are muxed with QSPI, Thus only one of the two can be used at a time. Selection is controlled by: (a) dynamically driving following GPIO pin from software GPMC_A0(GPIO) == 0 NAND is selected (default) GPMC_A0(GPIO) == 1 eMMC is selected Signed-off-by: Pekon Gupta <pekon@ti.com> --- arch/arm/boot/dts/am4372.dtsi | 24 ++++++++ arch/arm/boot/dts/am43x-epos-evm.dts | 107 +++++++++++++++++++++++++++++++++++ 2 files changed, 131 insertions(+)