@@ -262,9 +262,7 @@ static int __init omap_hsmmc_pdata_init(struct omap2_hsmmc_info *c,
mmc->slots[0].name = hc_name;
mmc->nr_slots = 1;
mmc->slots[0].caps = c->caps;
- mmc->slots[0].pm_caps = c->pm_caps;
mmc->slots[0].internal_clock = !c->ext_clock;
- mmc->max_freq = c->max_freq;
mmc->reg_offset = 0;
mmc->get_context_loss_count = hsmmc_get_context_loss;
@@ -280,18 +278,6 @@ static int __init omap_hsmmc_pdata_init(struct omap2_hsmmc_info *c,
if (c->nonremovable)
mmc->slots[0].nonremovable = 1;
- if (c->power_saving)
- mmc->slots[0].power_saving = 1;
-
- if (c->no_off)
- mmc->slots[0].no_off = 1;
-
- if (c->no_off_init)
- mmc->slots[0].no_regulator_off_init = c->no_off_init;
-
- if (c->vcc_aux_disable_is_sleep)
- mmc->slots[0].vcc_aux_disable_is_sleep = 1;
-
/*
* NOTE: MMC slots should have a Vcc regulator set up.
* This may be from a TWL4030-family chip, another
@@ -12,23 +12,17 @@ struct omap2_hsmmc_info {
u8 mmc; /* controller 1/2/3 */
u32 caps; /* 4/8 wires and any additional host
* capabilities OR'd (ref. linux/mmc/host.h) */
- u32 pm_caps; /* PM capabilities */
bool transceiver; /* MMC-2 option */
bool ext_clock; /* use external pin for input clock */
bool cover_only; /* No card detect - just cover switch */
bool nonremovable; /* Nonremovable e.g. eMMC */
bool power_saving; /* Try to sleep or power off when possible */
- bool no_off; /* power_saving and power is not to go off */
- bool no_off_init; /* no power off when not in MMC sleep state */
- bool vcc_aux_disable_is_sleep; /* Regulator off remapped to sleep */
bool deferred; /* mmc needs a deferred probe */
int gpio_cd; /* or -EINVAL */
int gpio_wp; /* or -EINVAL */
char *name; /* or NULL for default */
struct platform_device *pdev; /* mmc controller instance */
int ocr_mask; /* temporary HACK */
- int max_freq; /* maximum clock, if constrained by external
- * circuitry, or 0 for default */
/* Remux (pad configuration) when powering on/off */
void (*remux)(struct device *dev, int slot, int power_on);
/* init some special card */
@@ -30,8 +30,6 @@
#define OMAP_HSMMC_BROKEN_MULTIBLOCK_READ BIT(1)
#define OMAP_HSMMC_SWAKEUP_MISSING BIT(2)
-struct mmc_card;
-
struct omap_hsmmc_dev_attr {
u8 flags;
};
@@ -73,16 +71,9 @@ struct omap_hsmmc_platform_data {
* 4/8 wires and any additional host capabilities
* need to OR'd all capabilities (ref. linux/mmc/host.h)
*/
- u8 wires; /* Used for the MMC driver on omap1 and 2420 */
u32 caps; /* Used for the MMC driver on 2430 and later */
u32 pm_caps; /* PM capabilities of the mmc */
- /*
- * nomux means "standard" muxing is wrong on this board, and
- * that board-specific code handled it before common init logic.
- */
- unsigned nomux:1;
-
/* switch pin can be for card detect (default) or card cover */
unsigned cover:1;
@@ -92,25 +83,13 @@ struct omap_hsmmc_platform_data {
/* nonremovable e.g. eMMC */
unsigned nonremovable:1;
- /* Try to sleep or power off when possible */
- unsigned power_saving:1;
-
- /* If using power_saving and the MMC power is not to go off */
- unsigned no_off:1;
-
/* eMMC does not handle power off when not in sleep state */
unsigned no_regulator_off_init:1;
- /* Regulator off remapped to sleep */
- unsigned vcc_aux_disable_is_sleep:1;
-
/* we can put the features above into this variable */
#define HSMMC_HAS_PBIAS (1 << 0)
#define HSMMC_HAS_UPDATED_RESET (1 << 1)
#define HSMMC_HAS_HSPE_SUPPORT (1 << 2)
-#define MMC_OMAP7XX (1 << 3)
-#define MMC_OMAP15XX (1 << 4)
-#define MMC_OMAP16XX (1 << 5)
unsigned features;
int switch_pin; /* gpio (card detect) */
@@ -145,8 +124,5 @@ struct omap_hsmmc_platform_data {
int card_detect_irq;
int (*card_detect)(struct device *dev, int slot);
-
- unsigned int ban_openended:1;
-
} slots[OMAP_MMC_MAX_SLOTS];
};
platform data is built from omap2_hsmmc_info, remove all fields that are never set in omap_hsmmc_info, hence never copied to platform data. Note that the omap_hsmmc driver never used any of these fields, they were completely unused compile tested for these platforms CONFIG_MACH_OMAP3_BEAGLE=y CONFIG_MACH_DEVKIT8000=y CONFIG_MACH_OMAP_LDP=y CONFIG_MACH_OMAP3530_LV_SOM=y CONFIG_MACH_OMAP3_TORPEDO=y CONFIG_MACH_OVERO=y CONFIG_MACH_OMAP3517EVM=y CONFIG_MACH_CRANEBOARD=y CONFIG_MACH_OMAP3_PANDORA=y CONFIG_MACH_TOUCHBOOK=y CONFIG_MACH_OMAP_3430SDP=y CONFIG_MACH_NOKIA_RX51=y CONFIG_MACH_CM_T35=y CONFIG_MACH_CM_T3517=y CONFIG_MACH_CM_T3730=y CONFIG_MACH_SBC3530=y Signed-off-by: Andreas Fenkart <afenkart@gmail.com>