@@ -694,6 +694,11 @@ static int __init dra7xx_pcie_probe(struct platform_device *pdev)
switch (mode) {
case DW_PCIE_RC_TYPE:
+ if (!IS_ENABLED(CONFIG_PCI_DRA7XX_HOST)) {
+ ret = -ENODEV;
+ goto err_gpio;
+ }
+
dra7xx_pcie_writel(dra7xx, PCIECTRL_TI_CONF_DEVICE_TYPE,
DEVICE_TYPE_RC);
ret = dra7xx_add_pcie_port(dra7xx, pdev);
@@ -701,6 +706,11 @@ static int __init dra7xx_pcie_probe(struct platform_device *pdev)
goto err_gpio;
break;
case DW_PCIE_EP_TYPE:
+ if (!IS_ENABLED(CONFIG_PCI_DRA7XX_EP)) {
+ ret = -ENODEV;
+ goto err_gpio;
+ }
+
dra7xx_pcie_writel(dra7xx, PCIECTRL_TI_CONF_DEVICE_TYPE,
DEVICE_TYPE_EP);
The dra7xx driver supports both host and ep mode. When enabling support for only one of the modes, help the compiler to remove code for the mode that we have not enabled in the driver. By adding if (!IS_ENABLED(CONFIG_PCI_DRA7XX_HOST)) return -ENODEV; anything after that statement will get silently dropped by the compiler, including static functions and structures that are referenced indirectly from there. Suggested-by: Arnd Bergmann <arnd@arndb.de> Signed-off-by: Niklas Cassel <niklas.cassel@axis.com> --- drivers/pci/dwc/pci-dra7xx.c | 10 ++++++++++ 1 file changed, 10 insertions(+)