@@ -719,7 +719,7 @@ static int cafe_nand_probe(struct pci_dev *pdev,
if (skipbbt) {
cafe->nand.options |= NAND_SKIP_BBTSCAN;
- cafe->nand.block_bad = cafe_nand_block_bad;
+ cafe->nand.legacy.block_bad = cafe_nand_block_bad;
}
if (numtimings && numtimings != 3) {
@@ -1572,7 +1572,7 @@ static int __init doc_probe(unsigned long physadr)
nand->legacy.cmd_ctrl = doc200x_hwcontrol;
nand->legacy.dev_ready = doc200x_dev_ready;
nand->legacy.waitfunc = doc200x_wait;
- nand->block_bad = doc200x_block_bad;
+ nand->legacy.block_bad = doc200x_block_bad;
nand->ecc.hwctl = doc200x_enable_hwecc;
nand->ecc.calculate = doc200x_calculate_ecc;
nand->ecc.correct = doc200x_correct_data;
@@ -1774,7 +1774,7 @@ static int mx23_boot_init(struct gpmi_nand_data *this)
*/
if (block_mark != 0xff) {
dev_dbg(dev, "Transcribing mark in block %u\n", block);
- ret = chip->block_markbad(chip, byte);
+ ret = chip->legacy.block_markbad(chip, byte);
if (ret)
dev_err(dev,
"Failed to mark block bad with ret %d\n",
@@ -1908,7 +1908,7 @@ static int gpmi_nand_init(struct gpmi_nand_data *this)
chip->legacy.read_buf = gpmi_read_buf;
chip->legacy.write_buf = gpmi_write_buf;
chip->badblock_pattern = &gpmi_bbt_descr;
- chip->block_markbad = gpmi_block_markbad;
+ chip->legacy.block_markbad = gpmi_block_markbad;
chip->options |= NAND_NO_SUBPAGE_WRITE;
/* Set up swap_block_mark, must be set before the gpmi_set_geometry() */
@@ -475,6 +475,27 @@ static int nand_default_block_markbad(struct nand_chip *chip, loff_t ofs)
return ret;
}
+/**
+ * nand_markbad_bbm - mark a block by updating the BBM
+ * @chip: NAND chip object
+ * @ofs: offset of the block to mark bad
+ */
+int nand_markbad_bbm(struct nand_chip *chip, loff_t ofs)
+{
+ if (chip->legacy.block_markbad)
+ return chip->legacy.block_markbad(chip, ofs);
+
+ return nand_default_block_markbad(chip, ofs);
+}
+
+static int nand_isbad_bbm(struct nand_chip *chip, loff_t ofs)
+{
+ if (chip->legacy.block_bad)
+ return chip->legacy.block_bad(chip, ofs);
+
+ return nand_block_bad(chip, ofs);
+}
+
/**
* nand_block_markbad_lowlevel - mark a block bad
* @mtd: MTD device structure
@@ -482,7 +503,7 @@ static int nand_default_block_markbad(struct nand_chip *chip, loff_t ofs)
*
* This function performs the generic NAND bad block marking steps (i.e., bad
* block table(s) and/or marker(s)). We only allow the hardware driver to
- * specify how to write bad block markers to OOB (chip->block_markbad).
+ * specify how to write bad block markers to OOB (chip->legacy.block_markbad).
*
* We try operations in the following order:
*
@@ -510,7 +531,7 @@ static int nand_block_markbad_lowlevel(struct mtd_info *mtd, loff_t ofs)
/* Write bad block marker to OOB */
nand_get_device(mtd, FL_WRITING);
- ret = chip->block_markbad(chip, ofs);
+ ret = nand_markbad_bbm(chip, ofs);
nand_release_device(mtd);
}
@@ -582,11 +603,11 @@ static int nand_block_checkbad(struct mtd_info *mtd, loff_t ofs, int allowbbt)
{
struct nand_chip *chip = mtd_to_nand(mtd);
- if (!chip->bbt)
- return chip->block_bad(chip, ofs);
-
/* Return info from the table */
- return nand_isbad_bbt(chip, ofs, allowbbt);
+ if (chip->bbt)
+ return nand_isbad_bbt(chip, ofs, allowbbt);
+
+ return nand_isbad_bbm(chip, ofs);
}
/**
@@ -4942,10 +4963,6 @@ static void nand_set_defaults(struct nand_chip *chip)
/* If called twice, pointers that depend on busw may need to be reset */
if (!chip->legacy.read_byte || chip->legacy.read_byte == nand_read_byte)
chip->legacy.read_byte = busw ? nand_read_byte16 : nand_read_byte;
- if (!chip->block_bad)
- chip->block_bad = nand_block_bad;
- if (!chip->block_markbad)
- chip->block_markbad = nand_default_block_markbad;
if (!chip->legacy.write_buf || chip->legacy.write_buf == nand_write_buf)
chip->legacy.write_buf = busw ? nand_write_buf16 : nand_write_buf;
if (!chip->legacy.write_byte || chip->legacy.write_byte == nand_write_byte)
@@ -689,7 +689,7 @@ static void mark_bbt_block_bad(struct nand_chip *this,
bbt_mark_entry(this, block, BBT_BLOCK_WORN);
to = (loff_t)block << this->bbt_erase_shift;
- res = this->block_markbad(this, to);
+ res = nand_markbad_bbm(this, to);
if (res)
pr_warn("nand_bbt: error %d while marking block %d bad\n",
res, block);
@@ -2819,8 +2819,8 @@ static int qcom_nand_host_init_and_register(struct qcom_nand_controller *nandc,
* and block_markbad helpers until we permanently switch to using
* MTD_OPS_RAW for all drivers (with the help of badblockbits)
*/
- chip->block_bad = qcom_nandc_block_bad;
- chip->block_markbad = qcom_nandc_block_markbad;
+ chip->legacy.block_bad = qcom_nandc_block_bad;
+ chip->legacy.block_markbad = qcom_nandc_block_markbad;
chip->controller = &nandc->controller;
chip->options |= NAND_NO_SUBPAGE_WRITE | NAND_USE_BOUNCE_BUFFER |
@@ -168,7 +168,7 @@ static int sm_attach_chip(struct nand_chip *chip)
/* Bad block marker position */
chip->badblockpos = 0x05;
chip->badblockbits = 7;
- chip->block_markbad = sm_block_markbad;
+ chip->legacy.block_markbad = sm_block_markbad;
/* ECC layout */
if (mtd->writesize == SM_SECTOR_SIZE)
@@ -1187,6 +1187,8 @@ int nand_op_parser_exec_op(struct nand_chip *chip,
* If set to NULL no access to ready/busy is available and the
* ready/busy information is read from the chip status register.
* @waitfunc: hardware specific function for wait on ready.
+ * @block_bad: check if a block is bad, using OOB markers
+ * @block_markbad: mark a block bad
*
* If you look at this structure you're already wrong. These fields/hooks are
* all deprecated.
@@ -1203,6 +1205,8 @@ struct nand_legacy {
int page_addr);
int (*dev_ready)(struct nand_chip *chip);
int (*waitfunc)(struct nand_chip *chip);
+ int (*block_bad)(struct nand_chip *chip, loff_t ofs);
+ int (*block_markbad)(struct nand_chip *chip, loff_t ofs);
};
/**
@@ -1214,8 +1218,6 @@ struct nand_legacy {
* fields/hooks, you should consider reworking the driver
* avoid using them.
* @select_chip: [REPLACEABLE] select chip nr
- * @block_bad: [REPLACEABLE] check if a block is bad, using OOB markers
- * @block_markbad: [REPLACEABLE] mark a block bad
* @exec_op: controller specific method to execute NAND operations.
* This method replaces ->cmdfunc(),
* ->legacy.{read,write}_{buf,byte,word}(),
@@ -1303,8 +1305,6 @@ struct nand_chip {
struct nand_legacy legacy;
void (*select_chip)(struct nand_chip *chip, int cs);
- int (*block_bad)(struct nand_chip *chip, loff_t ofs);
- int (*block_markbad)(struct nand_chip *chip, loff_t ofs);
int (*exec_op)(struct nand_chip *chip,
const struct nand_operation *op,
bool check_only);
@@ -1556,6 +1556,7 @@ extern const struct nand_manufacturer_ops macronix_nand_manuf_ops;
int nand_create_bbt(struct nand_chip *chip);
int nand_markbad_bbt(struct nand_chip *chip, loff_t offs);
+int nand_markbad_bbm(struct nand_chip *chip, loff_t ofs);
int nand_isreserved_bbt(struct nand_chip *chip, loff_t offs);
int nand_isbad_bbt(struct nand_chip *chip, loff_t offs, int allowbbt);
int nand_erase_nand(struct nand_chip *chip, struct erase_info *instr,
Those hooks have been overloaded by some drivers for bad reasons: either the driver was not fitting in the NAND framework and should have been an MTD driver (docg4), or it was not properly implementing the OOB read/write request or had a weird layout where BBM are trashed. In any case, we should discourage people from overloading those methods and encourage them to fix their driver instead. Move the ->block_{bad,markbad}() hooks to the nand_legacy struct to make it clear. Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com> --- drivers/mtd/nand/raw/cafe_nand.c | 2 +- drivers/mtd/nand/raw/diskonchip.c | 2 +- drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 4 ++-- drivers/mtd/nand/raw/nand_base.c | 37 ++++++++++++++++++++++-------- drivers/mtd/nand/raw/nand_bbt.c | 2 +- drivers/mtd/nand/raw/qcom_nandc.c | 4 ++-- drivers/mtd/nand/raw/sm_common.c | 2 +- include/linux/mtd/rawnand.h | 9 ++++---- 8 files changed, 40 insertions(+), 22 deletions(-)