@@ -565,6 +565,9 @@ static const struct cpsw_stats cpsw_gstrings_ch_stats[] = {
(func)(slave++, ##arg); \
} while (0)
+static int cpsw_ndo_vlan_rx_add_vid(struct net_device *ndev,
+ __be16 proto, u16 vid);
+
static inline int cpsw_get_slave_port(u32 slave_num)
{
return slave_num + 1;
@@ -1955,9 +1958,23 @@ static void cpsw_mqprio_resume(struct cpsw_slave *slave, struct cpsw_priv *priv)
slave_write(slave, tx_prio_map, tx_prio_rg);
}
+static int cpsw_restore_vlans(struct net_device *vdev, int vid, void *arg)
+{
+ struct cpsw_priv *priv = arg;
+
+ if (!vdev)
+ return 0;
+
+ cpsw_ndo_vlan_rx_add_vid(priv->ndev, 0, vid);
+ return 0;
+}
+
/* restore resources after port reset */
static void cpsw_restore(struct cpsw_priv *priv)
{
+ /* restore vlan configurations */
+ vlan_for_each(priv->ndev, cpsw_restore_vlans, priv);
+
/* restore MQPRIO offload */
for_each_slave(priv, cpsw_mqprio_resume, priv);
The vlan configuration is not restored after interface donw/up sequence (if dual-emac - both interfaces). Tested on am572x EVM. Steps to check: ~# ip link add link eth1 name eth1.100 type vlan id 100 ~# ifconfig eth0 down ~# ifconfig eth1 down This is TI sdk tool, dumping all ALE entries, see they are present ~# switch-config -d ~# ifconfig eth1 up See entry for vid 100 is absent ~# switch-config -d Try to remove vid and observe warning: ~# ip link del eth1.100 [ 739.526757] net eth1: removing vlanid 100 from vlan filter [ 739.533322] failed to kill vid 0081/100 for device eth1 This patch fixes it, restoring only vlan ALE entries and all other unicast/multicast entries are restored by system calling rx_mode ndo. Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@linaro.org> --- drivers/net/ethernet/ti/cpsw.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)