@@ -79,6 +79,15 @@
#define PCIE_RC_K2L 0xb00a
#define PCIE_RC_K2G 0xb00b
+#define KS_PCIE_DEV_TYPE_MASK (0x3 << 1)
+#define KS_PCIE_DEV_TYPE(mode) ((mode) << 1)
+
+#define EP 0x0
+#define LEG_EP 0x1
+#define RC 0x2
+
+#define KS_PCIE_SYSCLOCKOUTEN BIT(0)
+
#define to_keystone_pcie(x) dev_get_drvdata((x)->dev)
struct keystone_pcie {
@@ -859,6 +868,30 @@ static int ks_pcie_enable_phy(struct keystone_pcie *ks_pcie)
return ret;
}
+static int ks_pcie_set_mode(struct device *dev)
+{
+ struct device_node *np = dev->of_node;
+ struct regmap *syscon;
+ u32 val;
+ u32 mask;
+ int ret = 0;
+
+ syscon = syscon_regmap_lookup_by_phandle(np, "ti,syscon-pcie-mode");
+ if (IS_ERR(syscon))
+ return 0;
+
+ mask = KS_PCIE_DEV_TYPE_MASK | KS_PCIE_SYSCLOCKOUTEN;
+ val = KS_PCIE_DEV_TYPE(RC) | KS_PCIE_SYSCLOCKOUTEN;
+
+ ret = regmap_update_bits(syscon, 0, mask, val);
+ if (ret) {
+ dev_err(dev, "failed to set pcie mode\n");
+ return ret;
+ }
+
+ return 0;
+}
+
static int __init ks_pcie_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
@@ -971,6 +1004,10 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
goto err_get_sync;
}
+ ret = ks_pcie_set_mode(dev);
+ if (ret < 0)
+ goto err_get_sync;
+
ret = ks_pcie_add_pcie_port(ks_pcie, pdev);
if (ret < 0)
goto err_get_sync;
Explicitly set the PCIe mode to BOOTCFG_DEVCFG instead of always relying on the default values. This is required when EP mode has to be explicitly written to BOOTCFG_DEVCFG register. Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> --- drivers/pci/controller/dwc/pci-keystone.c | 37 +++++++++++++++++++++++ 1 file changed, 37 insertions(+)