diff mbox series

[1/4] ARM: dts: imx6: RDU2: Use new CODEC reset pin name

Message ID 20190329181313.21009-1-afd@ti.com (mailing list archive)
State New, archived
Headers show
Series [1/4] ARM: dts: imx6: RDU2: Use new CODEC reset pin name | expand

Commit Message

Andrew Davis March 29, 2019, 6:13 p.m. UTC 
The correct DT property for specifying a GPIO used for reset
is "reset-gpios", the driver now accepts this name, use it here.

Note the GPIO polarity in the driver was ignored before and always
assumed to be active low, when all the DTs are fixed we will start
respecting the specified polarity. Switch polarity in DT to the
currently assumed one, this way when the driver changes the
behavior will not change.

Signed-off-by: Andrew F. Davis <afd@ti.com>
---
 arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

Comments

Shawn Guo April 11, 2019, 2:42 a.m. UTC | #1 
On Fri, Mar 29, 2019 at 01:13:10PM -0500, Andrew F. Davis wrote:
> The correct DT property for specifying a GPIO used for reset
> is "reset-gpios", the driver now accepts this name, use it here.
> 
> Note the GPIO polarity in the driver was ignored before and always
> assumed to be active low, when all the DTs are fixed we will start
> respecting the specified polarity. Switch polarity in DT to the
> currently assumed one, this way when the driver changes the
> behavior will not change.
> 
> Signed-off-by: Andrew F. Davis <afd@ti.com>

I fixed up the prefix to use board name, and applied patch #1 ~ #3.

Shawn
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
index 69942c7ff89d..cbf7c9cae565 100644
--- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
@@ -384,7 +384,7 @@ 
 		AVDD-supply = <&reg_3p3v>;
 		IOVDD-supply = <&reg_3p3v>;
 		DVDD-supply = <&vgen4_reg>;
-		gpio-reset = <&gpio1 2 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&gpio1 2 GPIO_ACTIVE_LOW>;
 	};
 
 	accel@1c {
@@ -572,7 +572,7 @@ 
 		AVDD-supply = <&reg_3p3v>;
 		IOVDD-supply = <&reg_3p3v>;
 		DVDD-supply = <&vgen4_reg>;
-		gpio-reset = <&gpio1 0 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
 	};
 
 	touchscreen@20 {