| Message ID | 20190705150502.6600-5-ivan.khoronzhuk@linaro.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | net: ethernet: ti: cpsw: Add XDP support | expand |
diff --git a/drivers/net/ethernet/ti/cpsw_ethtool.c b/drivers/net/ethernet/ti/cpsw_ethtool.c index c477e6b620d6..e4d7185fde49 100644 --- a/drivers/net/ethernet/ti/cpsw_ethtool.c +++ b/drivers/net/ethernet/ti/cpsw_ethtool.c @@ -620,8 +620,7 @@ int cpsw_set_channels_common(struct net_device *ndev, } } - if (cpsw->usage_count) - cpsw_split_res(cpsw); + cpsw_split_res(cpsw); ret = cpsw_resume_data_pass(ndev); if (!ret)
That's possible to set channel num while interfaces are down. When interface gets up it should resplit budget. This resplit can happen after phy is up but only if speed is changed, so should be set before this, for this allow it to happen while changing number of channels, when interfaces are down. Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@linaro.org> --- drivers/net/ethernet/ti/cpsw_ethtool.c | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-)