@@ -208,30 +208,3 @@
pinctrl-1 = <&mmc2_pins_hs>;
pinctrl-2 = <&mmc2_pins_ddr_rev20 &mmc2_iodelay_ddr_conf>;
};
-
-&mac_sw {
- pinctrl-names = "default", "sleep";
- status = "okay";
-};
-
-&cpsw_port1 {
- phy-handle = <ðphy0_sw>;
- phy-mode = "rgmii-rxid";
- ti,dual-emac-pvid = <1>;
-};
-
-&cpsw_port2 {
- phy-handle = <ðphy1_sw>;
- phy-mode = "rgmii-rxid";
- ti,dual-emac-pvid = <2>;
-};
-
-&davinci_mdio_sw {
- ethphy0_sw: ethernet-phy@0 {
- reg = <0>;
- };
-
- ethphy1_sw: ethernet-phy@1 {
- reg = <1>;
- };
-};
@@ -27,8 +27,3 @@
pinctrl-1 = <&mmc2_pins_hs>;
pinctrl-2 = <&mmc2_pins_ddr_rev20>;
};
-
-&mac {
- status = "okay";
- dual_emac;
-};
@@ -36,11 +36,6 @@
pinctrl-2 = <&mmc2_pins_default>;
};
-&mac {
- status = "okay";
- dual_emac;
-};
-
&m_can0 {
status = "disabled";
};
@@ -448,19 +448,23 @@
ext-clk-src;
};
-&cpsw_emac0 {
+&mac_sw {
+ status = "okay";
+};
+
+&cpsw_port1 {
phy-handle = <ðphy0>;
phy-mode = "rgmii-rxid";
- dual_emac_res_vlan = <1>;
+ ti,dual-emac-pvid = <1>;
};
-&cpsw_emac1 {
+&cpsw_port2 {
phy-handle = <ðphy1>;
phy-mode = "rgmii-rxid";
- dual_emac_res_vlan = <2>;
+ ti,dual-emac-pvid = <2>;
};
-&davinci_mdio {
+&davinci_mdio_sw {
ethphy0: ethernet-phy@0 {
reg = <0>;
};
Switch all am571/2/4-idk boards to use new cpsw switch driver. Those boards have 2 Ext. port wired and configured in dual_mac mode by default. Hence, dual_mac mode has been preserved the same way between legacy and new driver it's safe to switch drivers. Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com> --- arch/arm/boot/dts/am571x-idk.dts | 27 ------------------------ arch/arm/boot/dts/am572x-idk.dts | 5 ----- arch/arm/boot/dts/am574x-idk.dts | 5 ----- arch/arm/boot/dts/am57xx-idk-common.dtsi | 14 +++++++----- 4 files changed, 9 insertions(+), 42 deletions(-)