| Message ID | 20200911123157.759379-1-aford173@gmail.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | [1/2] thermal: ti-soc-thermal: Enable addition power management | expand |
On Fri, Sep 11, 2020 at 7:32 AM Adam Ford <aford173@gmail.com> wrote: > > The bandgap sensor can be idled when the processor is too, but it > isn't currently being done, so the power consumption of OMAP3 > boards can elevated if the bangap sensor is enabled. > > This patch attempts to use some additional power management > to idle the clock to the bandgap when not needed. > > Signed-off-by: Adam Ford <aford173@gmail.com> > Reported-by: kernel test robot <lkp@intel.com> > Tested-by: Andreas Kemnade <andreas@kemnade.info> # GTA04 > --- > V3: bandgap_omap_cpu_notifier is only defined when CONFIG_PM_SLEEP > is enabled, so make all references to it also depend on > CONFIG_PM_SLEEP as well > Gentle nudge on this one. It was in the queue for a while, and got lost, then resurrected again. thanks adam > V2: Fix issue where variable stating the suspend mode isn't being > properly set and cleared. > > diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.c b/drivers/thermal/ti-soc-thermal/ti-bandgap.c > index ab19ceff6e2a..5e596168ba73 100644 > --- a/drivers/thermal/ti-soc-thermal/ti-bandgap.c > +++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.c > @@ -25,10 +25,20 @@ > #include <linux/of_platform.h> > #include <linux/of_irq.h> > #include <linux/io.h> > +#include <linux/cpu_pm.h> > +#include <linux/device.h> > +#include <linux/pm_runtime.h> > +#include <linux/pm.h> > +#include <linux/of.h> > +#include <linux/of_device.h> > > #include "ti-bandgap.h" > > static int ti_bandgap_force_single_read(struct ti_bandgap *bgp, int id); > +#ifdef CONFIG_PM_SLEEP > +static int bandgap_omap_cpu_notifier(struct notifier_block *nb, > + unsigned long cmd, void *v); > +#endif > > /*** Helper functions to access registers and their bitfields ***/ > > @@ -1008,6 +1018,11 @@ int ti_bandgap_probe(struct platform_device *pdev) > } > } > > +#ifdef CONFIG_PM_SLEEP > + bgp->nb.notifier_call = bandgap_omap_cpu_notifier; > + cpu_pm_register_notifier(&bgp->nb); > +#endif > + > return 0; > > remove_last_cooling: > @@ -1041,7 +1056,9 @@ int ti_bandgap_remove(struct platform_device *pdev) > struct ti_bandgap *bgp = platform_get_drvdata(pdev); > int i; > > - /* First thing is to remove sensor interfaces */ > + cpu_pm_unregister_notifier(&bgp->nb); > + > + /* Remove sensor interfaces */ > for (i = 0; i < bgp->conf->sensor_count; i++) { > if (bgp->conf->sensors[i].unregister_cooling) > bgp->conf->sensors[i].unregister_cooling(bgp, i); > @@ -1150,9 +1167,43 @@ static int ti_bandgap_suspend(struct device *dev) > if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) > clk_disable_unprepare(bgp->fclock); > > + bgp->is_suspended = true; > + > return err; > } > > +static int bandgap_omap_cpu_notifier(struct notifier_block *nb, > + unsigned long cmd, void *v) > +{ > + struct ti_bandgap *bgp; > + > + bgp = container_of(nb, struct ti_bandgap, nb); > + > + spin_lock(&bgp->lock); > + switch (cmd) { > + case CPU_CLUSTER_PM_ENTER: > + if (bgp->is_suspended) > + break; > + ti_bandgap_save_ctxt(bgp); > + ti_bandgap_power(bgp, false); > + if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) > + clk_disable(bgp->fclock); > + break; > + case CPU_CLUSTER_PM_ENTER_FAILED: > + case CPU_CLUSTER_PM_EXIT: > + if (bgp->is_suspended) > + break; > + if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) > + clk_enable(bgp->fclock); > + ti_bandgap_power(bgp, true); > + ti_bandgap_restore_ctxt(bgp); > + break; > + } > + spin_unlock(&bgp->lock); > + > + return NOTIFY_OK; > +} > + > static int ti_bandgap_resume(struct device *dev) > { > struct ti_bandgap *bgp = dev_get_drvdata(dev); > @@ -1161,6 +1212,7 @@ static int ti_bandgap_resume(struct device *dev) > clk_prepare_enable(bgp->fclock); > > ti_bandgap_power(bgp, true); > + bgp->is_suspended = false; > > return ti_bandgap_restore_ctxt(bgp); > } > diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.h b/drivers/thermal/ti-soc-thermal/ti-bandgap.h > index fce4657e9486..ed0ea4b17b25 100644 > --- a/drivers/thermal/ti-soc-thermal/ti-bandgap.h > +++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.h > @@ -12,6 +12,10 @@ > #include <linux/spinlock.h> > #include <linux/types.h> > #include <linux/err.h> > +#include <linux/cpu_pm.h> > +#include <linux/device.h> > +#include <linux/pm_runtime.h> > +#include <linux/pm.h> > > struct gpio_desc; > > @@ -203,6 +207,8 @@ struct ti_bandgap { > int irq; > struct gpio_desc *tshut_gpiod; > u32 clk_rate; > + struct notifier_block nb; > + unsigned int is_suspended:1; > }; > > /** > -- > 2.25.1 >
On 11/09/2020 14:31, Adam Ford wrote: > The bandgap sensor can be idled when the processor is too, but it > isn't currently being done, so the power consumption of OMAP3 > boards can elevated if the bangap sensor is enabled. > > This patch attempts to use some additional power management > to idle the clock to the bandgap when not needed. > > Signed-off-by: Adam Ford <aford173@gmail.com> > Reported-by: kernel test robot <lkp@intel.com> > Tested-by: Andreas Kemnade <andreas@kemnade.info> # GTA04 > --- [ ... ] > - /* First thing is to remove sensor interfaces */ > + cpu_pm_unregister_notifier(&bgp->nb); > + > + /* Remove sensor interfaces */ > for (i = 0; i < bgp->conf->sensor_count; i++) { > if (bgp->conf->sensors[i].unregister_cooling) > bgp->conf->sensors[i].unregister_cooling(bgp, i); > @@ -1150,9 +1167,43 @@ static int ti_bandgap_suspend(struct device *dev) > if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) > clk_disable_unprepare(bgp->fclock); > > + bgp->is_suspended = true; Is this flag really needed?
diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.c b/drivers/thermal/ti-soc-thermal/ti-bandgap.c index ab19ceff6e2a..5e596168ba73 100644 --- a/drivers/thermal/ti-soc-thermal/ti-bandgap.c +++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.c @@ -25,10 +25,20 @@ #include <linux/of_platform.h> #include <linux/of_irq.h> #include <linux/io.h> +#include <linux/cpu_pm.h> +#include <linux/device.h> +#include <linux/pm_runtime.h> +#include <linux/pm.h> +#include <linux/of.h> +#include <linux/of_device.h> #include "ti-bandgap.h" static int ti_bandgap_force_single_read(struct ti_bandgap *bgp, int id); +#ifdef CONFIG_PM_SLEEP +static int bandgap_omap_cpu_notifier(struct notifier_block *nb, + unsigned long cmd, void *v); +#endif /*** Helper functions to access registers and their bitfields ***/ @@ -1008,6 +1018,11 @@ int ti_bandgap_probe(struct platform_device *pdev) } } +#ifdef CONFIG_PM_SLEEP + bgp->nb.notifier_call = bandgap_omap_cpu_notifier; + cpu_pm_register_notifier(&bgp->nb); +#endif + return 0; remove_last_cooling: @@ -1041,7 +1056,9 @@ int ti_bandgap_remove(struct platform_device *pdev) struct ti_bandgap *bgp = platform_get_drvdata(pdev); int i; - /* First thing is to remove sensor interfaces */ + cpu_pm_unregister_notifier(&bgp->nb); + + /* Remove sensor interfaces */ for (i = 0; i < bgp->conf->sensor_count; i++) { if (bgp->conf->sensors[i].unregister_cooling) bgp->conf->sensors[i].unregister_cooling(bgp, i); @@ -1150,9 +1167,43 @@ static int ti_bandgap_suspend(struct device *dev) if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) clk_disable_unprepare(bgp->fclock); + bgp->is_suspended = true; + return err; } +static int bandgap_omap_cpu_notifier(struct notifier_block *nb, + unsigned long cmd, void *v) +{ + struct ti_bandgap *bgp; + + bgp = container_of(nb, struct ti_bandgap, nb); + + spin_lock(&bgp->lock); + switch (cmd) { + case CPU_CLUSTER_PM_ENTER: + if (bgp->is_suspended) + break; + ti_bandgap_save_ctxt(bgp); + ti_bandgap_power(bgp, false); + if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) + clk_disable(bgp->fclock); + break; + case CPU_CLUSTER_PM_ENTER_FAILED: + case CPU_CLUSTER_PM_EXIT: + if (bgp->is_suspended) + break; + if (TI_BANDGAP_HAS(bgp, CLK_CTRL)) + clk_enable(bgp->fclock); + ti_bandgap_power(bgp, true); + ti_bandgap_restore_ctxt(bgp); + break; + } + spin_unlock(&bgp->lock); + + return NOTIFY_OK; +} + static int ti_bandgap_resume(struct device *dev) { struct ti_bandgap *bgp = dev_get_drvdata(dev); @@ -1161,6 +1212,7 @@ static int ti_bandgap_resume(struct device *dev) clk_prepare_enable(bgp->fclock); ti_bandgap_power(bgp, true); + bgp->is_suspended = false; return ti_bandgap_restore_ctxt(bgp); } diff --git a/drivers/thermal/ti-soc-thermal/ti-bandgap.h b/drivers/thermal/ti-soc-thermal/ti-bandgap.h index fce4657e9486..ed0ea4b17b25 100644 --- a/drivers/thermal/ti-soc-thermal/ti-bandgap.h +++ b/drivers/thermal/ti-soc-thermal/ti-bandgap.h @@ -12,6 +12,10 @@ #include <linux/spinlock.h> #include <linux/types.h> #include <linux/err.h> +#include <linux/cpu_pm.h> +#include <linux/device.h> +#include <linux/pm_runtime.h> +#include <linux/pm.h> struct gpio_desc; @@ -203,6 +207,8 @@ struct ti_bandgap { int irq; struct gpio_desc *tshut_gpiod; u32 clk_rate; + struct notifier_block nb; + unsigned int is_suspended:1; }; /**