@@ -90,6 +90,7 @@ struct pinctrl_map;
* value on the line. Use argument 1 to indicate high level, argument 0 to
* indicate low level. (Please see Documentation/driver-api/pinctl.rst,
* section "GPIO mode pitfalls" for a discussion around this parameter.)
+ * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
* @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
* supplies, the argument to this parameter (on a custom format) tells
* the driver which alternative power source to use.
@@ -101,7 +102,6 @@ struct pinctrl_map;
* or latch delay (on outputs) this parameter (in a custom format)
* specifies the clock skew or latch delay. It typically controls how
* many double inverters are put in front of the line.
- * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
* @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
* you need to pass in custom configurations to the pin controller, use
* PIN_CONFIG_END+1 as the base offset.
@@ -127,11 +127,11 @@ enum pin_config_param {
PIN_CONFIG_LOW_POWER_MODE,
PIN_CONFIG_OUTPUT_ENABLE,
PIN_CONFIG_OUTPUT,
+ PIN_CONFIG_PERSIST_STATE,
PIN_CONFIG_POWER_SOURCE,
PIN_CONFIG_SLEEP_HARDWARE_STATE,
PIN_CONFIG_SLEW_RATE,
PIN_CONFIG_SKEW_DELAY,
- PIN_CONFIG_PERSIST_STATE,
PIN_CONFIG_END = 0x7F,
PIN_CONFIG_MAX = 0xFF,
};
It seems the ordering is by name. Keep it that way. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- include/linux/pinctrl/pinconf-generic.h | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)