@@ -313,6 +313,23 @@ static void pcs_pin_dbg_show(struct pinctrl_dev *pctldev,
seq_printf(s, "%zx %08x %s ", pa, val, DRIVER_NAME);
}
+static int pcs_pin_dbg_set(struct pinctrl_dev *pctldev, unsigned int pin,
+ char *buf)
+{
+ struct pcs_device *pcs;
+ unsigned int val, mux_bytes;
+
+ buf = skip_spaces(buf);
+ if (kstrtouint(buf, 0, &val))
+ return -EINVAL;
+
+ pcs = pinctrl_dev_get_drvdata(pctldev);
+
+ mux_bytes = pcs->width / BITS_PER_BYTE;
+ pcs->write(val, pcs->base + pin * mux_bytes);
+ return 0;
+}
+
static void pcs_dt_free_map(struct pinctrl_dev *pctldev,
struct pinctrl_map *map, unsigned num_maps)
{
@@ -331,6 +348,9 @@ static const struct pinctrl_ops pcs_pinctrl_ops = {
.get_group_name = pinctrl_generic_get_group_name,
.get_group_pins = pinctrl_generic_get_group_pins,
.pin_dbg_show = pcs_pin_dbg_show,
+#if IS_ENABLED(CONFIG_DEVMEM) && IS_ENABLED(CONFIG_SOC_AM33XX)
+ .pin_dbg_set = pcs_pin_dbg_set,
+#endif
.dt_node_to_map = pcs_dt_node_to_map,
.dt_free_map = pcs_dt_free_map,
};
As described in section 9.1 of the TI reference manual for AM335x [1], "For writing to the control module registers, the MPU will need to be in privileged mode of operation and writes will not work from user mode". By adding the pin_dbg_set helper to pcs_pinctrl_ops it will be possible to write these registers from the pins debug: cd /sys/kernel/debug/pinctrl/44e10800.pinmux-pinctrl-single/ echo <pin-number> <reg-value> >pins [1] https://www.ti.com/lit/ug/spruh73q/spruh73q.pdf Signed-off-by: Dario Binacchi <dariobin@libero.it> --- drivers/pinctrl/pinctrl-single.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)