@@ -8,6 +8,8 @@
/include/ "skeleton.dtsi"
#include <dt-bindings/interrupt-controller/arm-gic.h>
+#include <dt-bindings/clock/oxsemi,ox820.h>
+#include <dt-bindings/reset/oxsemi,ox820.h>
/ {
compatible = "oxsemi,ox820";
@@ -83,8 +85,8 @@
nandc: nand-controller@41000000 {
compatible = "oxsemi,ox820-nand";
reg = <0x41000000 0x100000>;
- clocks = <&stdclk 11>;
- resets = <&reset 15>;
+ clocks = <&stdclk CLK_820_NAND>;
+ resets = <&reset RESET_NAND>;
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
@@ -99,9 +101,9 @@
mac-address = [000000000000]; /* Filled in by U-Boot */
phy-mode = "rgmii";
- clocks = <&stdclk 9>, <&gmacclk>;
+ clocks = <&stdclk CLK_820_ETHA>, <&gmacclk>;
clock-names = "gmac", "stmmaceth";
- resets = <&reset 6>;
+ resets = <&reset RESET_MAC>;
/* Regmap for sys registers */
oxsemi,sys-ctrl = <&sys>;
@@ -208,7 +210,7 @@
no-loopback-test;
status = "disabled";
clocks = <&sysclk>;
- resets = <&reset 17>;
+ resets = <&reset RESET_UART1>;
};
uart1: serial@300000 {
@@ -222,7 +224,7 @@
no-loopback-test;
status = "disabled";
clocks = <&sysclk>;
- resets = <&reset 18>;
+ resets = <&reset RESET_UART2>;
};
rps@400000 {
Add OX820 dt-bindings includes files for clocks and resets, replace resets numbers by human readable defines. Signed-off-by: Neil Armstrong <narmstrong@baylibre.com> --- arch/arm/boot/dts/ox820.dtsi | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-)