[v7,0/3] vfio/pci: s390: Fix issues preventing VFIO_PCI_MMAP=y for s390 and enable it

Message

Niklas Schnelle Feb. 26, 2025, 12:07 p.m. UTC

With the introduction of memory I/O (MIO) instructions enbaled in commit
71ba41c9b1d9 ("s390/pci: provide support for MIO instructions") s390
gained support for direct user-space access to mapped PCI resources.
Even without those however user-space can access mapped PCI resources
via the s390 specific MMIO syscalls. There is thus nothing fundamentally
preventing s390 from supporting VFIO_PCI_MMAP, allowing user-space
drivers to access PCI resources without going through the pread()
interface. To actually enable VFIO_PCI_MMAP a few issues need fixing
however.

Firstly the s390 MMIO syscalls do not cause a page fault when
follow_pte() fails due to the page not being present. This breaks
vfio-pci's mmap() handling which lazily maps on first access.

Secondly on s390 there is a virtual PCI device called ISM which has
a few oddities. For one it claims to have a 256 TiB PCI BAR (not a typo)
which leads to any attempt to mmap() it fail with the following message:

    vmap allocation for size 281474976714752 failed: use vmalloc=<size> to increase size

Even if one tried to map this BAR only partially the mapping would not
be usable on systems with MIO support enabled. So just block mapping
BARs which don't fit between IOREMAP_START and IOREMAP_END. Solve this
by keeping the vfio-pci mmap() blocking behavior around for this
specific device via a PCI quirk and new pdev->non_mappable_bars
flag.

As noted by Alex Williamson With mmap() enabled in vfio-pci it makes
sense to also enable HAVE_PCI_MMAP with the same restriction for pdev->
non_mappable_bars. So this is added in patch 3 and I tested this with
another small test program.

Note:
For your convenience the code is also available in the tagged
b4/vfio_pci_mmap branch on my git.kernel.org site below:
https://git.kernel.org/pub/scm/linux/kernel/git/niks/linux.git/

Thanks,
Niklas

Link: https://lore.kernel.org/all/[e-mail]/
Signed-off-by: Niklas Schnelle <[e-mail]>
---
Changes in v7:
- Move all s390 changes, except for a one-lineer to set pdev->
  non_mappable_bars for all devices, to the third patch (Bjorn)
- Move checks in pci-sysfs.c and proc.c to the second patch (Bjorn)
- Only set ARCH_GENERIC_PCI_MMAP_RESOURCES not HAVE_PCI_MMAP following
  the recommendation for new architectures in
  Documentation/PCI/sysfs-pci.rst. This only enables the sysfs but not
  the proc interface.
- Link to v6: https://lore.kernel.org/r/[e-mail]

Changes in v6:
- Add a patch to also enable PCI resource mmap() via sysfs and proc
  exlcluding pdev->non_mappable_bars devices (Alex Williamson)
- Added Acks
- Link to v5: https://lore.kernel.org/r/[e-mail]

Changes in v5:
- Instead of relying on the existing pdev->non_compliant_bars introduce
  a new pdev->non_mappable_bars flag. This replaces the VFIO_PCI_MMAP
  Kconfig option and makes it per-device. This is necessary to not break
  upcoming vfio-pci use of ISM devices (Julian Ruess)
- Squash the removal of VFIO_PCI_MMAP into the second commit as this
  is now where its only use goes away.
- Switch to using follow_pfnmap_start() in MMIO syscall page fault
  handling to match upstream changes
- Dropped R-b's because the changes are significant
- Link to v4: https://lore.kernel.org/r/[e-mail]

Changes in v4:
- Overhauled and split up patch 2 which caused errors on ppc due to
  unexported __kernel_io_end. Replaced it with a minimal s390 PCI fixup
  harness to set pdev->non_compliant_bars for ISM plus ignoring devices
  with this flag in vfio-pci. Idea for using PCI quirks came from
  Christoph Hellwig, thanks. Dropped R-bs for patch 2 accordingly.
- Rebased on v6.10-rc5 which includes the vfio-pci mmap fault handler
  fix to the issue I stumbled over independently in v3
- Link to v3: https://lore.kernel.org/r/[e-mail]

Changes in v3:
- Rebased on v6.10-rc1 requiring change to follow_pte() call
- Use current->mm for fixup_user_fault() as seems more common
- Collected new trailers
- Link to v2: https://lore.kernel.org/r/[e-mail]

Changes in v2:
- Changed last patch to remove VFIO_PCI_MMAP instead of just enabling it
  for s390 as it is unconditionally true with s390 supporting PCI resource mmap() (Jason)
- Collected R-bs from Jason
- Link to v1: https://lore.kernel.org/r/[e-mail]

---
Niklas Schnelle (3):
      s390/pci: Fix s390_mmio_read/write syscall page fault handling
      PCI: s390: Introduce pdev->non_mappable_bars and replace VFIO_PCI_MMAP
      PCI: s390: Support mmap() of PCI resources except for ISM devices

 arch/s390/Kconfig                |  4 +---
 arch/s390/include/asm/pci.h      |  3 +++
 arch/s390/pci/Makefile           |  2 +-
 arch/s390/pci/pci_fixup.c        | 23 +++++++++++++++++++++++
 arch/s390/pci/pci_mmio.c         | 18 +++++++++++++-----
 drivers/pci/pci-sysfs.c          |  4 ++++
 drivers/pci/proc.c               |  4 ++++
 drivers/s390/net/ism_drv.c       |  1 -
 drivers/vfio/pci/Kconfig         |  4 ----
 drivers/vfio/pci/vfio_pci_core.c |  2 +-
 include/linux/pci.h              |  1 +
 include/linux/pci_ids.h          |  1 +
 12 files changed, 52 insertions(+), 15 deletions(-)
---
base-commit: d082ecbc71e9e0bf49883ee4afd435a77a5101b6
change-id: 20240503-vfio_pci_mmap-1549e3d02ca7

Best regards,