diff mbox

[-v3,1/7] PCI: rework pci_enable_ari to support disable ari forwarding

Message ID 1358219542-16880-2-git-send-email-wangyijing@huawei.com (mailing list archive)
State New, archived
Delegated to: Bjorn Helgaas
Headers show

Commit Message

Yijing Wang Jan. 15, 2013, 3:12 a.m. UTC 
pci_enable_ari will set the pci bridge ARI Forwarding Enable bit in Device
Control 2 Register when a ARI pcie device connected found. But the bridge ARI
Forwarding Enable bit will never be cleared when the ARI device hot removed.

As PCIe Spec 2.0(6.13/441) recommends:
"Following a hot-plug event below a Downstream Port, it is strongly recommended
that software Clear the ARI Forwarding Enable bit in the Downstream Port until
software determines that a newly added component is in fact an ARI Device"

This patch rework pci_enable_ari to support disable ARI Forwarding whenever found
the new pci device is a non-ari device.

Signed-off-by: Yijing Wang <wangyijing@huawei.com>
Signed-off-by: Jiang Liu <jiang.liu@huawei.com>
---
 drivers/pci/pci.c |   16 ++++++++++------
 1 files changed, 10 insertions(+), 6 deletions(-)
diff mbox

Patch

diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index 5cb5820..a17129f 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -2078,9 +2078,6 @@  void pci_enable_ari(struct pci_dev *dev)
 	if (pcie_ari_disabled || !pci_is_pcie(dev) || dev->devfn)
 		return;
 
-	if (!pci_find_ext_capability(dev, PCI_EXT_CAP_ID_ARI))
-		return;
-
 	bridge = dev->bus->self;
 	if (!bridge)
 		return;
@@ -2088,9 +2085,16 @@  void pci_enable_ari(struct pci_dev *dev)
 	pcie_capability_read_dword(bridge, PCI_EXP_DEVCAP2, &cap);
 	if (!(cap & PCI_EXP_DEVCAP2_ARI))
 		return;
-
-	pcie_capability_set_word(bridge, PCI_EXP_DEVCTL2, PCI_EXP_DEVCTL2_ARI);
-	bridge->ari_enabled = 1;
+
+	if (pci_find_ext_capability(dev, PCI_EXT_CAP_ID_ARI)) {
+		pcie_capability_set_word(bridge, PCI_EXP_DEVCTL2,
+				PCI_EXP_DEVCTL2_ARI);
+		bridge->ari_enabled = 1;
+	} else {
+		pcie_capability_clear_word(bridge, PCI_EXP_DEVCTL2,
+				PCI_EXP_DEVCTL2_ARI);
+		bridge->ari_enabled = 0;
+	}
 }
 
 /**