diff mbox

[v4,1/2] PCI: iproc: Retry request when CRS returned from EP

Message ID 1499224139-10746-2-git-send-email-oza.oza@broadcom.com (mailing list archive)
State New, archived
Delegated to: Bjorn Helgaas
Headers show

Commit Message

Oza Pawandeep July 5, 2017, 3:08 a.m. UTC
For Configuration Requests only, following reset it is possible for a
device to terminate the request but indicate that it is temporarily unable
to process the Request, but will be able to process the Request in the
future – in this case, the Configuration Request Retry Status 100 (CRS)
Completion Status is used.

As per PCI spec, CRS Software Visibility only affects config read of the
Vendor ID, for config write or any other config read the Root must
automatically re-issue configuration request again as a new request.
Iproc based PCIe RC (hw) does not retry request on its own.

As a result of the fact, PCIe RC driver (sw) should take care of CRS.
This patch fixes the problem, and attempts to read config space again in
case of PCIe code forwarding the CRS back to CPU.
It implements iproc_pcie_config_read which gets called for Stingray,
Otherwise it falls back to PCI generic APIs.

Signed-off-by: Oza Pawandeep <oza.oza@broadcom.com>
Reviewed-by: Ray Jui <ray.jui@broadcom.com>
Reviewed-by: Scott Branden <scott.branden@broadcom.com>
diff mbox

Patch

diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
index 0f39bd2..b0abcd7 100644
--- a/drivers/pci/host/pcie-iproc.c
+++ b/drivers/pci/host/pcie-iproc.c
@@ -68,6 +68,9 @@ 
 #define APB_ERR_EN_SHIFT             0
 #define APB_ERR_EN                   BIT(APB_ERR_EN_SHIFT)
 
+#define CFG_RETRY_STATUS             0xffff0001
+#define CFG_RETRY_STATUS_TIMEOUT_US  500000 /* 500 milli-seconds. */
+
 /* derive the enum index of the outbound/inbound mapping registers */
 #define MAP_REG(base_reg, index)      ((base_reg) + (index) * 2)
 
@@ -448,6 +451,55 @@  static inline void iproc_pcie_apb_err_disable(struct pci_bus *bus,
 	}
 }
 
+static int iproc_pcie_cfg_retry(void __iomem *cfg_data_p)
+{
+	int timeout = CFG_RETRY_STATUS_TIMEOUT_US;
+	unsigned int ret;
+
+	/*
+	 * As per PCI spec, CRS Software Visibility only
+	 * affects config read of the Vendor ID.
+	 * For config write or any other config read the Root must
+	 * automatically re-issue configuration request again as a
+	 * new request. Iproc based PCIe RC (hw) does not retry
+	 * request on its own, so handle it here.
+	 */
+	do {
+		ret = readl(cfg_data_p);
+		if (ret == CFG_RETRY_STATUS)
+			udelay(1);
+		else
+			return PCIBIOS_SUCCESSFUL;
+	} while (timeout--);
+
+	return PCIBIOS_DEVICE_NOT_FOUND;
+}
+
+static void __iomem *iproc_pcie_map_ep_cfg_reg(struct iproc_pcie *pcie,
+					       unsigned int busno,
+					       unsigned int slot,
+					       unsigned int fn,
+					       int where)
+{
+	u16 offset;
+	u32 val;
+
+	/* EP device access */
+	val = (busno << CFG_ADDR_BUS_NUM_SHIFT) |
+		(slot << CFG_ADDR_DEV_NUM_SHIFT) |
+		(fn << CFG_ADDR_FUNC_NUM_SHIFT) |
+		(where & CFG_ADDR_REG_NUM_MASK) |
+		(1 & CFG_ADDR_CFG_TYPE_MASK);
+
+	iproc_pcie_write_reg(pcie, IPROC_PCIE_CFG_ADDR, val);
+	offset = iproc_pcie_reg_offset(pcie, IPROC_PCIE_CFG_DATA);
+
+	if (iproc_pcie_reg_is_invalid(offset))
+		return NULL;
+
+	return (pcie->base + offset);
+}
+
 /**
  * Note access to the configuration registers are protected at the higher layer
  * by 'pci_lock' in drivers/pci/access.c
@@ -499,13 +551,48 @@  static void __iomem *iproc_pcie_map_cfg_bus(struct pci_bus *bus,
 		return (pcie->base + offset);
 }
 
+static int iproc_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
+				    int where, int size, u32 *val)
+{
+	struct iproc_pcie *pcie = iproc_data(bus);
+	unsigned int slot = PCI_SLOT(devfn);
+	unsigned int fn = PCI_FUNC(devfn);
+	unsigned int busno = bus->number;
+	void __iomem *cfg_data_p;
+	int ret;
+
+	/* root complex access. */
+	if (busno == 0)
+		return pci_generic_config_read32(bus, devfn, where, size, val);
+
+	cfg_data_p = iproc_pcie_map_ep_cfg_reg(pcie, busno, slot, fn, where);
+
+	if (!cfg_data_p)
+		return PCIBIOS_DEVICE_NOT_FOUND;
+
+	ret = iproc_pcie_cfg_retry(cfg_data_p);
+	if (ret)
+		return ret;
+
+	*val = readl(cfg_data_p);
+
+	if (size <= 2)
+		*val = (*val >> (8 * (where & 3))) & ((1 << (size * 8)) - 1);
+
+	return PCIBIOS_SUCCESSFUL;
+}
+
 static int iproc_pcie_config_read32(struct pci_bus *bus, unsigned int devfn,
 				    int where, int size, u32 *val)
 {
 	int ret;
+	struct iproc_pcie *pcie = iproc_data(bus);
 
 	iproc_pcie_apb_err_disable(bus, true);
-	ret = pci_generic_config_read32(bus, devfn, where, size, val);
+	if (pcie->type == IPROC_PCIE_PAXB_V2)
+		ret = iproc_pcie_config_read(bus, devfn, where, size, val);
+	else
+		ret = pci_generic_config_read32(bus, devfn, where, size, val);
 	iproc_pcie_apb_err_disable(bus, false);
 
 	return ret;