@@ -60,6 +60,10 @@
#define APB_ERR_EN_SHIFT 0
#define APB_ERR_EN BIT(APB_ERR_EN_SHIFT)
+#define CFG_RD_SUCCESS 0
+#define CFG_RD_UR 1
+#define CFG_RD_CRS 2
+#define CFG_RD_CA 3
#define CFG_RETRY_STATUS 0xffff0001
#define CFG_RETRY_STATUS_TIMEOUT_US 500000 /* 500 milliseconds */
@@ -289,6 +293,9 @@ enum iproc_pcie_reg {
IPROC_PCIE_IARR4,
IPROC_PCIE_IMAP4,
+ /* config read status */
+ IPROC_PCIE_CFG_RD_STATUS,
+
/* link status */
IPROC_PCIE_LINK_STATUS,
@@ -350,6 +357,7 @@ static const u16 iproc_pcie_reg_paxb_v2[] = {
[IPROC_PCIE_IMAP3] = 0xe08,
[IPROC_PCIE_IARR4] = 0xe68,
[IPROC_PCIE_IMAP4] = 0xe70,
+ [IPROC_PCIE_CFG_RD_STATUS] = 0xee0,
[IPROC_PCIE_LINK_STATUS] = 0xf0c,
[IPROC_PCIE_APB_ERR_EN] = 0xf40,
};
@@ -474,10 +482,12 @@ static void __iomem *iproc_pcie_map_ep_cfg_reg(struct iproc_pcie *pcie,
return (pcie->base + offset);
}
-static unsigned int iproc_pcie_cfg_retry(void __iomem *cfg_data_p)
+static unsigned int iproc_pcie_cfg_retry(struct iproc_pcie *pcie,
+ void __iomem *cfg_data_p)
{
int timeout = CFG_RETRY_STATUS_TIMEOUT_US;
unsigned int data;
+ u32 status;
/*
* As per PCIe spec r3.1, sec 2.3.2, CRS Software Visibility only
@@ -498,6 +508,15 @@ static unsigned int iproc_pcie_cfg_retry(void __iomem *cfg_data_p)
*/
data = readl(cfg_data_p);
while (data == CFG_RETRY_STATUS && timeout--) {
+ /*
+ * CRS state is set in CFG_RD status register
+ * This will handle the case where CFG_RETRY_STATUS is
+ * valid config data.
+ */
+ status = iproc_pcie_read_reg(pcie, IPROC_PCIE_CFG_RD_STATUS);
+ if (status != CFG_RD_CRS)
+ return data;
+
udelay(1);
data = readl(cfg_data_p);
}
@@ -576,7 +595,7 @@ static int iproc_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
if (!cfg_data_p)
return PCIBIOS_DEVICE_NOT_FOUND;
- data = iproc_pcie_cfg_retry(cfg_data_p);
+ data = iproc_pcie_cfg_retry(pcie, cfg_data_p);
*val = data;
if (size <= 2)
In the current implementation, config read output data 0xffff0001 is assumed as CRS completion. But sometimes 0xffff0001 can be a valid data. IPROC PCIe host controller PAXB v2 has a register to show config read status flags like SC, UR, CRS and CA. So that extra check is added to confirm the CRS using status flags before reissue config read. Signed-off-by: Srinath Mannam <srinath.mannam@broadcom.com> --- drivers/pci/controller/pcie-iproc.c | 23 +++++++++++++++++++++-- 1 file changed, 21 insertions(+), 2 deletions(-)