diff mbox series

[v9,17/26] PCI: hotplug: Don't disable the released bridge windows immediately

Message ID 20201218174011.340514-18-s.miroshnichenko@yadro.com (mailing list archive)
State New, archived
Delegated to: Bjorn Helgaas
Headers show
Series PCI: Allow BAR movement during boot and hotplug | expand

Commit Message

Sergei Miroshnichenko Dec. 18, 2020, 5:40 p.m. UTC 
On a hotplug event with enabled BAR movement, calculating new BAR layout
and bridge windows takes some time. During this procedure, the structures
representing these windows are released: marked for a recalculation.

When the new bridge window values are ready, they are written to the bridge
registers via pci_setup_bridges().

Currently, bridge's registers are updated immediately after releasing a
window to disable it. But if a driver doesn't yet support movable BARs, it
doesn't stop MEM transactions during the hotplug, so disabled bridge
windows will break them.

Let the bridge windows remain operating after releasing, as they will be
updated to the new values in the end of a hotplug event.

Signed-off-by: Sergei Miroshnichenko <s.miroshnichenko@yadro.com>
---
 drivers/pci/setup-bus.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/pci/setup-bus.c b/drivers/pci/setup-bus.c
index ab58b999ac6d..f98772474421 100644
--- a/drivers/pci/setup-bus.c
+++ b/drivers/pci/setup-bus.c
@@ -1649,7 +1649,8 @@  static void pci_bridge_release_resources(struct pci_bus *bus,
 		/* Avoiding touch the one without PREF */
 		if (type & IORESOURCE_PREFETCH)
 			type = IORESOURCE_PREFETCH;
-		__pci_setup_bridge(bus, type);
+		if (!pci_can_move_bars)
+			__pci_setup_bridge(bus, type);
 		/* For next child res under same bridge */
 		r->flags = old_flags;
 	}