@@ -140,7 +140,11 @@
#define APPL_DEBUG_PM_LINKST_IN_L0 0x11
#define APPL_DEBUG_LTSSM_STATE_MASK GENMASK(8, 3)
#define APPL_DEBUG_LTSSM_STATE_SHIFT 3
-#define LTSSM_STATE_PRE_DETECT 5
+#define LTSSM_STATE_DETECT_QUIET 0x00
+#define LTSSM_STATE_DETECT_ACT 0x08
+#define LTSSM_STATE_PRE_DETECT_QUIET 0x28
+#define LTSSM_STATE_DETECT_WAIT 0x30
+#define LTSSM_STATE_L2_IDLE 0xa8
#define APPL_RADM_STATUS 0xE4
#define APPL_PM_XMT_TURNOFF_STATE BIT(0)
@@ -209,7 +213,8 @@
#define PME_ACK_DELAY 100 /* 100 us */
#define PME_ACK_TIMEOUT 10000 /* 10 ms */
-#define LTSSM_TIMEOUT 50000 /* 50ms */
+#define LTSSM_DELAY 10000 /* 10 ms */
+#define LTSSM_TIMEOUT 120000 /* 120 ms */
#define GEN3_GEN4_EQ_PRESET_INIT 5
@@ -1606,23 +1611,31 @@ static void tegra_pcie_dw_pme_turnoff(struct tegra_pcie_dw *pcie)
data &= ~APPL_PINMUX_PEX_RST;
appl_writel(pcie, data, APPL_PINMUX);
- /*
- * Some cards do not go to detect state even after de-asserting
- * PERST#. So, de-assert LTSSM to bring link to detect state.
- */
- data = readl(pcie->appl_base + APPL_CTRL);
- data &= ~APPL_CTRL_LTSSM_EN;
- writel(data, pcie->appl_base + APPL_CTRL);
-
err = readl_poll_timeout_atomic(pcie->appl_base + APPL_DEBUG,
data,
((data &
- APPL_DEBUG_LTSSM_STATE_MASK) >>
- APPL_DEBUG_LTSSM_STATE_SHIFT) ==
- LTSSM_STATE_PRE_DETECT,
- 1, LTSSM_TIMEOUT);
+ APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_QUIET) ||
+ ((data &
+ APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_ACT) ||
+ ((data &
+ APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_PRE_DETECT_QUIET) ||
+ ((data &
+ APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_WAIT),
+ LTSSM_DELAY, LTSSM_TIMEOUT);
if (err)
dev_info(pcie->dev, "Link didn't go to detect state\n");
+
+ /*
+ * Deassert LTSSM state to stop the state toggling between
+ * polling and detect.
+ */
+ data = readl(pcie->appl_base + APPL_CTRL);
+ data &= ~APPL_CTRL_LTSSM_EN;
+ writel(data, pcie->appl_base + APPL_CTRL);
}
/*
* DBI registers may not be accessible after this as PLL-E would be
@@ -1698,19 +1711,29 @@ static void pex_ep_event_pex_rst_assert(struct tegra_pcie_dw *pcie)
if (pcie->ep_state == EP_STATE_DISABLED)
return;
- /* Disable LTSSM */
+ ret = readl_poll_timeout(pcie->appl_base + APPL_DEBUG, val,
+ ((val & APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_QUIET) ||
+ ((val & APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_ACT) ||
+ ((val & APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_PRE_DETECT_QUIET) ||
+ ((val & APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_DETECT_WAIT) ||
+ ((val & APPL_DEBUG_LTSSM_STATE_MASK) ==
+ LTSSM_STATE_L2_IDLE),
+ LTSSM_DELAY, LTSSM_TIMEOUT);
+ if (ret)
+ dev_err(pcie->dev, "LTSSM state: 0x%x timeout: %d\n", val, ret);
+
+ /*
+ * Deassert LTSSM state to stop the state toggling between
+ * polling and detect.
+ */
val = appl_readl(pcie, APPL_CTRL);
val &= ~APPL_CTRL_LTSSM_EN;
appl_writel(pcie, val, APPL_CTRL);
- ret = readl_poll_timeout(pcie->appl_base + APPL_DEBUG, val,
- ((val & APPL_DEBUG_LTSSM_STATE_MASK) >>
- APPL_DEBUG_LTSSM_STATE_SHIFT) ==
- LTSSM_STATE_PRE_DETECT,
- 1, LTSSM_TIMEOUT);
- if (ret)
- dev_err(pcie->dev, "Failed to go Detect state: %d\n", ret);
-
reset_control_assert(pcie->core_rst);
tegra_pcie_disable_phy(pcie);
On surprise down LTSSM state transisition from L0 -> Recovery.RcvrLock -> Recovery.RcvrSpeed -> Gen1 Recovery.RcvrLock -> Detect. Recovery.RcvrLock and Recovery.RcvrSpeed time is 24 msec and 48 msec respectively. It takes ~96 msec to move from L0 to detect state, hence, increase the poll time to 120 msec. Disable the LTSSM state after it moves to detect to avoid LTSSM toggle between polling and detect. Signed-off-by: Vidya Sagar <vidyas@nvidia.com> --- drivers/pci/controller/dwc/pcie-tegra194.c | 69 ++++++++++++++-------- 1 file changed, 46 insertions(+), 23 deletions(-)