@@ -2675,8 +2675,11 @@ static void rtl_disable_exit_l1(struct rtl8169_private *tp)
static void rtl_hw_aspm_clkreq_enable(struct rtl8169_private *tp, bool enable)
{
- /* Don't enable ASPM in the chip if OS can't control ASPM */
- if (enable && tp->aspm_manageable) {
+ /* Skip if PCIe ASPM isn't possible */
+ if (!tp->aspm_manageable)
+ return;
+
+ if (enable) {
RTL_W8(tp, Config5, RTL_R8(tp, Config5) | ASPM_en);
RTL_W8(tp, Config2, RTL_R8(tp, Config2) | ClkReqEn);
@@ -4545,8 +4548,13 @@ static void rtl_task(struct work_struct *work)
/* ASPM compatibility issues are a typical reason for tx timeouts */
ret = pci_disable_link_state(tp->pci_dev, PCIE_LINK_STATE_L1 |
PCIE_LINK_STATE_L0S);
+
+ /* OS may not be granted to control PCIe ASPM, prevent the driver from using it */
+ tp->aspm_manageable = 0;
+
if (!ret)
netdev_warn_once(tp->dev, "ASPM disabled on Tx timeout\n");
+
goto reset;
}
@@ -5227,13 +5235,19 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
* Chips from RTL8168h partially have issues with L1.1 and L1.2, but
* seem to work fine with L1.
*/
- if (rtl_aspm_is_safe(tp))
+ if (!pcie_aspm_support_enabled() || !pcie_aspm_capable(pdev))
+ rc = -EINVAL;
+ else if (rtl_aspm_is_safe(tp))
rc = 0;
else if (tp->mac_version >= RTL_GIGA_MAC_VER_46)
rc = pci_disable_link_state(pdev, PCIE_LINK_STATE_L1_1 | PCIE_LINK_STATE_L1_2);
else
rc = pci_disable_link_state(pdev, PCIE_LINK_STATE_L1);
- tp->aspm_manageable = !rc;
+
+ /* -EPERM means BIOS doesn't grant OS ASPM control, ASPM should be use
+ * as is. Honor it.
+ */
+ tp->aspm_manageable = (rc == -EPERM) ? 1 : !rc;
tp->dash_type = rtl_check_dash(tp);
To really enable ASPM on r8169 NICs, both standard PCIe ASPM and chip-specific ASPM have to be enabled at the same time. Before enabling ASPM at chip side, make sure the following conditions are met: 1) Use pcie_aspm_support_enabled() to check if ASPM is disabled by kernel parameter. 2) Use pcie_aspm_capable() to see if the device is capable to perform PCIe ASPM. 3) Check the return value of pci_disable_link_state(). If it's -EPERM, it means BIOS doesn't grant ASPM control to OS, and device should use the ASPM setting as is Consider ASPM is manageable when those conditions are met. While at it, disable ASPM at chip-side for TX timeout reset, since pci_disable_link_state() doesn't have any effect when OS isn't granted with ASPM control. Signed-off-by: Kai-Heng Feng <kai.heng.feng@canonical.com> --- v8: - Enable chip-side ASPM only when PCIe ASPM is already available. - Wording. v7: - No change. v6: - Unconditionally enable chip-specific ASPM. v5: - New patch. drivers/net/ethernet/realtek/r8169_main.c | 22 ++++++++++++++++++---- 1 file changed, 18 insertions(+), 4 deletions(-)