| Message ID | 20220213130524.18748-3-hdegoede@redhat.com |
|---|---|
| State | Not Applicable |
| Headers | show |
| Series | usb/dwc3 / phy/tusb1210: Add TUSB1211 charger detection | expand |
diff --git a/drivers/usb/dwc3/dwc3-pci.c b/drivers/usb/dwc3/dwc3-pci.c index 022341aef400..1ecedbb1684c 100644 --- a/drivers/usb/dwc3/dwc3-pci.c +++ b/drivers/usb/dwc3/dwc3-pci.c @@ -85,8 +85,8 @@ static const struct acpi_gpio_mapping acpi_dwc3_byt_gpios[] = { static struct gpiod_lookup_table platform_bytcr_gpios = { .dev_id = "0000:00:16.0", .table = { - GPIO_LOOKUP("INT33FC:00", 54, "reset", GPIO_ACTIVE_HIGH), - GPIO_LOOKUP("INT33FC:02", 14, "cs", GPIO_ACTIVE_HIGH), + GPIO_LOOKUP("INT33FC:00", 54, "cs", GPIO_ACTIVE_HIGH), + GPIO_LOOKUP("INT33FC:02", 14, "reset", GPIO_ACTIVE_HIGH), {} }, };
When the Bay Trail phy GPIO mappings where added cs and reset were swapped, this did not cause any issues sofar, because sofar they were always driven high/low at the same time. Note the new mapping has been verified both in /sys/kernel/debug/gpio output on Android factory images on multiple devices, as well as in the schematics for some devices. Fixes: 5741022cbdf3 ("usb: dwc3: pci: Add GPIO lookup table on platforms without ACPI GPIO resources") Signed-off-by: Hans de Goede <hdegoede@redhat.com> --- drivers/usb/dwc3/dwc3-pci.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)