@@ -10,6 +10,7 @@
* published by the Free Software Foundation.
*
*/
+#include <linux/interrupt.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_gpio.h>
@@ -75,7 +76,12 @@ static const char *act8945a_charger_manufacturer = "Active-semi";
#define APCH_STATE_CSTATE_PRE 0x03
struct act8945a_charger {
+ struct power_supply *psy;
struct regmap *regmap;
+ struct work_struct work;
+
+ bool init_done;
+ int irq_pin;
};
static int act8945a_get_charger_state(struct regmap *regmap, int *val)
@@ -252,6 +258,47 @@ static const struct power_supply_desc act8945a_charger_desc = {
.num_properties = ARRAY_SIZE(act8945a_charger_props),
};
+static int act8945a_enable_interrupt(struct act8945a_charger *charger)
+{
+ struct regmap *regmap = charger->regmap;
+ unsigned char ctrl;
+ int ret;
+
+ ctrl = APCH_CTRL_CHGEOCOUT | APCH_CTRL_CHGEOCIN |
+ APCH_CTRL_INDIS | APCH_CTRL_INCON |
+ APCH_CTRL_TEMPOUT | APCH_CTRL_TEMPIN |
+ APCH_CTRL_TIMRPRE | APCH_CTRL_TIMRTOT;
+ ret = regmap_write(regmap, ACT8945A_APCH_CTRL, ctrl);
+ if (ret)
+ return ret;
+
+ ctrl = APCH_STATUS_CHGSTAT | APCH_STATUS_INSTAT |
+ APCH_STATUS_TEMPSTAT | APCH_STATUS_TIMRSTAT;
+ ret = regmap_write(regmap, ACT8945A_APCH_STATUS, ctrl);
+ if (ret)
+ return ret;
+
+ return 0;
+}
+
+static void act8945a_work(struct work_struct *work)
+{
+ struct act8945a_charger *charger =
+ container_of(work, struct act8945a_charger, work);
+
+ power_supply_changed(charger->psy);
+}
+
+static irqreturn_t act8945a_status_changed(int irq, void *dev_id)
+{
+ struct act8945a_charger *charger = dev_id;
+
+ if (charger->init_done)
+ schedule_work(&charger->work);
+
+ return IRQ_HANDLED;
+}
+
#define DEFAULT_TOTAL_TIME_OUT 3
#define DEFAULT_PRE_TIME_OUT 40
#define DEFAULT_INPUT_OVP_THRESHOLD 6600
@@ -283,6 +330,18 @@ static int act8945a_charger_config(struct device *dev,
if (tmp & APCH_CFG_SUSCHG)
value |= APCH_CFG_SUSCHG;
+ charger->irq_pin = of_get_named_gpio(np, "active-semi,irq_gpios", 0);
+ if (gpio_is_valid(charger->irq_pin)) {
+ if (!devm_gpio_request(dev, charger->irq_pin, "irq-pin")) {
+ ret = devm_request_irq(dev,
+ gpio_to_irq(charger->irq_pin),
+ act8945a_status_changed,
+ IRQF_TRIGGER_FALLING,
+ "irq-pin", charger);
+ if (ret)
+ dev_dbg(dev, "failed to request nIRQ pin IRQ\n");
+ }
+ }
chglev_pin = of_get_named_gpio_flags(np,
"active-semi,chglev-gpios", 0, &flags);
@@ -360,7 +419,6 @@ static int act8945a_charger_config(struct device *dev,
static int act8945a_charger_probe(struct platform_device *pdev)
{
struct act8945a_charger *charger;
- struct power_supply *psy;
struct power_supply_config psy_cfg = {};
int ret;
@@ -381,14 +439,22 @@ static int act8945a_charger_probe(struct platform_device *pdev)
psy_cfg.of_node = pdev->dev.parent->of_node;
psy_cfg.drv_data = charger;
- psy = devm_power_supply_register(&pdev->dev,
- &act8945a_charger_desc,
- &psy_cfg);
- if (IS_ERR(psy)) {
+ charger->psy = devm_power_supply_register(&pdev->dev,
+ &act8945a_charger_desc,
+ &psy_cfg);
+ if (IS_ERR(charger->psy)) {
dev_err(&pdev->dev, "failed to register power supply\n");
- return PTR_ERR(psy);
+ return PTR_ERR(charger->psy);
}
+ INIT_WORK(&charger->work, act8945a_work);
+
+ ret = act8945a_enable_interrupt(charger);
+ if (ret)
+ return -EIO;
+
+ charger->init_done = true;
+
return 0;
}
Add the charger status change interrupt support, it will report the power supply changed event. This interrupt is generated by one of the conditions as below: - the state machine jumps out of or into the EOC state - the CHGIN input voltage goes out of or into the valid range. - the battery temperature goes out of or into the valid range. - the PRECHARGE time-out occurs. - the total charge time-out occurs. Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com> --- Changes in v3: None Changes in v2: None drivers/power/act8945a_charger.c | 78 ++++++++++++++++++++++++++++++++++++---- 1 file changed, 72 insertions(+), 6 deletions(-)