@@ -162,14 +162,6 @@
compatible = "active-semi,act8945a";
reg = <0x5b>;
active-semi,vsel-high;
- active-semi,chglev-gpios = <&pioA 12 GPIO_ACTIVE_HIGH>;
- active-semi,lbo-gpios = <&pioA 72 GPIO_ACTIVE_LOW>;
- active-semi,irq_gpios = <&pioA 45 GPIO_ACTIVE_LOW>;
- active-semi,input-voltage-threshold-microvolt = <6600>;
- active-semi,precondition-timeout = <40>;
- active-semi,total-timeout = <3>;
- pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_charger_chglev &pinctrl_charger_lbo &pinctrl_charger_irq>;
status = "okay";
regulators {
@@ -222,6 +214,21 @@
regulator-always-on;
};
};
+
+ charger {
+ compatible = "active-semi,act8945a-charger";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_charger_chglev &pinctrl_charger_lbo &pinctrl_charger_irq>;
+ interrupt-parent = <&pioA>;
+ interrupts = <45 GPIO_ACTIVE_LOW>;
+
+ active-semi,chglev-gpios = <&pioA 12 GPIO_ACTIVE_HIGH>;
+ active-semi,lbo-gpios = <&pioA 72 GPIO_ACTIVE_LOW>;
+ active-semi,input-voltage-threshold-microvolt = <6600>;
+ active-semi,precondition-timeout = <40>;
+ active-semi,total-timeout = <3>;
+ status = "okay";
+ };
};
};
Add act8945a-charger as a sub-device node. Use the "interrupts" property, instead of the "active-semi,irq_gpios" to denote the act8945a chager's irq. Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com> --- Changes in v8: - Add 4 new patches: 1/11, 2/11, 9/11, and 11/11. Changes in v7: None Changes in v6: None Changes in v5: None Changes in v4: None Changes in v3: None Changes in v2: None arch/arm/boot/dts/at91-sama5d2_xplained.dts | 23 +++++++++++++++-------- 1 file changed, 15 insertions(+), 8 deletions(-)