@@ -301,3 +301,12 @@ config ARM_PXA2xx_CPUFREQ
This add the CPUFreq driver support for Intel PXA2xx SOCs.
If in doubt, say N.
+
+config ARM_QCOM_CPUFREQ_FW
+ tristate "QCOM CPUFreq FW driver"
+ help
+ Support for the CPUFreq FW driver.
+ The CPUfreq FW preset in some QCOM chipsets offloads the steps
+ necessary for changing the frequency of CPUs. The driver
+ implements the cpufreq driver interface for this firmware.
+ Say Y if you want to support CPUFreq FW.
@@ -85,6 +85,7 @@ obj-$(CONFIG_ARM_TEGRA124_CPUFREQ) += tegra124-cpufreq.o
obj-$(CONFIG_ARM_TEGRA186_CPUFREQ) += tegra186-cpufreq.o
obj-$(CONFIG_ARM_TI_CPUFREQ) += ti-cpufreq.o
obj-$(CONFIG_ARM_VEXPRESS_SPC_CPUFREQ) += vexpress-spc-cpufreq.o
+obj-$(CONFIG_ARM_QCOM_CPUFREQ_FW) += qcom-cpufreq-fw.o
##################################################################################
new file mode 100644
@@ -0,0 +1,319 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2018, The Linux Foundation. All rights reserved.
+ */
+
+#include <linux/cpufreq.h>
+#include <linux/init.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/of_address.h>
+#include <linux/of_platform.h>
+
+#define INIT_RATE 300000000UL
+#define XO_RATE 19200000UL
+#define LUT_MAX_ENTRIES 40U
+#define CORE_COUNT_VAL(val) ((val & GENMASK(18, 16)) >> 16)
+#define LUT_ROW_SIZE 32
+
+struct cpufreq_qcom {
+ struct cpufreq_frequency_table *table;
+ struct device *dev;
+ void __iomem *perf_base;
+ void __iomem *lut_base;
+ cpumask_t related_cpus;
+ unsigned int max_cores;
+};
+
+static struct cpufreq_qcom *qcom_freq_domain_map[NR_CPUS];
+
+static int
+qcom_cpufreq_fw_target_index(struct cpufreq_policy *policy, unsigned int index)
+{
+ struct cpufreq_qcom *c = policy->driver_data;
+
+ if (index >= LUT_MAX_ENTRIES) {
+ dev_err(c->dev,
+ "Passing an index (%u) that's greater than max (%d)\n",
+ index, LUT_MAX_ENTRIES - 1);
+ return -EINVAL;
+ }
+
+ writel_relaxed(index, c->perf_base);
+
+ /* Make sure the write goes through before proceeding */
+ mb();
+ return 0;
+}
+
+static unsigned int qcom_cpufreq_fw_get(unsigned int cpu)
+{
+ struct cpufreq_qcom *c;
+ unsigned int index;
+
+ c = qcom_freq_domain_map[cpu];
+ if (!c)
+ return -ENODEV;
+
+ index = readl_relaxed(c->perf_base);
+ index = min(index, LUT_MAX_ENTRIES - 1);
+
+ return c->table[index].frequency;
+}
+
+static int qcom_cpufreq_fw_cpu_init(struct cpufreq_policy *policy)
+{
+ struct cpufreq_qcom *c;
+ int ret;
+
+ c = qcom_freq_domain_map[policy->cpu];
+ if (!c) {
+ pr_err("No scaling support for CPU%d\n", policy->cpu);
+ return -ENODEV;
+ }
+
+ cpumask_copy(policy->cpus, &c->related_cpus);
+
+ policy->freq_table = c->table;
+ policy->driver_data = c;
+
+ return ret;
+}
+
+static struct freq_attr *qcom_cpufreq_fw_attr[] = {
+ &cpufreq_freq_attr_scaling_available_freqs,
+ &cpufreq_freq_attr_scaling_boost_freqs,
+ NULL
+};
+
+static struct cpufreq_driver cpufreq_qcom_fw_driver = {
+ .flags = CPUFREQ_STICKY | CPUFREQ_NEED_INITIAL_FREQ_CHECK |
+ CPUFREQ_HAVE_GOVERNOR_PER_POLICY,
+ .verify = cpufreq_generic_frequency_table_verify,
+ .target_index = qcom_cpufreq_fw_target_index,
+ .get = qcom_cpufreq_fw_get,
+ .init = qcom_cpufreq_fw_cpu_init,
+ .name = "qcom-cpufreq-fw",
+ .attr = qcom_cpufreq_fw_attr,
+ .boost_enabled = true,
+};
+
+static int qcom_read_lut(struct platform_device *pdev,
+ struct cpufreq_qcom *c)
+{
+ struct device *dev = &pdev->dev;
+ u32 data, src, lval, i, core_count, prev_cc = 0;
+
+ c->table = devm_kcalloc(dev, LUT_MAX_ENTRIES + 1,
+ sizeof(*c->table), GFP_KERNEL);
+ if (!c->table)
+ return -ENOMEM;
+
+ for (i = 0; i < LUT_MAX_ENTRIES; i++) {
+ data = readl_relaxed(c->lut_base + i * LUT_ROW_SIZE);
+ src = ((data & GENMASK(31, 30)) >> 30);
+ lval = (data & GENMASK(7, 0));
+ core_count = CORE_COUNT_VAL(data);
+
+ if (!src)
+ c->table[i].frequency = INIT_RATE / 1000;
+ else
+ c->table[i].frequency = XO_RATE * lval / 1000;
+
+ c->table[i].driver_data = c->table[i].frequency;
+
+ dev_dbg(dev, "index=%d freq=%d, core_count %d\n",
+ i, c->table[i].frequency, core_count);
+
+ if (core_count != c->max_cores)
+ c->table[i].frequency = CPUFREQ_ENTRY_INVALID;
+
+ /*
+ * Two of the same frequencies with the same core counts means
+ * end of table.
+ */
+ if (i > 0 && c->table[i - 1].driver_data ==
+ c->table[i].driver_data
+ && prev_cc == core_count) {
+ struct cpufreq_frequency_table *prev = &c->table[i - 1];
+
+ if (prev->frequency == CPUFREQ_ENTRY_INVALID) {
+ prev->flags = CPUFREQ_BOOST_FREQ;
+ prev->frequency = prev->driver_data;
+ }
+
+ break;
+ }
+ prev_cc = core_count;
+ }
+ c->table[i].frequency = CPUFREQ_TABLE_END;
+
+ return 0;
+}
+
+static int qcom_get_related_cpus(struct device_node *np, struct cpumask *m)
+{
+ struct device_node *dev_phandle;
+ struct device *cpu_dev;
+ int cpu, i = 0, ret = -ENOENT;
+
+ dev_phandle = of_parse_phandle(np, "qcom,cpulist", i++);
+ while (dev_phandle) {
+ for_each_possible_cpu(cpu) {
+ cpu_dev = get_cpu_device(cpu);
+ if (cpu_dev && cpu_dev->of_node == dev_phandle) {
+ cpumask_set_cpu(cpu, m);
+ ret = 0;
+ break;
+ }
+ }
+ dev_phandle = of_parse_phandle(np, "qcom,cpulist", i++);
+ }
+
+ return ret;
+}
+
+static int qcom_cpu_resources_init(struct platform_device *pdev,
+ struct device_node *np)
+{
+ struct cpufreq_qcom *c;
+ struct resource res;
+ struct device *dev = &pdev->dev;
+ void __iomem *en_base;
+ int cpu, index = 0, ret;
+
+ c = devm_kzalloc(dev, sizeof(*c), GFP_KERNEL);
+
+ index = of_property_match_string(np, "reg-names", "en_base");
+ if (index < 0)
+ return index;
+
+ if (of_address_to_resource(np, index, &res))
+ return -ENOMEM;
+
+ en_base = devm_ioremap(dev, res.start, resource_size(&res));
+ if (!en_base) {
+ dev_err(dev, "Unable to map %s en-base\n", np->name);
+ return -ENOMEM;
+ }
+
+ /* FW should be enabled state to proceed */
+ if (!(readl_relaxed(en_base) & 0x1)) {
+ dev_err(dev, "%s firmware not enabled\n", np->name);
+ return -ENODEV;
+ }
+
+ devm_iounmap(&pdev->dev, en_base);
+
+ index = of_property_match_string(np, "reg-names", "perf_base");
+ if (index < 0)
+ return index;
+
+ if (of_address_to_resource(np, index, &res))
+ return -ENOMEM;
+
+ c->perf_base = devm_ioremap(dev, res.start, resource_size(&res));
+ if (!c->perf_base) {
+ dev_err(dev, "Unable to map %s perf-base\n", np->name);
+ return -ENOMEM;
+ }
+
+ index = of_property_match_string(np, "reg-names", "lut_base");
+ if (index < 0)
+ return index;
+
+ if (of_address_to_resource(np, index, &res))
+ return -ENOMEM;
+
+ c->lut_base = devm_ioremap(dev, res.start, resource_size(&res));
+ if (!c->lut_base) {
+ dev_err(dev, "Unable to map %s lut-base\n", np->name);
+ return -ENOMEM;
+ }
+
+ ret = qcom_get_related_cpus(np, &c->related_cpus);
+ if (ret) {
+ dev_err(dev, "%s failed to get core phandles\n", np->name);
+ return ret;
+ }
+
+ c->max_cores = cpumask_weight(&c->related_cpus);
+
+ ret = qcom_read_lut(pdev, c);
+ if (ret) {
+ dev_err(dev, "%s failed to read LUT\n", np->name);
+ return ret;
+ }
+
+ for_each_cpu(cpu, &c->related_cpus)
+ qcom_freq_domain_map[cpu] = c;
+
+ return 0;
+}
+
+static int qcom_resources_init(struct platform_device *pdev)
+{
+ struct device_node *np;
+ int ret = -ENODEV;
+
+ for_each_available_child_of_node(pdev->dev.of_node, np) {
+ if (of_device_is_compatible(np, "cpufreq")) {
+ ret = qcom_cpu_resources_init(pdev, np);
+ if (ret)
+ return ret;
+ }
+ }
+
+ return ret;
+}
+
+static int qcom_cpufreq_fw_driver_probe(struct platform_device *pdev)
+{
+ int rc = 0;
+
+ /* Get the bases of cpufreq for domains */
+ rc = qcom_resources_init(pdev);
+ if (rc) {
+ dev_err(&pdev->dev, "CPUFreq resource init failed\n");
+ return rc;
+ }
+
+ rc = cpufreq_register_driver(&cpufreq_qcom_fw_driver);
+ if (rc) {
+ dev_err(&pdev->dev, "CPUFreq FW driver failed to register\n");
+ return rc;
+ }
+
+ dev_info(&pdev->dev, "QCOM CPUFreq FW driver inited\n");
+
+ return 0;
+}
+
+static const struct of_device_id match_table[] = {
+ { .compatible = "qcom,cpufreq-fw" },
+ {}
+};
+
+static struct platform_driver qcom_cpufreq_fw_driver = {
+ .probe = qcom_cpufreq_fw_driver_probe,
+ .driver = {
+ .name = "qcom-cpufreq-fw",
+ .of_match_table = match_table,
+ .owner = THIS_MODULE,
+ },
+};
+
+static int __init qcom_cpufreq_fw_init(void)
+{
+ return platform_driver_register(&qcom_cpufreq_fw_driver);
+}
+subsys_initcall(qcom_cpufreq_fw_init);
+
+static void __exit qcom_cpufreq_fw_exit(void)
+{
+ platform_driver_unregister(&qcom_cpufreq_fw_driver);
+}
+module_exit(qcom_cpufreq_fw_exit);
+
+MODULE_DESCRIPTION("QCOM CPU Frequency FW");
+MODULE_LICENSE("GPL v2");
The CPUfreq FW present in some QCOM chipsets offloads the steps necessary for changing the frequency of CPUs. The driver implements the cpufreq driver interface for this firmware. Signed-off-by: Taniya Das <tdas@codeaurora.org> --- drivers/cpufreq/Kconfig.arm | 9 ++ drivers/cpufreq/Makefile | 1 + drivers/cpufreq/qcom-cpufreq-fw.c | 319 ++++++++++++++++++++++++++++++++++++++ 3 files changed, 329 insertions(+) create mode 100644 drivers/cpufreq/qcom-cpufreq-fw.c -- Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc.is a member of the Code Aurora Forum, hosted by the Linux Foundation.