diff mbox series

[v2,14/17] thermal: ti-soc-thermal: enable+check sensor after its setup is finished

Message ID 1539791563-5959-15-git-send-email-b.zolnierkie@samsung.com (mailing list archive)
State Superseded, archived
Delegated to: Zhang Rui
Headers show
Series thermal: enable+check sensor after its setup is finished | expand

Commit Message

Bartlomiej Zolnierkiewicz Oct. 17, 2018, 3:52 p.m. UTC 
Enable sensor after setting sensor data and check sensor after
writing update interval.

Cc: Eduardo Valentin <edubezval@gmail.com>
Cc: Keerthy <j-keerthy@ti.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
 drivers/thermal/ti-soc-thermal/ti-thermal-common.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/drivers/thermal/ti-soc-thermal/ti-thermal-common.c b/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
index aa15719..4675d96 100644
--- a/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
+++ b/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
@@ -197,13 +197,15 @@  int ti_thermal_expose_sensor(struct ti_bandgap *bgp, int id,
 		return PTR_ERR(data->ti_thermal);
 	}
 
+	ti_bandgap_set_sensor_data(bgp, id, data);
+
 	thermal_zone_set_mode(data->ti_thermal, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check(data->ti_thermal);
 
-	ti_bandgap_set_sensor_data(bgp, id, data);
 	ti_bandgap_write_update_interval(bgp, data->sensor_id,
 					data->ti_thermal->polling_delay);
 
+	thermal_zone_device_check(data->ti_thermal);
+
 	return 0;
 }