diff mbox series

[v2,15/17] thermal: uniphier: enable+check sensor after its setup is finished

Message ID 1539791563-5959-16-git-send-email-b.zolnierkie@samsung.com (mailing list archive)
State Superseded, archived
Delegated to: Zhang Rui
Headers show
Series thermal: enable+check sensor after its setup is finished | expand

Commit Message

Bartlomiej Zolnierkiewicz Oct. 17, 2018, 3:52 p.m. UTC 
Enable sensor after checking trip points (unipher_tm_enable_sensor()
enables IRQ so we need to toggle sensor before calling it) and check
sensor after doing chipset specific enable sensor operation.

Cc: Masahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
 drivers/thermal/uniphier_thermal.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/thermal/uniphier_thermal.c b/drivers/thermal/uniphier_thermal.c
index ed3a920..9ccc1fc 100644
--- a/drivers/thermal/uniphier_thermal.c
+++ b/drivers/thermal/uniphier_thermal.c
@@ -307,9 +307,6 @@  static int uniphier_tm_probe(struct platform_device *pdev)
 		return PTR_ERR(tdev->tz_dev);
 	}
 
-	thermal_zone_set_mode(tdev->tz_dev, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check(tdev->tz_dev);
-
 	/* get trip points */
 	trips = of_thermal_get_trip_points(tdev->tz_dev);
 	ntrips = of_thermal_get_ntrips(tdev->tz_dev);
@@ -332,8 +329,12 @@  static int uniphier_tm_probe(struct platform_device *pdev)
 		return -EINVAL;
 	}
 
+	thermal_zone_set_mode(tdev->tz_dev, THERMAL_DEVICE_ENABLED);
+
 	uniphier_tm_enable_sensor(tdev);
 
+	thermal_zone_device_check(tdev->tz_dev);
+
 	return 0;
 }