diff mbox series

[v2,06/17] thermal: brcmstb: enable+check sensor after its setup is finished

Message ID 1539791563-5959-7-git-send-email-b.zolnierkie@samsung.com (mailing list archive)
State Superseded, archived
Delegated to: Zhang Rui
Headers show
Series thermal: enable+check sensor after its setup is finished | expand

Commit Message

Bartlomiej Zolnierkiewicz Oct. 17, 2018, 3:52 p.m. UTC 
Enable+check sensor after setting priv->thermal.

Cc: Markus Mayer <mmayer@broadcom.com>
Cc: bcm-kernel-feedback-list@broadcom.com
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
 drivers/thermal/broadcom/brcmstb_thermal.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/drivers/thermal/broadcom/brcmstb_thermal.c b/drivers/thermal/broadcom/brcmstb_thermal.c
index 3511ce6..5650a6a 100644
--- a/drivers/thermal/broadcom/brcmstb_thermal.c
+++ b/drivers/thermal/broadcom/brcmstb_thermal.c
@@ -336,11 +336,11 @@  static int brcmstb_thermal_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	priv->thermal = thermal;
+
 	thermal_zone_set_mode(thermal, THERMAL_DEVICE_ENABLED);
 	thermal_zone_device_check(thermal);
 
-	priv->thermal = thermal;
-
 	irq = platform_get_irq(pdev, 0);
 	if (irq < 0) {
 		dev_err(&pdev->dev, "could not get IRQ\n");